HRX-OM-W060

For a facility having a small installation area (that can not vent the air naturally): Make a forced air exhaust vent on a wall at a high level and an air inlet on a wall at a low level. 3.

DOC1001322

For a facility with a large installation area that can vent the air naturally: Make an air outlet on a wall at a high level and air inlet on a wall at a low level, to allow for adequate airflow. 2. For a facility with a small installation area that cannot vent the air naturally: Make a forced air exhaust vent on a wall at a high level and an air inlet on a wall at a low level. 3.

HRX-OM-W032

For a facility having a small installation area (that can not vent the air naturally): Make a forced air exhaust vent on a wall at a high level and an air inlet on a wall at a low level. 3.

Digital Pressure Switch

Normal output Reversed output P_1 = A (A B)/4 n_1 = B + (A B)/4 A = Maximum pressure H_1 = (A B)/2 H_1 = (A B)/2 B = Minimum pressure In the OUT2 setting, the above P_1, n_1 and H_1 will be P_2, n_2 and H_2 respectively.

SI unit ( device)

If the connector is a larger diameter it will interfere with the clamping face. -34No.EX-OMW0016-A Revision history A: Contents revised in several places.

Industrial Filters

FGDT/F(L250) Replacement case assembly FGDT/F(L500) FGDC/E(L250) FGDC/E(L500) 25 A FGD Series Dimensions FGDA (1 element) FGDB (2 elements) 108 108 2 x Rc 2 x Rc AIR VENT M6 AIR VENT M6 OUT IN OUT IN B A FGDT FGDF B A DRAIN DRAIN G1/4 G1/4 Element removal dimension: 50 mm (mm) A B Model Element length Port size Rc 314 346 A (L250) FGDC FGDE 574 606 B (L500) 3/8, 1/2, 3/4 314 349 A (L250)

3 Port Solenoid Valve

x 0.8 Port 2 M5 x 0.8 Note) 10-V114(A) and 10-V124(A) cannot be mounted on the same manifold.

High-precision Digital Pressure Switch

Bracket A (Part No.: ZS-50-A) Bracket B (Part No.: ZS-50-B) -13No.PS-OMW0002-C Piping Piping specification: -02 and -N02 After hand tightening, tighten the fitting using a spanner on the flat surfaces of the fitting. The tightening torque must be 8 to 12 Nm. Piping specification: -F02 After hand tightening, tighten the fitting using a spanner on the flat surfaces of the fitting.

SI unit ( device)

Use a soft cloth to remove stains.

CL

If there is a risk of contact, provide safety measures such as a cover or a system that uses sensors that will activate an emergency stop before contact is made. 2. Use a balance circuit in which lurching of the piston is taken into consideration.

3M/SMseries

-1.8WDC WF333O Exhaust Conter NVF343O GNced Center (B) (A) (B) (a) 01 c2 \ t \ T I'f E I J E Z (R2)(PxFl) (R2XPXR1) Prssure Center NVF3530 (B) (A) Spej;ifications -, Flurd-Art f Operatangprssurcrange2Positionsingle2O-12gPSlS(1.5-9kgF) U 2 pooition double-1 5 1 28 PSI (1 9kgf/cm'?

I

Plugging one of the cylinder ports (A or B) enables use as a 3 port valve. lt should not be used in special applications such as use as a non-leakage valve. Make sure the exhaust port is open if used as a 3 port valve. Solenoid {X) represents plugged port. common Exhaust ifflg"o,BJ"". rnd Pilot valve I Exhaust air from pilot valve will flow to main valve exhaust port.

tTV2000/3000

See pg 4 for Dart numbers I Switch outpuUPNP output t{ Analoo output 4 to 20mA A 1/2 (3000 type) rTUz000/3000 tlectrn-Pneuma Relula on Combinations itlaildtLii:l:i.rtrlif iii:ti,.:..aiu.lu:.it:rit spqtrcatrons iet pressure max. 0.1MPa 1 a o iet Dressure max. 0.5MPa o a o iet oressure max. 0.9MPa a o )onnection Rc(Pfl 1/4 02 o o o E EE .ti'6 u, at CL ]onnection Rc(PT) 3/8 03 o o )onnection

Series 10-SY3000/5000/7000/9000 5 Port Solenoid Valve Body Ported/Single Unit

How to Order 10 SY 5 L 5 1 20 01 Clean series Bracket Series Nil: Without bracket F1: With foot bracket A, B port size 3 10-SY3000 5 10-SY5000 Thread piping 2 position single only Coil type Symbol Port size M5 x 0.8 10-SY3000 Applicable series 7 9 10-SY7000 10-SY9000 M5 Standard Nil 1 8 01 10-SY5000 T With power saving circuit (24, 12 VDC only) Actuation type 1 4 10-SY7000 02 02 03 2 position

Series VER2000/4000 5 Port Electro-Pneumatic Proportional Valve How to Order Port size Nil Without sub-plate 1 4 02 3 8 03 ARJ 02 VER2000 Series VER2000 AR425 to 935 AMR 03 0 VER400 Series VER4000 ARM Thread type Pilot type ARP 0 Internal pilot Rc Nil Por

VEA 5 (R1) 4 (A) 1 (P) 2 (B) VY2 OFF state VBA VBAT F1 < F2 condition: See figure q. 2 (B) 3 (R2) AP100 4 (A) ON state Immediately after turning on F1 > F2: See figure e. Thereafter F1 = F2: See figure w. 4 (A) 1 (P) 2 (B) 3 (R2) Inw, port 3(R) is half open. 705

Water Strainer

range (-X215): 0.05 to 0.69 MPa Rc1/8, Rc1/4 NPT1/8, NPT1/4 Port size: Rc1/8 Port size: Rc1/4, 3/8, 1/2 Series WF300 14-E628 Series WF300 Dimensions 25 25 A A 14 41 54 29 66.5 Construction A-A Component Parts q e w r No.

CLQ

Hs A B A B 32 to 100 D-A73C D-A80C D-J79C D-A79W D-F7WV D-F7V Approx.

IP8001 Series

Caution Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Warning Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury. Danger Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury. Warning 1.

Compact Cylinder with Lock Series CLQ

Hs A B A B 32 to 100 D-A73C D-A80C D-J79C D-A79W D-F7WV D-F7V Approx.

ChemicalThermo-con

No need for a tube-type heat exchanger. No need for a tubetype heat exchanger. Can directly control temperature of chemicals.