ZL3-OM00601

(mg/m3) 0.1 d 0.5 0.5 d 1.0 1.0 d 5.0 point() 1 20,000 400 10 1 -70 1 0.01 2 400,000 6,000 100 2 -40 2 0.1 3 Not specified 90,000 1,000 3 -20 3 1 4 Not specified Not specified 10,000 4 +3 4 5 5 Not specified Not specified 100,000 5 +7 6 +10 3.3.2 Air pressure 1) Operation with a pressure exceeding the maximum operating pressure leads to breakage of the product.

ZL3-OM00801

. *1 F06 G3/4 B1 N.0.+N.C. *1 F04 2xG1/2 B2 N.O.

AC Servo Motor Driver (SSCNET /H Type)

(SW1) (SW1) (SW2-3, SW2-4) (SW2-3, SW2-4) 0 33 0 49 1 34 1 50 2 35 2 51 3 36 3 52 4 37 4 53 5 38 5 54 6 39 6 55 ON ON 7 40 7 56 8 41 8 57 1 2 3 4 1 2 3 4 9 42 9 58 A 43 A 59 B 44 B 60 C 45 C 61 D 46 D 62 E 47 E 63 F 48 F 64 -14- 5. Parameter list (Driver side) Please configure the appropriate parameters to enable correct driver operation. Refer to [5.

HRX-OM-Z015

Table 3-6 RTU mode message frame a) Start b) Device Address c) Function d) Data e) Checksum (CRC) f) End T1-T2-T3-T4 XX XX XX XX XX XX T1-T2-T3-T4 a) Start In Modbus RTU mode, message frames are separated by a silent interval (non-communication time).

Body Size: 50, Thread: F (G), Port Size: 06 (3/4), Mounting: w/o Mounting Option, Bowl: 8 (Metal Bowl w/Level Gauge), Lubricant Exhaust Port: w/o Drain Cock, Flow Direction: Left to Right, Pressure Unit: Pressure Unit: MPa; Temp Unit: °C

Body Size: 50, Thread: F (G), Port Size: 06 (3/4), Mounting: w/o Mounting Option, Bowl: 6 (Nylon Bowl), Lubricant Exhaust Port: w/o Drain Cock, Flow Direction: Left to Right, Pressure Unit: Pressure Unit: MPa; Temp Unit: °C

Body Size: 50, Thread: G, Port Size: 3/4, Mounting: w/o Mounting Option, Bowl: Metal Bowl w/Level Gauge, Lubricant Exhaust Port: w/o Drain Cock, Flow Direction: Left to Right, Pressure Unit: Pressure Unit: MPa; Temp Unit: °C

Thermo-chiller

Series HRS100/150 CAT.NAS40-62B R410A as refrigerant Thermo-chiller Standard Type Series HRS100/150 Circulating Fluid Temperature Controller Triple controller Fan Air-cooled condenser fan control Cooling valve Heating valve Circuit diagram Ventilation Cooling valve control Fan Facility water outlet Temperature sensor (Heat exchanger inlet) Water-cooled condenser Dryer Air-cooled condenser D

HRS100/150

-phase 200 VAC 3-phase 400 VAC [mm] [mm] 93 Environmental friendly R410A as refrigerant Thermo-chiller Standard Type HRS100/150 Series Circulating Fluid Temperature Controller Fan Triple controller Air-cooled condenser fan control Cooling valve Heating valve Circuit diagram Ventilation Cooling valve control Fan Facility water outlet Dryer Air-cooled condenser D

rep-modular-e

Hook spanner flat Bowl O-ring Bowl assembly Detent: 4 places Lock button Setting mark 412 AL50/AL60 Exploded View 2 Lubrication plug assembly Actuators Modular F.R.L.

Modular Pressure Control Equipment F.R.L. Replacement Procedure

Hook spanner flat Bowl O-ring Bowl assembly Detent: 4 places Lock button Setting mark 412 AL50/AL60 Exploded View 2 Lubrication plug assembly Actuators Modular F.R.L.

