10 When an impact, such as water hammer etc., caused by the rapid pressure fluctuation is applied, the solenoid valve may be damaged. Give an attention to it.
Use caution, as operating above the prescribed values may lead to dropping of the load. The cushion effect (smooth start-up, soft stop) exists only before the stroke end in the stroke ranges indicated in the table below. The cushion effect (smooth start-up, soft stop) cannot be obtained in an intermediate stop or return from an intermediate stop using an external stopper, etc.
This product cannot be used as a check regulator by installing it between solenoid valve and actuator. 3. Port with a pressure gauge or a plug can be used as an OUT port.
For an exterior dimension diagram to identify the mounting support types, refer to p.3.1-21 to 3.1-24 as the dimensions are identical to those of standard.
to operate it as an ordinary double acting cylinder at an even lower operating speeds, use a low speed cylinder (see "Made to Order" on Page SPECIALS-1 ).
L1 to L5 dimensions are the same as 10P type.
Pad Caution Guide for drop prevention Provide an auxiliary device (example: a guide for preventing the workpieces from dropping) as necessary. Mounting Position As a rule, the unit must be installed horizontally.
Dimensions are the same as standard type.
How to Order Type 46 (5 port/Base mounted) 10 SS5YJ3 46 05 M5 Type 46 Type S46 ( ) Single solenoid pilot valve is on same side as the A, B port. Clean series CE-compliant M5 x 0.8 R1, R2 port Stations Nil 02 2 stations Valve mounting direction P port thread type Q CE-compliant : : Single solenoid pilot valve is on opposite side as the A, B port.
Note 3) When n is an odd number, an even number that is one larger than this odd number is used for the calculation.
For an exterior dimension diagram to identify the mounting support types, refer to p.3.1-21 to 3.1-24 as the dimensions are identical to those of standard.
An over current error (Er1, Er2) is displayed. (1) Check that there is no noise interference such as static electricity, and check for noise sources.
This function prevents detection of such temporary drops in the supply pressure as an error by changing the delay time setting.
Note) When placing an order for body ported solenoid valve as a single unit, mounting bolt for manifold and gasket are not attached. Order them separately, if necessary.
For male thread When in the locked state, do not apply a load accompanied by an impact shock, strong vibration, turning force, etc. 30 Note that an external action, such as an impacting load, strong vibration, or turning force, may damage the lock unit or reduce its life.
Panel mount adapter ZS-46-B Panel mount adapter + Front protective cover ZS-46-D Lead wire with connector ZS-46-3L 3 cores, 2 m Front protective cover ZS-27-01 R1/8 piping adapter ZS-46-N1 NPT1/8 piping adapter ZS-46-N2 One-touch fitting 4 mm straight ZS-46-C4H One-touch fitting 6 mm straight ZS-46-C6H One-touch fitting 1/4 inch straight ZS-46-N7H One-touch fitting 4 mm elbow ZS-46-C4L One-touch
This allows reading and monitoring the contact signal from an external switch. When inputting an external switch signal to the contact input, select External Switch (external switch signal) for the type of contact input signal. (Refer to 2.3.1 Setting of contact input signal type and form) If an input from an external switch is detected, it can be generated as an alarm.
Meaning When Parameter Classification Enabled Uses the absolute encoder as an absolute encoder. n.0 [Factory setting] Pn002 After restart Setup n.1 Uses the absolute encoder as an incremental encoder.