Part Number Description: 2-275 BUNA-50 ORING Product Line: C Product Line Description: CONNECTORS Family Code: 790 Family Description: CONN-SPECIAL NO DIST.DISCOUNT Class Code: 2X Part Code: 1 Click here to report information errorImage shown may not match exact part number
This is a legacy product. Please contact us for the latest version.sales@ocaire.com
This is a legacy product. Please contact us for the latest version.sales@ocaire.com
This is a legacy product. Please contact us for the latest version.sales@ocaire.com
This is a legacy product. Please contact us for the latest version.sales@ocaire.com
Industrial Process Trainer- basic config, TRAINING EQUIPMENT SAI-, Q14, 45.40000 lb
This is a legacy product. Please contact us for the latest version.sales@ocaire.com
This is a legacy product. Please contact us for the latest version.sales@ocaire.com, CYL, TIE ROD, DUAL STK, ACTUATOR, CS1/CS2 TIE ROD CYLINDER, TC, 125MM CS1/CS2 OTHERS (COMBO), 48.72215 lb
IPT BASE W/ SENS-VENTURI-ORIPLT, TRAINING EQUIPMENT SAI-, Q14, 43.50000 lb
US-IPT200 INST & PROCESS CONT W/ AO, TRAINING EQUIPMENT, H25, 340 lb
TRAINING EQUIPMENT SAI-. Process Control Trainer w/ AB Comp Logic. 75.00000 lb. Q14.
This is a legacy product. Please contact us for the latest version.sales@ocaire.com
IPT200 W/A,B,D & I OPTIONS, TRAINING EQUIPMENT SAI-, Q14, 44.45000 lb
Inst and Process Control Trainer-NO PLC/, TRAINING EQUIPMENT SAI-, Q14, 56.70000 lb
This is a legacy product. Please contact us for the latest version.sales@ocaire.com, CYL, TIE ROD, NON-LUBE,AUTO-SW, ACTUATOR, CA1/CA2 TIE-ROD CYLINDER, SE, 100MM CA1 DBL-ACT AUTO-SW, .00000 lb
IPT200 W/A,B,D,F & I OPTIONS, TRAINING EQUIPMENT SAI-, Q14, 44.50000 lb
IPT200 PROC CNTRL W/WATER TEMP ADD ON, TRAINING EQUIPMENT SAI-, Q14, 36.70000 lb
IPT200 W/A,B,D,F,I, & J OPTIONS, TRAINING EQUIPMENT SAI-, Q14, 44.90000 lb
Check the pressure and air supply.
The main valve may not be switching due to insufficient supply air pressure or flow (piping is over-restricted, etc.), and the air from the supply port may be escaping from the exhaust port.
At pressures higher than 0.2 MPa, the combined sonic conductance (d m3/ (s•bar)) of the inlet piping and equipment should be equal to or greater than the values
The needle valve on the bottom of the valve may be fully closed.
In the fully closed state, no air is supplied to the outlet side. Adjust the switching timing of the valve by opening the needle valve a little.
Since it is dangerous if they pop out suddenly upon startup, the products are shipped with the needle valves in a fully closed state.