Air Gripper for Collaborative Robots

JMHZ2-16D-X7400B-DTP-(N/P) . 12 3-5-2. JMHZ2-16D-X7400B-HC10DT-(N/P) . 13 3-5-3. JMHZ2-16D-X7400B-HC10-(N/P) . 14 3-6. Connector and pin layout . 15 3-6-1. JMHZ2-16D-X7400B-DTP-(N/P) . 15 3-6-2. JMHZ2-16D-X7400B-(HC10DT/HC10)-(N/P) . 16 3-7. Center of gravity . 17 4Product Specifications . 18 4-1. Air gripper . 18 4-2. 3-port solenoid valve . 19 4-3.

Multi-channel Digital Sensor Monitor

Refer to the table for each pressure specification (page 80) Display/set pressure range Display/min. setting unit Power supply voltage 12 to 24 VDC (10%), and ripple (p-p) 10% at max. Electric spec.

Rotary Actuator NCRA1 Series Single Rack and Pinion

P 2 Specifications(NCRAl).P 3 Torque DiagramMeight CharvRotation Range. P 4 Shaft Load/Operational Instructions (NCRAI ) . P 5 Construction/ParlsList.-.P 6 Single Rod End/Dimensaons . .P 7 Double Rod End/Dimensions.-...P 8 Series:NCRAI How To Order Adluatable cuahlon C Both end cushion Not available on NCRA1BW30 Fotation .

Fieldbus system EtherNet/IP TM compatible SI unit

Upper and lower setting limit of user setting Analogue output Settable range during measurement range communication error or idling (Range) (Lwr_Lmt) (Upr_Lmt) (Fault_MA) (Idle_MA) 0..10 V 0.00 to +10.45 V +0.05 to +10.50 V 0.00 to +10.50 V 0..5 V 0.00 to + 5.22 V +0.03 to +5.25 V 0.00 to +5.25 V 1..5 V +0.75 to +5.22 V +0.78 to +5.25 V +0.75 to +5.25 V 0..20 mA 0.00 to +20.90 mA +0.10 to

Fieldbus system Ethernet POWERLINK compatible SI unit

V 5 to 1050 0..5 V 0.00 to +5.22 V 0 to 522 +0.03 to +5.25 V 3 to 525 1..5 V +0.75 to +5.22 V 75 to 522 +0.78 to +5.25 V 78 to 525 0..20 mA 0.00 to +20.90 mA 0 to 2090 +0.10 to +21.00 mA 10 to 2100 4..20 mA +3.00 to +20.90 mA 300 to 2090 +3.10 to +21.00 mA 310 to 2100 41 EX## OMS1015-A 7.

MR Unit (Regulator with Mist Separator) AMR3000 to 6000 Series

Compact Pressure Switch Specifications (For further information, refer to Best Pneumatics No. 8) IS10-01 Model 0.1 to 0.4 MPa Set pressure range (OFF) 0.08 MPa Hysteresis 1a Contact point construction 2 VA AC, 2 W DC Max. contact point capacity 12 V 48 V 100 V Voltage (AC, DC) 24 V 50 mA 40 mA 20 mA Max. current 50 mA Symbol 2 1 AMR4000 AMR3000 L AMR5100 686 Regulator with Mist Separator

HRX-OM-S004

HRX-OM-S004-N Operation Manual InstallationOperation Original Instructions Thermo chiller HRS100-A-20HRS150-A-20HRS100-A-40HRS150-A-40HRS100-A-46HRS150-A-46HRS100-W-20HRS150-W-20HRS100-W-40HRS150-W-40HRS100-W-46HRS150-W-46Keep this manual available whenever necessary 2023 SMC CORPORATION All Rights Reserved To the users Thank you for purchasing SMCs Thermo chiller (hereinafter referred to

CJP

Applicable bore (mm) A D L MM N R W B C H d Applicable bore (mm) Part no.

CJP

Applicable bore (mm) A D L MM N R W B C H d Applicable bore (mm) Part no.

