Table of Contents Rt I lA-t 2 N12t 2931 29 | PRll 25 /225 .Jd 1.63 2.00 1.7 5 l.l3 #t0 nsnsaoo$ FPill5oo !oi" All dimensions in incrres. SQUARE FI.ANGE (SR LOCK / srot ffi l r g (lloloq llo. P! llonber l|odol (n.fl IC TH SA SB loll tre Wl. (ot.) sf?rr-t2 M483010056 9M2000 5e es .41 .62 3.50 2.75 1r 20 Ali drmensions in inches. -i FFH FooT MoUNT XIT (Fil) Pt\4120.
silencer, Direct exhaust L5 Note 1) In case of two or more options, enter them in alphabetical order.
Finally, the cool dehumidified air is heated in the reheater by hot inlet air and discharged in a dry state.
order, starting from station No. 1 as shown in the drawing.
Indicate the valves to be mounted below the manifold part number, in order starting from station 1 as shown in the drawing. When a layout becomes complicated, please indicate it on a manifold specification sheet.
Indicate the valves to be mounted below the manifold part number, in order starting from station 1 as shown in the drawing.
conditions that exceed the lines in the graphs above, be sure to use a regenerative absorption unit.
OUT IN OUT IN OUT IN OUT IN OUT IN 56 31 157 100 353 252 628 471 982 756 1608 1206 4 CXS 6 15.7 10.0 35.3 25.2 62.8 47.1 98.2 75.6 161 121 6 CXS10 8 CXS15 Manual Release 10 CXS20 Manual release (Non-locking type) 1.
If the cylinder is used in an application in which a magnetic material is placed in close contact around the cylinder as shown in the figure on the right (including cases in which even one of the sides is in close contact) the operation of auto switches could become unstable. Therefore, please consult with SMC for this type of application. Magnetic substance (Iron plate etc.)
Do not operate multiple cylinders in synchronization. Avoid applications in which two or more cylinders with end lock are synchronized to move one workpiece, as one of the cylinder locks may not be able to release when required. 6. Use a speed controller with meter-out control. Lock cannot be released occasionally by meter-in control. 7.
Decide when to replace the pads, referring to the signs of deterioration, such as changes in the appearance due to wear, reduction in the vacuum pressure or delay in the transport cycle time.
the specification sheet in the case of CM and LM.
Cylinder side pressure (P2) IN IN Specifications Max. operating pressure Min. operatingpressure Ambient and fluid temp.
case of CP port plug is inserted in all 2(A) port.
Do not use in the atmosphere and environment over the rated specifications. 2. Do not use in the environment of corrosive gas or liquid splash. 3. Do not use in an environment where oil and chemicals are used. Maintenance Caution 1. Perform periodic inspection. 249
Make measurement on dimensions A as shown in Fig. 5 (b) and adjust it in such a way that Dimensions A are equal to those B, resulting in being at such a condition as shown in (e) of Fig. 5. As can be seen in Fig. 5 (a) and (b), the lock nut should be set to the bottom in the installation employing the joint. In the installation not employing the joint, set it to the top.
(If the devices are connected in series in the vacuum line, their conductances must be combined.)