LEJ-OM004xx

The vacuum aspiration fluence shows the fluence immediately before piping in the actuator. 5 - 3.How to Order 11LEJS 40 A 500 S2 1 10 9 8 7 4 5 3 2 6 *1 (2) Motor type (3) Lead [mm] (1) Size 40 LEJS40 LEJS63 Output [W] Actuator size Compatible controller Type 63 16 A 20 AC servo motor (incremental encoder) S2 10 8 B LECSA-S1 40 100 (5) Motor option AC servo motor (incremental encoder) S3

VFR3000 Series

Operation manual DC coil: 3% or less of rated voltage Warning AC coil: 20% or less of rated voltage 3. Solenoid valve drive for AC with a solid state output (SSR, TRIAC output, etc.) Install the products and operate them only after reading the operation manual carefully and understanding its 1) Current leakage contents.

HRX-OM-M005

AC/DC 800mA Max. load current (Other than Pin (Pin No.15 is common to output signals. Total used load current should be at or No. 5-18) below 800mA.) Rated load voltage Max. AC48V / Max. DC30V Contact output signal Max. load current AC/DC 800mA (resistance load) (Pin No. 5-18) Rated load voltage Max. AC48V / Max.

SY3000/5000/7000/9000 Series (Pilot Valve:V100)

AC> (There is no S option.Because the generation of surge voltage is prevented by a rectifier) Note) Surge voltage suppressor of varistor has residual voltage corresponding to the protective element and rate voltage.

SYJ Series

DC coil 3% or less of the rated voltage AC coil 8% or less of the rated voltage 2. Solenoid valve drive for AC with a solid state output (SSR, TRIAC output, etc.) 1) Current leakage When using a snubber circuit (C-R element) for surge protection of the output, a very small amount of electrical current will continue to flow even during the OFF state.

HRX-OM-K003

DC30V Max. load current AC/DC 800mA (resistance load, inductive load) EMO signal Rated load voltage Max. AC48V/ Max. DC30V Max. load current AC/DC 800mA (resistance load, inductive load) Your system Thermo Chiller Pin No.

10

Load voltage Auto switch model Lead wire length [m] Pre-wired connector Applicable load DC AC Tie-rod mounting Band mounting 0.5 (Nil) 1 (M) 3 (L) 5 (Z) Indicator light Wiring (Output) Type Special function Electrical entry 3-wire (NPN) 24 V 5 V, 12 V M9N V V V v v IC circuit 3-wire (PNP) M9P V V V v v 2-wire 12 V M9B V V V v v Terminal conduit 3-wire (NPN) Grommet G39 2-wire 12 V

Series CQ2

D-Z80 Electrical entry direction In-line Applicable load Relay, PLC, IC circuit AC DC AC DC AC DC 100V 24V or less Load voltage 48V Maximum load current 50mA 40mA 20mA Contact protection circuit None 1 or less (including lead wire length of 3m) Internal resistance Leakage current . None Operating time . 1.2ms Lead wires .

2–4

Applicable load IC circuit, Relay, PLC Load voltage 24 V or less 48 V or less 100 V or less AC DC AC DC AC DC Maximum load current 50 mA 40 mA 20 mA Contact protection circuit None Internal resistance 1 or less (including lead wire length of 3 m) D-A93, D-A93V, D-A96, D-A96V (With indicator light) D-A93, D-A93V D-A96, D-A96V Auto switch part no.

CQS

Special function Style Electrical entry Indicator Load voltage Auto switch model Wiring (Output) Applicable load 0.5 () 3 (L) 5 (Z) DC AC Perpendicular In-line 5V 12V 100V or less IC A90V A90 Yes No Yes Relay PLC Reed switch Solid state switch 2 wire 24V A93V A93 Grommet 100V 12V 3 wire (Equiv.

CY1

Indicator light Type Electrical entry Wiring (output)) Special function Applicable load 0.5 (Nil) 3 (L) 5 (Z) AC DC Vertical Lateral 3 wire (NPN equiv.)

Microspeed Cylinder

Auto switch specifications Load voltage Lead wire length (m) Indicator light Type Special function Wiring (output) Electrical entry Auto switch model Applicable load 0.5 (Nil) 3 (L) 5 (Z) None (N) DC AC 3 wire (NPN equiv.)

3 Port Direct Operated Solenoid Valve Metal Seal, Body Ported 1

80 or less 180 or less 180 or less 30 or less 60 or less 300 or less 180 or less 0.8 1.4 100 90 20 14 13.2 Response time (1) (ms) VFN Max. operating frequency (c.p.m.) (2) DC AC DC AC 1.6 2.4 300 360 50 60 24 Weight (kg) 50 Hz Apparent power (VA) Inrush 60 Hz AC 50 Hz Holding 60 Hz Power consumption (W) DC Note 1) Based on JIS B 8375-1981.

VT307

Without indicator light: 4.8 W, With indicator light: 5 W ZNR (Varistor), Neon bulb Diode, LED (Neon bulb for 100 V or more) How to Calculate the Flow Rate Inrush Holding (3) (4) Apparent power AC For obtaining the flow rate, refer to page 4-1-6. (3) (4) Power consumption Light/Surge voltage suppressor (Not applicable for grommet type) DC AC DC Courtesy of Steven Engineering, Inc.-230 Ryan

VQ4000

Refer to pages 2-5-40 to 2-5-43 for with control unit.consumption of AC type. The release valve and the pressure switch on the manifold with control unit are connected to another power supply.

AC MASS PRO 1/4 MODULAR (NPT). 1.90585 lb. DC.

AC MASS PRO 1/4 MODULAR (NPT). 1.21254 lb. DC.

AC MASS PRO 1/4 MODULAR (PT). 1.85072 lb. DA.

AC MASS PRO 1/4 MODULAR (PT). 2.10602 lb. DA.

AC MASS PRO 1/4 MODULAR (NPT). 1.70460 lb. DC.