VZ5000

Compact size (Width: 18 mm) Low power consumption: 1.8 W DC Fluid Air 0.15 to 0.7 0.1 to 0.7 0.15 to 0.7 10 to 50C (No freezing.

IC

0 q CONTROLLER PRESSURE OUT w Position Detection Switch Flow Sensor Pressure Control Pressure Sensor e w r RUN 4 3 2 1 CH kPa 4 3 2 1 SW t e y D-IN RUN UP SET P-ON DOWN STOP READ r u i o t y u i o !

Angle Seat Valve /

V Ps + 0.1 293 S = 12.1 log10 () (6) t P + 0.1 T S : Effective area [mm2] V : Air tank capacity [dm3] t : Discharging time [s] Ps : Pressure inside air tank before discharging [MPa] P : Residual pressure inside air tank after discharging [MPa] T : Temperature inside air tank before discharging [K] Power supply Pressure switch Thermometer Pressure control equipment Control circuit Solenoid

Digital Pressure Switch

Connector pin numbers -18No.PS-OMS0007-H Internal circuit and wiring examples Z/ISE20(F)---Output specification -N NPN open collector 1 output Max. 28 V, 80 mA Residual voltage: 1 V or less -P PNP open collector 1 output Max. 80 mA Residual voltage: 1 V or less -19No.PS-OMS0007-H Outline of Settings [Measurement mode] Power is supplied.

Servo Motor Controller (24 VDC)

Cable color Tarminal no. 1 1.5m U 1 Red 1 V 2 White 2 3 3m W 3 Black 3 5 5m Shield signal Tarminal no.

Series 10-, 21- AF-A Air Filter

Fittings & Tubing Air Cylinders Rotary Actuators Bracket (Option) Bracket (Option) R R V Q V Q IN OUT B C IN OUT Clearance for maintenance G B C 2 x P (Port size) 2 x P (Port size) Hexagon width across flats 14 1/8 Drain Hexagon width across flats 17 1/4 E A Clearance for maintenance G Drain A AF50/60-A 1021J D M U S N T Bracket (Option) R V Q C B IN OUT 2 x P (Port size) Hexagon width across

IDX-OM-W019

IDX-OM-W019-C PRODUCT NAME Refrigerated Air Dryer MODEL / Series IDFB3E-11 -A,S IDFB4E-11 -A,R,T,S,V IDFB6E-11 -A,K,R,T,S,V IDFB8E-11 -A,K,R,T,S,V IDFB11E-11 -A,K,R,T,S,V IDFB15E-11 -K,R,T,S,V This manual is intended to explain the installation and operation of the product.

8

In the case of Fig. (3), ripple 10% means V' V" V'/V x 100 = 10% When no pulsation has occurred, ripple is 0%. V ZSE ISE Vacuum breaking pressure Positive pressure added for releasing the work or quickly returning to atmospheric pressure after breaking the vacuum condition. V' V" PSE V Vibration resistance The amount of vibration a device can withstand without damage.

JXCx-OMT0062

(unit mm): When the current position is within W-AREA1 and W-AREA2, the WAREA output turns ON. When W-Area 1 < W-Area2, the Parameter ALM of alarm occurs.

Rotary Cylinder Series MRQ

The amount of air requirement of rotary actuator = 0.06 x V x (P/0.1)/t L /min(ANR) V : Inner volume = cm3 P : Absolute pressure = {Operating pressure (MPa) + 0.1} t : Operating time = s Calculate the required air volume separately for the linear motion part and the rotary motion part.

Space Saving Vacuum Ejector Series ZQ [Option] Note) CE compliant: For DC only.

KJS04-M5 4 (Straight) Single unit KJS06-M5 6 (Straight) KJL04-M5 4 (Elbow) Note 9) For filter only (Without vacuum pressure switch) When neither V port fitting nor P port fitting are needed, enter nothing or 00 in the dotted line above How to Order. 2