IDX-OM-W094

3) 10 oC 382 509 763 1,018 MPa 0.7 oC 35 oC 25 () AC230V(50Hz) 10% 4 7-2 5) W 820 1,300 1,950 2,220 5) A 4.9 7.2 12.0 13.0 (30mA) 6) A 10 15 20 30 R410A (HFC) GWP2,088 7) g 39010 53010 63010 78010 :0.1MPa) mm 12 R1 R1 1/2 R2 kg 49 68 95 110 :1 :2 1 2ANR[2065%] 3[3275%] 4 5 6R 30mA 7IPCC4 AR4 R410A GWP2090 8L V1.6MPa IDFA60/70/80/90 Series 7-1 IDX-OM-W094 oC 525 30 35 40 45

SI unit for EtherNet/IP TM

Review the setting of PLC. -26No.EX-OMK0004-B Specifications Specifications General specification Item Specification Operating ambient temp. 5 to 45 oC Operating ambient humidity 35 to 85%RH (No dew condensation) Storage ambient temp. -20 to +60 oC Withstand voltage 500 VAC for 1 min.

SMC Wireless System EtherNet/IP ® compatible

(Including insulator) 1.55 mm Min. bending radius (Fixed) 19.5 mm -106No.EX-OMU0028-D Cable with M12 RJ-45 connector (Plug/RJ-45 connector) Plug connector Plug connector pin arrangement pin arrangement D-coded Item Specifications Cable O.D. 6.4 mm Nominal cross section 0.14 mm2/AWG26 Wire diameter 0.98 mm Min. bending radius (Fixed) 26 mm -107No.EX-OMU0028-D Cable with connector (Plug) Plug

5 Port Solenoid Valve

A side: Orange(Right) B side: Green(Left) Solenoid A Solenoid B Fixed DIN rail manifold Light/surge Voltage Suppressor Fixed "45", "45" DIN rail manifold to the setting side with screws, fix points as follows:2 to 5 stations: 2 points 6 to 10 stations : 3points 11 to 15 stations: 4 points 16 to 20 stations:5 points If fixed at lesser points than specified and use it, there could be a warp

SI unit for AS-Interface

N_m L 0 1 2 3 4 5 6 7 8 L1 45 55.5 66 76.5 87 97.5 108 118.5 129 L2 89.8 110.8 131.8 152.8 173.8 194.8 215.8 236.8 257.8 (mm) Wiring (for power supply, communication, input and output) and piping are carried out on one side only.

Compact Vacuum Unit Ejector/ Vacuum Pump System

Insert the V port assembly into the ejector/vacuum pump system (Fig. to the right), press it slightly and turn it for approximately 45 degrees in the clockwise direction until it stops. (See Fig. to the right) (Mount the V port assembly in the direction specified in the figure.

SMC Wireless System PROFINET compatible

(Including insulator) 1.55 mm Min. bending radius (Fixed) 19.5 mm -117No.EX-OMW0006-D Cable with M12 RJ-45 connector (Plug/RJ-45 connector) Plug connector Plug connector pin arrangement pin arrangement D-coded Item Specifications Cable O.D. 6.4 mm Nominal cross section 0.14 mm2/AWG26 Wire diameter 0.98 mm Min. bending radius (Fixed) 26 mm -118No.EX-OMW0006-D Cable with connector (Plug) Plug

Vacuum regulator

/163/8 SET side tubing O.D 1/45/16 Standard connections 135g(IRV10-C08) 250g(IRV20-C10) Weight (No accessories) Single sided connections 125g(IRV10A-C08) 250g(IRV20A-C10) Note1This varies with pressure on vacuum pump side.

Multi-channel Digital Sensor Monitor

13 Wiring 15 Pressure Setting 18 Outline of Settings 19 Initial Setting 21 3 Step Setting Mode 25 Simple Setting Mode 27 Function Selection Mode 29 Function selection mode 29 Default setting 29 F 0 Differential pressure check mode, pressure range, display unit 31 F 1 Setting of OUT1 37 F 2 Setting of OUT2 40 F 3 Digital filter setting 42 F 4 Auto-preset function 43 F 5 Auto-shift setting 45

XLF Series

Vibration resistance allows for normal operation of up to 30 m/s2 (45 to 250Hz), but continuous vibration may cause a decline in durability. Arrange piping to avoid excessive vibration or impacts. High temperature type (temperature specification / H0 H4 H5) 1. In models with a heater (thermistor), take care not to damage the insulation components of the lead wires and connector section.

