XMC/XYC Series

The switch section should be kept at the temperature no greater than 60 oC. Selection Caution All models 1. When controlling valve responsiveness, take note of the size and length of piping, as well as the flow rate characteristics of the actuating solenoid valve. 2.

XMD/XYD Series

The switch section should be kept at the temperature no greater than 60 oC Selection All models 1. When controlling valve responsiveness, take note of the size and length of piping, as well as the flow rate characteristics of the actuating solenoid valve. 2. Actuating pressure should be kept within the specified range. 0.4 MPa to 0.5 MPa is recommended. 3.

Pressure Sensor for General Fluids

The fluid and ambient temperatures should be -10 to 60 C. Operation under low temperature leads to cause damage or operation failure due to frozen moist in the fluid or air. Protection against freezing is necessary. Air dryer is recommended for elimination of drain and water. Avoid sudden temperature change even within specified temperature.

CG1-OM0227

ON 3. 60 ON 4. OFF ( OFF 1. 2. ON 24 4. (XC85,X446) 4-1. -XC85 GR-H-010(10g) <> splash zone <> splash zone 4-2.

Air cylinder (Series compatible with secondary batteries)

D-M9V-900 1 D-M9WV-900 55 30 (n 4 65 30 (n 4 60 30 (n 4 70 30 (n 4 10 30 (n n=(4,8,12,16) n n=(4,8,12,16) n=(4,8,12,16) n=(4,8,12,16) n=(2,4,6,8) 15 Auto switch Connection and Example 16 3.

CG1x-OM0006N

ON 3. 60 4. 1. OFF ( OFF) 2.

MX-OMP0051

60 MXQ20(A,C) 30.2 19.2 19.2 19.2 19.2 19.2 19.2 19.2 19.2 34.9 35.9 35.9 35.9 41.9 50.9 75.9 75.9 75.9 MXQ25(A,C) 32.4 23.4 23.4 23.4 23.4 23.4 23.4 23.4 23.4 42.7 41.7 41.7 41.7 54.7 54.7 40.7 79.7 77.7 A 10 20 30 40 50 75 100 125 150 10 20 30 40 50 75 100 125 150 MXQ6B 16 5.4 5.4 5.4 5.4 5.4 15 25.6 25.6 31.6 48.6 25.6 MXQ8B 27 11.9 11.9 11.9 11.9 11.9 11.9 16 23.1 23.1 31.1 31.1 50.1

Miniature Guide Rod Cylinder

Operable temperature range is -10 to 60 deg.C (No freezing). Use the product within this range. If the cylinder is used outside of the operable temperature range, the seal can be worn out due to hardening of the seal and lubrication failure of the grease, causing air leakage.

MGP-OM0242Q

This compact cylinder is applicable within the range from 10 to 60 C. Make sure to keep it during operation. In case of immoderate use over the range, extreme wearing due to hardening of packing may result in air leak and lubrication failure as lubrication grease cannot perform fully. 11.

RS2H-OM0045P

ON 3. 60 4.

CEx-OMQ0010

a0~60 b25~85%RH c d e 5. f g. h i 6. j k L 2. 7. 8. 1. 9. 2. 10. 11. ()70% ()35% 1. 15% 1. 2. 3 3. () 1. 0.1~1.0MPa 0.3~0.5MPa 0~60 ()35% 2. ) 1. 1. 2. 2. 3. 1. 1. ( 2. 6 ) 3. 2. 50% 4. (6 ) 3. 5. 4. () 0.5 5. 1 2 3. F.G. 1. 4. 1 ISO VG32 1. 2. 1. 2. 3. 1. 2 1. 2. 2. 14.5mT CE2 1.5~2 15,000 18cm 3. 4. IP65 5.

MONOSASHI-KUN WITH BRAKE CONTROLLER

Place where ambient temperature exceeds the range of 0 to 60. b. Place where ambient humidity exceeds the range of 25% to 85% RH. c. Place where condensation occurs due to sudden temperature change. 4. Deceleration circuits or shock absorbers are d. Place where atmosphere containing corrosive gas, flammable gas or organic solvent. needed in some cases.

CEx-OMQ0011

P1 No.1 OFF ON P2 No.2 OFF ON P3 No.3 OFF ON P4 No.4 OFF ON P5 P6 P7 P8 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 59 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 60

Trimmer Auto Switch

output PNP 2 output Load voltage 28 V or less Load current 80 mA or less / 1 output Internal voltage drop 1.5 V or less Leakage current 100 A or less / 1 output Response time 1 ms or less Impact resistance 98 m/s2 Insulation resistance 50 M or more under the test voltage 500 VDC (between case and cable) Withstand voltage 1000 VAC 1min (between case and cable) Ambient temperature -10 to 60

CRB2-OM00001

Table 2: Allowable Shaft Load N Model Fr Fs CRB2BW40 60 40 Note) Point of application of force Fr is the center to longitudinal dimension of key. 6 It is recommended to use the method in Figure 2 to avoid applying direct load to the shaft for better operating conditions.

Parallel Type Air Gripper

frequency (c.p.m.) 180 60 Lubrication Lubrication not required.

LEF-OM007xx

CLASS4 ISO CLASS5 ISO CLASS6 1,000,000 Particle concentration [particles/m3] 100,000 10,000 1,000 100 10 1 0 0.1 0.2 0.3 0.4 0.5 0.6 Particle diameter [m] Clean class Amount of recommended vacuum aspiration (/min(ANR)) Type Speed mm/s) ISO 14644-1 Fed.Std.209E 6 1000 5 5 100 10 4 10 30 6 1000 5 5 100 10 4 10 30 6 1000 20 5 100 30 4 10 50 6 1000 5 5 100 15 4 10 30 6 1000 20 5 100 50 4 10 60

JXCx-OMU0026

JXC-OMU0026 (3) LIN-A / LIN-I . 59 (4) CIR-R / CIR-L / CIR-3 . 60 (5) SYN-I . 60 10. Description of operation . 61 10.1 Return to origin . 61 10.2 Positioning Operation . 62 10.3 Pushing Operation . 64 10.4 Linear interpolation . 68 10.5 Circular interpolation . 71 10.6 Speed tuning control . 75 10.7 PLC output signal response time . 77 10.8 Methods of interrupting operation . 77 11.

Step Motor Controller With Step data Teaching Function (Servo / 24VDC)

Move Speed Position Accel PushingF T riggerL V PushingSp Moving F Area1 Area2 In posn mm/s2 mm/s mm mm/s2 mm/s mm mm mm 0 Absolute 100 20.00 1000 1000 0 0 0 100 18.00 22.50 0.5 1 Absolute 50 10.00 1000 1000 70 60 5 100 6.0 12.0 1.5 63 Absolute 20 5.00 500 500 0 0 0 100 3.0 8.0 1.2 6.

LEC-OM034xx

Size *The rated temperature for the insulation coating: 60 degrees C or more. EMG signal output AWG20: Single line,No insulation sleeve, Twisted wire with (EMG+,EMG-) bar terminal.