S Couplers IDK Fluid: Water, Air Operating temperature range: 5 to 150C Note) This product should not be used with steam. 341 KKA Series Plug (P) Socket (S) Part no. Male thread type Male thread type Body size Body size Part no.
P-77 (YG) Positioning Driver Series LC6C Driver LC6D has built-in pulse control function Position information can be set up to a maximum of 28 points Point movement can be easily accomplished with a PLC, etc. Compatible with Series LX electric actuator 2-phase stepping motor Application examples Can be used in operation patterns like these.
These can be mounted on all filter models. Differential pressure indicator Operating pressure24 kPa Mounting orientation: Vertical upward Once a value is displayed, it will continue to be displayed until reset, even if the pump is stopped. (Reset type) Perform element replacement when the red ring floats up and covers the entire view port. Reset button COM. N.O. N.C.
N.C. and N.O. common A differential pressure indicator or a differential pressure indication switch can be selected, and mounted on all filter models. Differential pressure indicator Operating pressure20 kPa Once a value is displayed, it will continue to be displayed until reset, even if the pump is stopped.
Low power consumption: 4 W A long pipe can also be connected to the discharge port. It can be connected directly to a compressor. ADM200Model Air 1.0 MPa 1.5 MPa Fluid Max. operating pressure Proof pressure Ambient and fluid temperature Operating cycle 5 to 60C (No freezing) 1 cycle in a minute (Standard) 2 sec.
1 to be closed while check ball !3 is open, and causing built-up oil outside to enter into the diaphragm interior. When exhaust pressure once again enters, operation of the piston and diaphragm causes the diaphragm to be compressed, and check ball !1 opens, causing the oil in the diaphragm interior to be discharged from discharge port !2.
D-R Note 3) Options for 2, 6, and 8 can not be specified at the same time. (Ex.) 68 Note 4) Symbols 9, D, J can not be specified at the same time. (Ex.) 9-D-J Note 5) For products with auto drain, either symbol D or J cannot be specified at the same time. 1 Indicate the required filtration rate after the symbol 1. Ex.)
The expected performance and safety assurance of the equipment will be the responsibility of the person who has determined its compatibility with the product regardless of any recommendation.
Note) Compared with AR25 type, its adjusting spring will only be changed for 0.2 MPa. It is not the product which does not allow the pressure more than 0.2 MPa.
This product cannot be used as a check regulator by installing it between solenoid valve and actuator. It can result in causing breakdown and malfunction. 2.
Speed Controller with Residual Pressure Release Valve with One-touch Fitting ASFE Series RoHS Residual pressure can be easily released with one push of button. Model Elbow type Applicable tubing O.D.
When in the exhaust position, the valve may be padlock secured, preventing accidental start-ups while personnel are cleaning or servicing equipment. The supply/exhaust status of the air flow can be verified at a glance in the indicating window.
The tightening torque should be 0.05 to 0.1 Nm. As a rule, it should be turned about 90 beyond the point at which tightening can be felt. Auto Switch Mounting Bracket Part No. Auto switch part no. D-M9(V) D-M9W(V) D-M9A(V) Auto switch mounting bracket part no.