HRX-OM-Z015 Change by operation display panel Change by mode request About mode request The mode request is the ability to change the operation mode by the serial communication.
This maintains the seal created by the seal , in place, thus shutting the outside air from inside the bowl G. If there is no accumulation of condensate in the bowl G, at this time float M will be pulled down by its own weight, causing valve H, which is connected to lever A, to seal valve seat J.
(Locked by double solenoid valve.) SOL. location SI unit output no. (Locked by double solenoid valve.)
Moreover, due to the fact that bumpers are installed at each end of the piston, overall length is increased by 6mm for 32 and 40, 8mm for 50 and 63, and by 10mm for 80 and 100.
Continuous suction and discharge is performed by the reciprocal motion of the diaphragm. 2.
1 manually counterclockwise lowers piston u, which pushes open the seal created by seal !
pressure with by-pass High back pressure with flow rate adjustment & by-pass High back pressure with indicator Symbol 2 3 4 5 6 Orifice dia. 4 8 10 16 22 Body class 2 3 4 5 6 1 6 With flow rate adjustment Valve type VX2 2 7 With by-pass 0 1 2 N.C.
S Kit can be used by connecting to gateway unit.
Do not carry a cylinder by the auto switch lead wires. Never carry a cylinder by its lead wires. This may not only cause broken lead wires, but it may cause internal elements of the switch to be damaged by the stress. 6. Avoid incorrect wiring.
Do not carry an actuator by the auto switch lead wires. Never carry a cylinder by its lead wires. This may not only cause broken lead wires, but it may cause internal elements of the switch to be damaged by the stress. 3. Mount switches using the proper tightening torque. When a switch is tightened above the torque specification, the mounting screws, or switch may be damaged.
Applicable shaft type: W Equal dimensions are indicated by the same marker.
Do not carry a cylinder by the auto switch lead wires. Never carry a cylinder by its lead wires. This may not only cause broken lead wires, but it may cause internal elements of the switch to be damaged by the stress. 3. Mount switches using the proper tightening torque. When a switch is tightened above the torque specification, the mounting screws, or switch may be damaged.
PLC VElectric actuators *1 VProvided by customer.
O.D. of covering: 1.7 mm Hook Covering With power saving circuit Power consumption is decreased by 1/4 by reducing the wattage required to hold the valve in an energized state. (Effective energizing time is over 62 ms at 24 VDC.) 3.
1 manually counterclockwise lowers piston u, which pushes open the seal created by seal !0, thus allowing the condensate to drain out. Manual Draining 1. Turning drain cock !1 manually counterclockwise lowers piston u, which pushes open the seal created by seal !
By substituting the measurement results for formula (8) to figure out Av.
This is possible by inverting the solenoid valve direction 180.
A Adjustment amount by adjustment bolt A Adjustment amount by adjustment bolt A Adjustment amount by adjustment bolt B Adjustment amount by adjustment bolt B Adjustment amount by adjustment bolt B 90 Rotation 90 Rotation 90 Rotation 11-9-13 14 Series MSQ Construction o i t !
This is possible by inverting the solenoid valve direction 180.
The proper operating range can be determined by the color of the light.