SMC Electronic Switch Series Variations ) 2% F.S. or less (Total) (0 to 50C) 3% F.S. or less (0 to 50C) Total of controller and sensor Total of controller and sensor 0.5% F.S. or less (Total) Hysteresis mode: Variable Window comparator mode: Fixed (3 digits: ISE5B/6B) (2 digits: ZSE5B/6B) Digit is min. calibration unit.
Metal seal Rubber seal Single 0.15MPa 0.1MPa 2 position double (double solenoid) Valve specifications Solenoid specifications Double (latching) 0.18MPa 0.18MPa (A) 4 (B) 2 (A) 4 (B) 2 Minimum operating pressure Double (double solenoid) 0.1MPa 0.1MPa 3 position 0.2MPa 0.1MPa 1 (P) 5 (R1) 3 (R2) 1 (P) 5 (R1) 3 (R2) Metal seal Rubber seal 4 position 0.15MPa 3 position closed center 10 to 50C
style and/or special voltage, consult SMC. 1.12-34 VQZ1000/2000/3000 Base Mounted Standard Specifications Metal seal Seal Rubber seal Air, lnert gas Fluid Air, lnert gas 0.7MPa (High pressure type: 1.0MPa) Max. operationg pressure 0.15MPa Single Double 2 position Min. operating pressure 0.1MPa only for VQZ3000, 3 position 0.15MPa Valve specifications 0.1MPa 3 position 0.2MPa (1) (1) 10 to 50C
(No freezing, heat cycle not applied) 0 to 50C (No freezing, heat cycle not applied) 1 to 10 Hz FLUID IN Air operated 0.2 Note 3) 0.18 kg 0.11 kg FLUID OUT port upside General environment 100 mPas 24 VDC 0.35 W Each of the values above are for normal temperatures and clear water.
Water (1 to 50C), Air, Heated water (80C) Note 3), Low vacuum (133 Paabs) Quick fastener type Fluid Air, Water (1 to 40C) Note 5), Low vacuum (133 Paabs) One-touch fitting type Note 4) Withstand pressure 1.0 MPa Valve specifications Coil specifications 10 to 50C Ambient temperature 1 to 50C (No freezing) Fluid temperature Ambient humidity RH85% Environment Location without corrosive or explosive
Max. load current Protection Built-in short circuit protection Current consumption 50 mA or less (inside a unit) Enclosure IP10 10 to 50C Operating temperature range Environmental resistance Operating humidity range 35 to 85%RH (with no condensation) EX Withstand voltage 500 VAC for 1 min. between external terminals and FG 10 M or more (500 VDC) between external terminals and FG Insulation
Flow characteristics: C Max. operating frequency 0.8 MPa 0.15 MPa 5 to 50C 0.60 dm3/(sbar) 180 c.p.m SUP side pressure (P1) VVQ1000-FPG-02 1 set VQ1000-FPG-C6M5-D 2 pcs.
Fluid temperature 0 (0.1 Pa.abs) 0 to +50C Ambient temperature Note 1) Flow rate (l/min) (at max. operating pressure differential) AP100 0 to 100 0 to 75 Action N.C.
min 0.35 to 4.5 L/min 1.7 to 17.0 L/min 7 to 110 L/min 3.5 to 45 L/min 0.35 to 4.5 L/min 2 to 16 L/min 10 to 100 L/min 5 to 40 L/min 0.5 to 4 L/min 0.1 L/min 1 L/min 0.5 L/min 0.05 L/min 0.1 L/pulse 1 L/pulse 0.5 L/pulse 0.05 L/pulse Accumulated pulse flow rate exchange value (Pulse width: 50 ms) Operating fluid temperature Accuracy Repeatability Temperature characteristics Note 1) 0 to 50C
Operating temperature range 41 to 122F (5 to 50C) Operating humidity range [%RH] 90 or less (No condensation) Weight [g] 350 (Except cable) Note) CE-compliance The EMC compliance of the teaching box was tested with the LECP6 series step motor controller (servo/24 VDC) and an applicable actuator.
Note 2) 5 to 50C when the digital pressure switch will be used.
(at 25C of ambient temperature range between 5 and 50C) Temperature characteristics Oil-resistant cabtire cord Cross section: 0.15 mm2 (AWG26), 5 cores, Conductor O.D.: 1.0 mm Lead wires Note 1) If the applied voltage fluctuates around the set-value, the hysteresis must be set to a value more than the fluctuating width, otherwise chattering will occur.
Cylinder side pressure (P2) B B B B B + + + A NI NI O T U Specifications Maximum operating pressure Minimum operating pressure Ambient and fluid temperature Flow characteristics: C Max. operating frequency SJ O T U 0.8 MPa 0.15 MPa 5 to 50C 0.60 dm3/(sbar) 180 c.p.m SUP side pressure (P1) SY To CYL port Note) Based on JIS B 8375-1981 (Supply pressure: 0.5 MPa) SV Dimensions SYJ 21.5 (5) 18
Connector gasket Specifications Max. operating pressure 1.0 MPa Min. operating pressure 0.1 MPa Ambient and fluid temperatures 10 to 50C D-sub, Flat Ribbon SY3000 0.3 dm3/(sbar) SY5000 0.7 dm3/(sbar) SY7000 1.1 dm3/(sbar) Max. operating frequency 3 Hz Flow rate characteristics: C EX510 Manifold Exploded View Fitting, Plug Part Nos.
OUT1: Orange Digital filter*4 0, 10, 50, 100, 500, 1000, 5000 ms Enclosure IP40 Withstand voltage 1000 VAC for 1 minute between terminals and housing Insulation resistance 50 M or more (500 VDC measured via megohmmeter) between terminals and housing Environment Operating temperature range Operating: 5 to 50C, Stored: 10 to 60C (No condensation or freezing) Operating humidity range Operating
OUT2: Lights up when ON) Hysteresis mode Window comparator mode Hysteresis Note 4) Response time Output short circuit protection Display Display accuracy Indication light Analog output Auto shift input Note 2) Output voltage: 1 to 5V 5% F.S. or less Output voltage: 1 to 5V 2.5% F.S. or less Note 3) No-voltage input (solid state switch or reed switch), input 5ms or more IP65 Operating: 0 to 50C
(with no freezing and condensation) Fluid temperature 0 to 50C (with no freezing and condensation) Operating temperature range 10 to 60C (with no freezing and condensation) Stored temperature range Operating humidity range 35 to 85% R.H.
Operating temperature range 41 to 122F (5 to 50C) Operating humidity range [%RH] 90 or less (No condensation) Weight [g] 350 (Except cable) Note) CE-compliance The EMC compliance of the teaching box was tested with the LECP6 series step motor controller (servo/24 VDC) and an applicable actuator.
Operating temperature range 0 to 50C (with no freezing and condensation) Environmental resistance Operating humidity range Operating, Storage: 35 to 85% R.H.