HRX-OM-Q040_E

Circulating fluid return port Circulating fluid return port evision 8 4 Rev.G:Oct.2019 3 8 5 3 5 4 1 1 Circulating fluid outlet port Circulating fluid outlet port Caution [HRS-PF001] [HRS-PF002] Mounting Use a long screwdriver for tightening the M5 screws.

FGX-OMZ0008

Dimensions 9/12 FGX-OMZ0008 5. Installation and Piping 1 Installation 1) When installing, allow sufficient space for maintenance. Reserve a space of 100mm or more beneath the reservoir. 2) Start with a flow with an initial differential pressure across the element of 0.02 MPa or less.

FILTER REGULATOR

Construction and operation principle 5 3. How to order 6 4. Precautions for handling 7~8 5. Troubleshooting 9 6. Exploded View 10 7. Drawing 11 -1- Safety Instructions These safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of potential hazard with the labels of Caution, Warning or Danger.

Jxx-OMT0084

How to Order 5.

Rotary Actuated Air Gripper

If air gripper is used below 5, moisture inside the circuit is frozen and may cause damage of packings or malfunction. Take preventative measures for freezing. Refer to SMC Compressed Air Cleaning System for the details of compressed air quality described above. 11 25 Piping ! Caution 1Preparation before piping.

Communication cable for controller setting kit

Installation of driver 5 3.1 Automatic Installation 5 3.2 Manual Installation 6 4. ACT Controller Installation 10 4.1 Installation 10 4.2 Check of the Communication Port 10 4.3 Communication Setting 11 4.4 Functions of Each Mode 12 -1No.JXC-OMX0002 Controller Setting Kit 1.

FGD-E

FGD-KT002 FGDE Nut kit FGD-KT003 FGDT FGD-KT004 FGDF FGD-CV005-03 FGDT,F-03 FGD-CV005-04 FGDT,F-04 FGD-CV005-06 FGDT,F-06 Replacement cover (5) FGD-CV006-03 FGDC,E-03 FGD-CV006-04 FGDC,E-04 FGD-CV006-06 FGDC,E-06 Joint FGD-OP001 FGDB (10) KT-FGDC FGDC Each of (2)(4)(6)(13) and (16) are provided as a kit.

Membrane Air Dryer

When using the product in the temperature range between -5 and 5 deg. C, prevent water droplets from entering the inlet port. (No freezing of the fluid) * Note 2. ANR indicates the flow rate converted to the value at 20 deg. C, under the atmospheric pressure and the state of relative humidity 65%. * Note 3.

Pressure Gauge

Operation principle 5 4. Caution on handling 67 3. Type marking 5 5. Pattern of the dial 8 6. Drawing 8 -1- Safety Instructions These safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of potential hazard with the labels of Caution, Warning or Danger.

Air Cylinder

C96*-MM0049Q 4 Tube Trunnion bore part number 32 V5032P 40 V5040P 50 V5050P 63 V5063P 80 V5080P 100 V5100P Product image CP96S*V*-* 125 V5125P 4 1 5 2 3 Component parts No. Description Qty Notes 1 Trunnion 2 2 Retaining bracket 4 3 Trunnion pin 2 4 Hexagon socket head cap screw 8 4 32 to 80 8 100, 125 Set screw 5 Assembly Procedure No.

11-cqss-e

5 Rod seal Set of left nos. !3, !4, !5. Piston seal NBR Tube gasket Seal kit includes !3, !4, !5. Order the seal kit, based on each bore size. Since the seal kit does not include a grease pack, order it separately. Grease pack part no.: GR-S-010 (10 g) 69

11-cuj-e

Grease pack part no.: GR-L-005 (5 g) 50

Series 10-MGF Guide table ø40, ø63, ø100

mm increments) are available by attaching a spacer of 5, 10, 15, 20 or 25 mm width.

Magnet Gripper

auto switch 24 VDC Small Auto Switches Load voltage Auto switch model Lead wire length [m] Pre-wired connector Applicable load DC AC Perpendicular 0.5 (Nil) 1 (M) 3 (L) 5 (Z) Type Special function Electrical entry Indicator light Wiring (Output) M9NV V V V v v IC circuit 3-wire (NPN) Solid state auto switch 5 V, 12 V 3-wire (PNP) M9PV V V V v v 2-wire 12 V M9BV V V V v v 3-wire (NPN) 5

AS-FPQ/AS-FPG

Block off the heat with a cover, etc. 5. Do not use in locations where static electric charges will be a problem. Consult SMC regarding use in this kind of environment. 6. Do not use in locations where spatter occurs. There is a danger of spatter causing a fire.

Compact Guide Cylinder JMGP Series ø 12, ø 16, ø 20, ø 25, ø 32, ø 40, ø 50, ø 63, ø 80, ø 100

Indicator light Load voltage Auto switch model Lead wire length [m] Pre-wired connector Applicable load DC AC Perpendicular In-line 0.5 (Nil) 1 (M) 3 (L) 5 (Z) Type Special function Electrical entry Wiring (Output) M9NV M9N V V V v v IC circuit 3-wire (NPN) 5 V, 12 V Solid state auto switch 3-wire (PNP) M9PV M9P V V V v v 2-wire 12 V M9BV M9B V V V v v 3-wire (NPN) 5 V, 12 V M9NWV M9NW

ISO Standards Air Cylinder: Standard Double Acting with End of Stroke Cushioning ø 32, ø 40, ø 50, ø 63, ø 80, ø 100, ø 125 Series CP96

Grommet 12 V Diagnostic indication (2-color indication) 5 V, 12 V IC Relay, PLC Yes 24 V 12 V Grommet IC 5 V, 12 V Water resistant (2-color indication) 12 V 3-wire (NPN equivalent) A96 IC 5 V Yes Grommet A93 A90 IC 100 V 100 V or less Relay, PLC 12 V 24 V 2-wire No 1 Water resistant type auto switches can be mounted on the above models, but in such case SMC cannot guarantee water

Low torque Metal seal type Rotary joint

An application which has the possibility of having negative effects on people, property, or animals, requiring special safety analysis. 5 Series MQR Rotary Joint/Precautions 1 Be sure to read before handling. Mounting Design Warning Warning 1.

5 to 60C Note 1)/?5 to 60C Note 1) (NBR seal)?5 to 60C Note 1)/?5 to 99C Note 1) (FKM seal)0.25 to 0.7 MPa?5 to 50C Note 1)Not required (Use turbine oil Class 1 ISO VG32, if lubricated.)10.5 MPa?5 to 50C Note 1)20 times/minVertical upwards1/2?5.2 ?291/83.180

5 to 60C Note 1)/?5 to 60C Note 1) (NBR seal)?5 to 60C Note 1)/?5 to 99C Note 1) (FKM seal)0.25 to 0.7 MPa?5 to 50C Note 1)Not required (Use turbine oil Class 1 ISO VG32, if lubricated.)10.5 MPa?5 to 50C Note 1)20 times/minVertical upwards3/4?6.2 ?3/81/45.6100