α PneuAlpha HARDWARE MANUAL Choose the desired connecting block with the OK key Function Blocks (FB) are connected by joining an output pin to an unused input pin. The arrow is pointing to the output pin. The output pin is always shown on the right side of the function blocks. Unused Input pins are shown as > while used input pins show as a solid triangles.
Absolutely never use in an atmosphere where explosive gases are used. The compact manometer does not have explosion proof construction. If used in an atmosphere of explosive gases, there is a possibility of causing an explosion, and therefore, should absolutely not be used under these conditions. 1. The compact manometer can be used for measurement of air and non-corrosive gases.
Internal voltage drop Caused by the resistance of an electrical part in an electronic circuit. Example is a 2-wire pneumatic pressure switch. 16-13-3 11 Glossary of Terms K Key lock mode It is the function to prevent from malfunctioning. Commands other than unlocking key lock mode by pressing the botton can not to be accepted.
Use piping with an adequate effective sectional area. Select piping for the vacuum side which has an adequate effective sectional area, so that the ejectors maximum suction flow rate can be accomodated by the piping. Also, make sure that there are no unnecessary restrictions or leaks, etc. along the course of the piping.
Compressed air can be dangerous if an operator is unfamiliar with it.
Note 2) An auto switch magnet is not attached. In cases where an auto switch magnet is attached, please add -M9// at the end of the part number. (Not available for high temperature models) Note 3) Auto switch and solenoid valve are not attached.
In such a case, give an additional tightening to the tube connection part. If leakage still occurs after giving an additional tightening, replace the fitting with a new product. For other precautions, refer to Fittings & Tubing Precautions. When using the fluoropolymer fittings, refer to the precautions on pages 445 and 446. Select the size after confirming O.D. and I.D.
An application which could have negative effects on people, property, or animals requiring special safety analysis. 4. Use in an interlock circuit, which requires the provision of double interlock for possible failure by using a mechanical protective function, and periodical checks to confirm proper operation. 1.
L2 = 21 x m + 89.8 L1 = 10.5 x n + 45 Do not operate in an atmosphere containing flammable or explosive gases. Fire or an explosion can result. This product is not designed to be explosion proof. Default settings At the time of factory shipment, the product is in "Remote Control Mode" and set to "Enable DHCP".
Verify the specifications before use. 1 9 Specification 2 Specification Item Gateway distributed system 2 (128 points) specifications Do not operate in an atmosphere containing flammable or explosive gases. Fire or an explosion can result.
A non-compatible connector can be connected to a compatible connector as well as an M12.
Otherwise an injury can result. Safe communication is running.