Multi Channel Pressure Sensor Controller

C: Revision D: Limited warranty and Disclaimer and measurement laws are added. E: Contents revised in several places. F: Contents revised in several places.

KFx-OMV0007

Tube deformation ratio at the minimum bending radius Here, : Deformation ratio (%) d: Tubing diameter (mm) L: Measured length (mm) D: Mandrel diameter (mm) (Twice against the minimum bending radius) Test temperature: 20 +/5oC Relative humidity: 65 +/5% (3) Do not use fluids other than listed on the specifications. Applicable fluids are air,N2,water and steam.

HEC-OM-U015

D Level gauge K Circulating fluid OUT Set the Communication protocol.

HEC-OM-R008

D-sub 9 pin (socket type) Fixed screw: M2.6 6-8 Unused Unused 9 Unused BUS 1-2 Unused 8 1 Install the product above 0.6m from the floor. 3-5 PT-RTD 5.2 Environment 6 Output Cutoff Alarm a contact (OPEN During Alarm) 15 9 Signal D-sub 15 pin (Socket type) 7 Output Cutoff Alarm Common External Do not use in an environment where the product is directly exposed to Fixed screw: M2.6 temperature

ITV_P-E

ITV2-OM00109-C P R O D U C T N A M E E/P Regulator (16points preset input type) MODEL/ Series/ Product Number ITV1000/2000/3000/2090-52* Series (Switch output: NPN output) ITV1000/2000/3000/2090-53* Series (Switch output: PNP output) Install and operate the product only after reading the Operation Manual carefully and understanding its contents.

Miniature Guide Rod Cylinder Series MGJ

D-X Individual -X 261

PSE530/200

D Auto identification function Display units can be selected using either or . This function automatically identifies the pressure range of the pressure sensor that is connected to the multi-channel pressure sensor controller, thus eliminating the need of having to reset the range again after replacing the sensor.

VX21/22/23

8 F 24 VDC 5 G DIN terminal 24 VDC With surge voltage suppressor A B D E H J L M 4 H 100 VAC Size 2 2 1/4 N.C. 7 J 110 VAC Aluminum 4 5 N.O. 3/8 K 200 VAC 7 L 230 VAC 4 8 7 Resin (With bracket) M Conduit terminal 24 VDC With surge voltage suppressor 4 N 100 VAC 10 7 P 110 VAC A B C D E F G H J K L M N 5 Q 200 VAC Size 3 3 N.C. 8 1/4 R 230 VAC 10 (N.C. only) 6 N.O.

RSQ

CEP1 Action D B T CE1 CE2 Applicable Auto Switch/Refer to page 10-20-1 for further information on auto switches.

JIS Standard Hydraulic Cylinder Double Acting/Single Rod

D-A9, M9, M9W, M9A auto switches are shipped together. (not assembled).

CHA

D-A9, M9, M9W, M9A auto switches are shipped together (not assembled).

CJ2X

Note Data 16 CJ-L016B CJ-F016B CJ-T016B T-bracket is used with double clevis (D). 1. For Series CJ2X, 0.1 Nl/min is the values at maximum in terms of its construction and there is internal leakage (ANR). Foot bracket Flange bracket T-bracket BJ2-010 Common for the types of D-C7/C8 and D-H7 BJ2-016 10-3-7

5 Port Pilot Operated Solenoid Valve Series VFR2000 Rubber Seal, Plug-in/Non Plug-in How to Order Option Port size (P, A, B port) Thread type Electrical entry Rc Nil Nil Nil None Without sub-plate F: Plug-in type 01 1 8 F Z G With light/surge voltage supp

Option Port size (P, A, B port) Thread type Nil F G Rc Nil Z None Nil 01 Without sub-plate 1 8 1 4 With light/surge voltage suppressor 02 N NPT Piping (P, A, B, EA, EB port) T NPTF EA, EB port: Rc 1/8 Nil B Side ported Bottom ported Option SJ 1 00 01 F Plug-in VFR2 5 SY 1 E 10 1 Non plug-in VFR2 02 SV CE-compliant SYJ Q CE-compliant Nil Pilot valve manual override SZ Electrical entry: D/

Heavy Duty Stopper Cylinder Series RSH/RS1H ø20, ø32 ø50, ø63, ø80 3

Port Note 2) Lever detection switch type Direction of transfer R Type E2E-X1C1 E2E-X2D1-N Applicable model RSH 20, 30 RS1H 50, 63, 80 10-9-4

VEX1

1 8 1 8 01 1 02 G Grommet (Lead wire length 300 mm) 1 4 1 4 H Grommet (Lead wire length 600 mm) 1 4 1 4 02 3 03 D DIN terminal 3 8 3 8 DO DIN terminal (Without connector) 04 1 2 1 2 1 2 3 4 1 2 3 4 1 04 5 06 Body ported G Grommet (Lead wire length 300 mm) 10 1 1 1 H Grommet (Lead wire length 600 mm) 10 7 12 14 9 20 2 E Grommet terminal 1 4 1 T Conduit terminal 1 4 1 2 D DIN terminal 1 2

3 Port Solenoid Valve Direct Operated Poppet Type VT317 Series Rubber Seal

Nil Without port (For manifold) (8A) 1 4 02 Electrical entry Light/Surge voltage suppressor CE-compliant CE-compliant G Grommet, 300 mm lead wire H Grommet, 600 mm lead wire Electrical entry D T C H G Only"D" Symbol Nil S Z C Conduit Note) Note) T Conduit terminal Note) D DIN terminal Symbol S: With surge voltage suppressor Note) Refer to the figure below.

Model: 10 (Side Ported), Connector Type: F (D-sub Connector, 25 Pins), Connector Entry Direction: 1 (Upward), Valve Stations: 5 Stations, P, E Port Location: D (D Side), SUP/EXH Block: R (External Pilot), A, B Port Size: N7 (ø1/4" One-touch Fitting), Mounting: D (DIN Rail Mounting w/o Name Plate), DIN Rail Option: 0 (w/o DIN Rail with Bracket)

Model: 10 (Side Ported), Connector Type: F (D-sub Connector, 25 Pins), Connector Entry Direction: 2 (Lateral), Valve Stations: 2 Stations, P, E Port Location: D (D Side), SUP/EXH Block: R (External Pilot), A, B Port Size: C8 (ø8 One-touch Fitting), Mounting: D (DIN Rail Mounting w/o Name Plate)

Model: 10 (Side Ported), Connector Type: F (D-sub Connector, 25 Pins), Connector Entry Direction: 2 (Lateral), Valve Stations: 3 Stations, P, E Port Location: D (D Side), SUP/EXH Block: R (External Pilot), A, B Port Size: C8 (ø8 One-touch Fitting), Mounting: D (DIN Rail Mounting w/o Name Plate)

Model: 10 (Side Ported), Connector Type: F (D-sub Connector, 25 Pins), Connector Entry Direction: 1 (Upward), Valve Stations: 2 Stations, P, E Port Location: D (D Side), SUP/EXH Block: R (External Pilot), A, B Port Size: N7 (ø1/4" One-touch Fitting), Mounting: D (DIN Rail Mounting w/o Name Plate), DIN Rail Option: 0 (w/o DIN Rail with Bracket)