Series VQ Metal Seal/Rubber Seal Body Ported No malfunction occurred in a one-sweep test between 8.3 and 2000Hz. Test was performed at both energized and de-energized states to the axis and right angle directions of the main valve and armature. (Value in the initial stage.) Vibration resistance: Values in case of high pressure style (1.5W). Values in case of low wattage (0.5W) .
the desired direction (4 directions in 90 increments).
conditions that exceed the lines in the graphs above, be sure to use a regenerative absorption unit.
Rt I lA-t 2 N12t 2931 29 | PRll 25 /225 .Jd 1.63 2.00 1.7 5 l.l3 #t0 nsnsaoo$ FPill5oo !oi" All dimensions in incrres. SQUARE FI.ANGE (SR LOCK / srot ffi l r g (lloloq llo. P! llonber l|odol (n.fl IC TH SA SB loll tre Wl. (ot.) sf?rr-t2 M483010056 9M2000 5e es .41 .62 3.50 2.75 1r 20 Ali drmensions in inches. -i FFH FooT MoUNT XIT (Fil) Pt\4120.
silencer, Direct exhaust L5 Note 1) In case of two or more options, enter them in alphabetical order.
Finally, the cool dehumidified air is heated in the reheater by hot inlet air and discharged in a dry state.
order, starting from station No. 1 as shown in the drawing.
Indicate the valves to be mounted below the manifold part number, in order starting from station 1 as shown in the drawing. When a layout becomes complicated, please indicate it on a manifold specification sheet.
Indicate the valves to be mounted below the manifold part number, in order starting from station 1 as shown in the drawing.
conditions that exceed the lines in the graphs above, be sure to use a regenerative absorption unit.
OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN OUT IN 804 550 1256 862 1963 1347 3116 2126 5024 3434 7850 5388 1256 1002 1963 1569 3116 2500 5024 4035 7850 6260 32 18 40 22.4 B-series rod 50 28 63 35.5 80 45 100 56 40 18 50 22.4 C-series rod 63 28 80 35.5 100 45 Minimum Strokes for Auto Switch Mounting Unit: mm Mounting brackets other than center trunnion Center trunnion
Do not operate multiple cylinders in synchronization. Avoid applications in which two or more cylinders with end lock are synchronized to move one workpiece, as one of the cylinder locks may not be able to release when required. 6. Use a speed controller with meter-out control. Lock cannot be released occasionally by meter-in control. 7.
Decide when to replace the pads, referring to the signs of deterioration, such as changes in the appearance due to wear, reduction in the vacuum pressure or delay in the transport cycle time.
the specification sheet in the case of CM and LM.
Cylinder side pressure (P2) IN IN Specifications Max. operating pressure Min. operatingpressure Ambient and fluid temp.
case of CP port plug is inserted in all 2(A) port.
Do not use in the atmosphere and environment over the rated specifications. 2. Do not use in the environment of corrosive gas or liquid splash. 3. Do not use in an environment where oil and chemicals are used. Maintenance Caution 1. Perform periodic inspection. 249