High Vacuum L Type Valve

Vibration resistance allows for normal operation of up to 30m/s2 (45 to 250Hz). Be advised that continuous vibration may cause a decline in durability. Arrange piping to avoid excessive vibration or impacts. 5 XL-OMV0016 Models with solenoid valve 1. When mounting the fitting to the pilot port, mount it so that the solenoid valve and plate are secured at the same time.

Mist Separator

drain Max. air flow capacity Note 1) 1,100 L/min(ANR) 200 L/min(ANR) 450 L/min(ANR) Filtration rating 0.3 m (99.9% filtered particle size) Max. 1.0 mg/m30.8 ppm Outlet side oil mist concentration Compressed air quality class Note 2) ISO8573-1:2010 [3:7:3] 45 cm3 Drain capacity 8 cm3 25 cm3 Bowl material Polycarbonate Bowl guard Standard (Polycarbonate) Semi-standard (Steel) Weight 0.10 kg

Digital Flow Switch

It can be positioned at 45 and 90 intervals, clockwise and anti-clockwise. Rotating the display with excessive force will damage the end stop. If there is a risk of foreign matter entering the fluid, install and pipe a filter or the mist separator at the inlet to avoid failure and malfunction.

Electric Actuator / Slider type 《 Battery-less absolute encoder type (Step motor 24VDC) 》

Vibration resistance: No malfunction occurred in a test ranging between 45 to 2000 Hz. The test was performed in both an axial direction and a perpendicular direction to the lead screw.

Digital Pressure Switch

1, After the key lock setting has been completed, perform the first three steps in the unlocking procedure (page 45). 2, After the security code has been entered and the display changes to "UnL", press the and buttons simultaneously for 5 seconds or longer. "000" is displayed and a new security code can now be entered.

CJP2-OM0002K

18.0 10.5 21.0 16 5 10 15 20 25 30 35 40 45 20.0 13.0 26.0 * The above numbers are references for the mounting positions of those auto switches that detect a stroke end.

Air cylinder

Usable stroke by buckling strength Usablestroke by Mounting style Pressur buckling strength (cm) e Symbol and sketch Symbol 125 140 160 180 200 250 320 (MPa) of bracket Rod side 0.3 103 92 113 108 124 155 162 Head L Foot: side Frang flange e F 0.5 79 70 86 81 94 118 122 L G F 0.7 66 58 72 67 78 98 101 0.3 45 38 47 46 54 67 69 0.5 33 27 34 33 39 49 49 G 0.7 26 22 27 26 31 39 39 0.3 96 83

3 Port Solenoid Valve

In such a case, use caution not to scratch the seat face because the seat face of the fittings 45 gasket is the sealing face. Do not use compressed air that contains chemicals, synthetic oils that include organic solvents, salt, corrosive gases, etc., as it can cause damage or malfunction. 5. Piping to products 1. Install an air filter.

High Vacuum L Type Valve

Vibration resistance allows for normal operation of up to 30 m/s2 (45 to 250Hz), but continuous vibration may cause a decline in durability. Arrange piping to avoid excessive vibration or impacts. High temperature type (temperature specification / H0 H4 H5) 1.

LUBRICATOR

DIMENSIONS Bracket (Accessory) (Port size) Maintenance space Model Standard specifications M5X0.8 1/81/4 AL10-A 25 51.5 25.5 12.5 35 12.5 AL20-A 40 79.3 35.9 20 60 20 AL30-A 53 104.1 38.1 26.7 30 80 26.7 AL40-A 70 136.1 39.8 35.5 38.4 110 35.5 AL40-06-A 75 138.1 37.8 35.5 38.4 110 35.5 AL50-A 90 209 41.2 45 110 45 AL60-A 95 223 44.7 47.5 110 47.5 1/43/8 1/43/81/2 3/4 3/41 1 Bracket mount