Industrial Filters Replacement Procedure (Reference tightening rotation angle: approx. 1/4 to 1/2 turn after tightening by hand) This makes the element e be pushed up as a whole, and the element seal will be installed to the case q sealing. The element e can also be pushed hard by hand to be surely installed before setting the case q. 2-4.
Dedicated grounding should be used. Grounding should be to a D-class ground. (Ground resistance of 100 or less.) 3. Grounding should be performed near the actuator to shorten the grounding distance. 4. The cross-sectional area of this wire shall be a minimum of 2 mm2. 5. Avoid common grounding with other devices.
This calculation can be easily made using the SMC Pneumatics CAD System.
When using the safety function, a safety function device must be connected and the wiring that is necessary to activate the safety function must be done to turn ON the servomotor power.
When using the safety function, a safety function device must be connected and the wiring that is necessary to activate the safety function must be done to turn ON the servomotor power.
Position where light turns ON Position to be secured Position to be secured It is recommended that gripping of a workpiece be performed close to the center of the finger stroke.
back pressure effects actuator operation due to simultaneous operation of manifold valves, etc., this effect can be eliminated by installing a plate between the manifold block and the valve from which back pressure is to be prevented.
Consumable parts 3-3-1 Replacement parts The replacement parts can be ordered as shown below. Table 4 20 25 32 40 Rod seal CM20Z-PS CM25Z-PS CM32Z-PS CM40Z-PS The rod seal is not delivered in sealed packaging for storage independently, so it must be used within 1 year.
When a speed controller is mounted, the cylinder installation area can be reduced significantly. The dust seal band can be removed by loosening two holding screws (on one side).
Replaceable Rod Seal CM2 CG1 Rod seal can be quickly replaced, greatly extending the cylinder life. (C85 20, 25).
The IODD file can be downloaded from the URL below.
Avoid applications in which two or more end lock cylinders are synchronized to move one workpiece, as one of the cylinder locks may not be able to release when required. 6. Use a speed controller with meter-out control. Lock cannot be released occasionally by meter-in control. 7. Be sure to operate completely to the cylinder stroke end on the side with the lock.
This calculation can be easily made using the SMC Pneumatics CAD System.
F F H H Note) Male thread effective length should be no more than 100 mm.
UX Edition C Safety Instructions Be sure to read the Handling Precautions for SMC Products (M-E03-3) and Operation Manual before use.
The most suitable piping position can be selected by choosing each 1 port from A, B, C and combining them.
(Exhaust locking) High precision Holding power can be adjusted freely. High precision Holding power can be adjusted freely. Works on the safety side. Characteristics Maximum piston speed: 500 mm/s It can be used at 50 to 500 mm/s provided that it is within the allowable kinetic energy range. Air cushion is standard.
The most suitable piping position can be selected by choosing each 1 port from A, B, C and combining them.
(Exhaust locking) High precision Holding power can be adjusted freely. High precision Holding power can be adjusted freely. Works on the safety side. Characteristics Maximum piston speed: 500 mm/s It can be used at 50 to 500 mm/s provided that it is within the allowable kinetic energy range. Air cushion is standard.