Series VC, Series VCL, Direct Operated 2 Port Solenoid Valve for Oil D -DIN connector DL -DIN connector with light DO-For DIN connector (without connector) Orifice and port size combinations T -With conduit terminal TL-With conduit terminal/light Class Orifice diameter Port size 2 3 4 5 7 10 1/8 (6A) 2 1/4 (8A) 1/4 (8A) 3 3/8 (10A) 1/2 (15A) Connector 1/4 (8A) 3/8 (10A) 4 All class B coils are equipped with surge voltage suppressor.
Do not disassemble, except for when replacing any of the replaceable parts, as this may cause the performance to deteriorate. In the case of a rubber cover, the lock can be released easily by hitting the round tab on the cover with a plastic hammer. 3.
Do not apply external force to the coil section. When tightening is performed, apply a wrench or other tool to the outside of the piping connection parts. 2. Do not warm the coil assembly with a heat insulator, etc. Use tape, heaters, etc., for freeze prevention on the piping and body only. They can cause the coil to burn out. 3.
Caution D: With connector DO: Without connector Y: With connector YO: Without connector When using the surge voltage suppressor type, residual voltage will remain. For details, refer to the Web Catalog (VP300/500 Low wattage specification). * Refer to the Web Catalog (VP300/500 Low wattage specification) for details of the DIN terminal. Assembly Example Products do not come assembled.
The VQ20/30 series is a pilot operated, two port multi-media valve. The series is compact and lightweight with a large flow capacity. The VQ20/30's long life, high speed coil (up to 20 million cycles at 100cps for pneumatic use) along with its all plastic construction, make it an excellent choice for those who want high performance at a lower cost.Manifold for VQ20/30 pilot operated valve
(Do not use a tool.) For setting the initial pumped amount, turn it counterclockwise. 2. Opening the valve (valve S) for initial pumping When air pressure is applied to the pilot port 1(P) and the initial pumping solenoid valve is energized, the S valve will release from the S valve seal assembly and open to the adjusted angle. 3.
Do not service machinery/equipment or attempt to remove component until safety is confirmed. 1) Inspection and maintenance of machinery/equipment should only be performed after confirmation of safe locked-out control positions. 4-17-4
M5 x 10 DIN913-45H VP4 12 2 8 VZS G 1/4 DIN/ISO228/1 M5 Drive flange face VFS VS4 19.5 5.5 Solenoid valve flange face O-ring 16 x 2 VQ7 1.5 3 EVS VFN The solenoid valve can be attached with 2 mounting bolts.
Surge voltage suppressor Grommet L plug connector M plug connector DIN terminal Nil Z None With light/surge voltage suppressor With surge voltage suppressor G: Lead wire length 300 mm L: With lead wire (Length 300 mm) M: With lead wire (Length 300 mm) MN: Without lead wire D: With connector S Not available for GZ, HZ and DOZ LN: Without lead wire LO: Without connector MO: Without connector DO
How to Order Do not replace heavy duty scrapers. XC4 Since heavy duty scrapers are press-fit, do not replace the cover only, but rather the entire rod cover assembly. The CM2 series cannot replace either heavy duty scraper or rod seal. (It goes for replacing retainer assembly for the CS1 series.) Replace the CNA2 series with the lock unit.
Do not apply force when transferring, mounting and dropping the regulator with a pressure gauge. This may cause misalignment of the pressure gauge pointer. AP100 Precautions for IR2120, IR3120 (air operated type) only Caution 1.
Please make sure that operating conditions do not cause problems since the use of FEP tubing under chemical environment is unsecured.
Do not operate the product outside of the specifications.
Note 5) Do not use the V-band type for gases. FGES/FGEL type (V-band type) FGET type (Bolt tightening type) Suitable for medium flow rate, low pressure filtration. Element replacement is easy with the V-band type.
Do nol apply voltage potential In excess of 250V. (Note) Indicator oanel Denatured PPO Swagelok* IS a registered trademark 0 1 Crawford Fitting Co. VCRlI lS a registered trademark. of Cajon Co.
Piping: Common SUP/Individual EXH, Stations: 16 Stations, Bracket: None, Thread: NPTF, CE Approval: -
Piping: Common SUP/Common EXH, Stations: 16 Stations, Bracket: -
Piping: Common SUP/Individual EXH, Stations: 16 Stations, Bracket: -
Manifold Type: Body Ported, Bar Manifold, Individual Wiring, Valve Stations: 16 Stations, A, B Port: NPTF, Q: -
Series: VQ30, Stations: 16 Stations, Option: DIN Rail Mounting, Thread: NPTF3/8