Lightweight and Compact

Writing Readout Run/Stop Circulating fluid temperature setting (SV) Circulating fluid present temperature Circulating fluid discharge pressure Status information Alarm occurrence information Item Specifications Connector type D-sub 9-pin, Female connector Protocol Modicon Modbus compliant/Simple communication protocol Standards EIA standard RS-485 EIA standard RS-232C To the thermo-chiller

Size: 3/4, Thread: G, Port Size: 3/4, Accessory: -, Option 1: -, Option 2: -

HRX-OM-Z002

Grounding class: D-class grounding (with a ground resistance of 100 or less) 3.3.3 Preparation and wiring of power supply cable The electrical facilities should be installed and wired in accordance with local laws and regulations of each country by a person who has knowledge and experience. Check the power supply.

Thermo-chiller

D-G

Table of Contents

D-F7WV D-F79F D-A7H D-A80H D-F7 D-J79 D-F7W D-F7BAL D-J79W D-F79F D-F7NTL DD-M9 D-M9V D-F7V D-A7 D-A80 D-F7BAVL D-J79C D-A79W D-A9V D-M9V D-A73C D-A80C D-A79W D-A9 D-A9V Bore size (mm) D-A7 D-A80 D-F7WV D-F9WV D-F9BAL -X D-F9BAL D-F9WV D-F9W 20Data B A B A B A B A B A B A U U U U U U U U U 12 16 20 32 40 50 9 4 13 8 12 7 17 19.5 16.5 11.5 11.5 12 12 9 9 22.5 23.5 29.5 26 29 25 17.5 9.5 18

5

Auto Switch Mounting Height (mm) D-B5m D-B64 D-B59W D-G5m D-K59 D-G5NT D-G5mW D-K59W D-G5BA D-G59F Auto switch model D-F5m D-J59 D-F5mW D-J59W D-F5BA D-F59F D-F5NT D-Z7m D-Z80 D-Y59m D-Y7P D-Y7BA D-Y7mW D-M9m D-M9mW D-M9mA D-A9m D-A3mC D-G39C D-K39C D-A44C D-A3m D-G39 D-K39 D-A44 D-A5m D-A6m D-A59W D-M9mV D-M9mWV D-M9mAV D-A9mV D-Y69m D-Y7PV D-Y7mWV D-P3DWA D-P4DW Bore size Hs Ht Hs Ht Hs

Air Cylinder Series CA2

Auto Switch Mounting Height (Except low friction, air-hydro cylinders) (mm) D-B5 D-B64 D-B59W D-G5 D-K59 D-G5NTL D-G5W D-K59W D-G5BAL D-G59F Auto switch model D-A9 D-M9 D-M9W D-M9AL D-F5 D-J59 D-F5W D-J59W D-F5BAL D-F59F D-F5NTL D-Z7 D-Z80 D-Y59 D-Y7P D-Y7BAL D-Y7W D-Y69 D-Y7PV D-Y7WV D-A3 D-G39 D-K39 D-A44 D-A5 D-A6 D-A59W D-A3C D-G39C D-K39C D-A44C D-A9V D-M9V D-M9WV D-M9AVL D-P4DWL Bore

Made to Order

D-M9(V)/M9W(V)/M9A(V) D-A9(V) D-B5/B6 D-G5/K5 Hs Hs B A B A D-B7/B8 D-G7/K7 D-C7/C8 D-H7 Hs Hs B A B A Proper Auto Switch Mounting Position (mm) Proper Auto Switch Mounting Height (mm) D-B7/B80 D-B73C D-B80C D-G79/K79 D-K79C D-H7C D-G5NT D-G5/K59 D-G5W D-K59W D-B5/B64 D-B59W D-G5BA D-G59F Auto switch model D-G59F/G5 D-K59 D-G5W D-K59W D-G5NT D-G5BA Auto switch model D-H7 D-H7C D-H7NF D-H7W

Air Cylinder

Mounting Height Auto Switch Proper Mounting Position (mm) D-Y59< D-Y69< D-Y7P D-Y7PV D-Y7D-Y7D-Y7BA D-Z7< D-Z80 D-B59W D-G39 D-G39C D-K39 D-K39C D-A5< D-A6< D-A3< D-A3D-A44 D-A44C Auto switch model D-G5< D-K59 D-G5NT D-G5D-K59W D-G5BA D-G59F D-M9< D-M9D-M9D-M9D-M9D-M9D-F5< D-J59 D-F59F D-F5D-J59W D-F5BA D-A9< D-A9D-J51 D-F5NT D-B5< D-B64 D-P3DW D-P4DW