High Vacuum L Type Valve nut and a washer) 9 (Valve seal 2) Washer (Material: SUS304 or equivalent) Nut (Material: SUS304 or equivalent) (Shaft) Working principle Port 1(P) is normally pressurized, and the valve opens when the solenoid valve is turned ON and closes when it is turned OFF. 10 XL-OMV0016 5-2.Dimensions C (KF flange) (K flange) Fd Fn C J Port 1(P) S K L M N B T Port 3(R) A G A Unit: mm Model A B C Fn
Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Caution: Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury. Warning: Danger : Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury.
nut and a washer) 9 (Valve seal 2) Washer (Material: SUS304 or equivalent) Nut (Material: SUS304 or equivalent) Shaft (Material: SUS304) 7 Working principle Port 1(P) is normally pressurized, and the valve opens when the solenoid valve is turned ON and closes when it is turned OFF. 10 XL-OMV0019 5-2.Dimensions C (KF flange) (K flange) Fd Fn C J Port 1(P) S K L M N B T Port 3(R) A G A Unit
Caution Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Warning Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury. Danger Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury. Warning 1.
As a guide, tighten it by hand, then turn it two or three turns with a wrench. Check the dimensions of each product for the hexagon width across flats.
HOUR METER 19 Records the accumulated time an Output or Input signal has been ON SCHMITT TRIGGER 19 Turn an Input On at the High Value and Off at the Low Value (or vice versa) ZONE COMPARE 20 Compare a value to a range of values (Analog, Direct Set, or FB values) DISPLAY * Display Messages or Data on the LCD display OFFSET GAIN 22 Manipulate Analog Values; y = A/B*x + C; Set High and Low
A counter clockwise until it stops (approx. 45). 4) Install a new element on cover A and insert it into the case.
As a guide, tighten it by hand, then turn it two or three turns with a wrench. Check the dimensions of each product for the hexagon width across flats.
side B side LES LEPY LEPS q 0.08 C side LER w LEFG32 (L = 30 mm) Displacement [mm] 0.06 LEFG25 (L = 25 mm) D side LEH LEFG16 (L = 20 mm) 0.04 LEY -X5 Model Traveling parallelism [mm] (Every 300 mm) LEFG40 (L = 37 mm) q C side traveling parallelism to A side w D side traveling parallelism to B side 11LEFS 0.02 LEFG16 0.05 0.03 LEFG25 0.05 0.03 11LEJS LEFG32 0.05 0.03 0 0 100 200 300 400 500
How to order JMHZ2 16 D M9B S X7500 A C KR Number of fingers *Note 2) For KAWADA ROBOTICS CORPORATION 2 2 Number of auto switches Protection cover Bre bize[mm] Nil. Without protection cover Nil. 2 16 16mm C With proctection cover S 1 Action N n D Double acting Test attachment *Note1) Nil. Without attachment Auto switch A With attachment Auto switch No.
This product cannot be used to hold a stop position for an extended period of time. Pilot check valves and actuators are not guaranteed for zero air leakage. Therefore, it is sometimes not possible to hold a stop position for an extended period of time. In the event that holding for an extended time is necessary, a mechanical means for holding should be devised. 3.
To release residual pressure, select a model with a backflow function. Using a model without a backflow function makes for inconsistent residual pressure release (i.e., residual pressure may or may not be released) depending upon the operating conditions. 3.
To release residual pressure, select a model with a backflow function. Using a model without a backflow function makes for inconsistent residual pressure release (i.e., residual pressure may or may not be released) depending upon the operating conditions. 3.
A COM. C () White Reset (Vacuum suspension) B DC negative common Lead wire colors Set (Vacuum generation) Simultaneous energization protection circuit COM. (+) Red () Black SOL. A C (+) White Reset (Vacuum suspension) B AC type Lead wire colors 100 VAC, 200 VAC Set (Vacuum generation) Yellow Yellow A 3.
Flow Characteristics/Weight C [dm 3/(sbar)] b Cv C [dm 3/(sbar)] b Cv 1 2 (P A) 2 3 (A R) Valve model Flow characteristics Weight (g) Operating pressure range (MPa) Port size Grommet DIN terminal 0.10 0.13 0.13 0.10 0.13 0.13 0.13 0.13 0.13 0.13 0.41 0.32 0.32 0.41 0.32 0.59 0.32 0.32 0.59 0.32 2 3 2 3 2 3 VKF33 VKF33 Y VKF33 E VKF33 V VKF33 W VKF334 VKF334Y VKF334E VKF334V VKF334W 0.67
Proportional Valve Related Products: Specifications A solenoid valve for actuating a cylinder and an electro-pneumatic proportional valve for pressure control have been integrated into a single unit.
ANm0m0-KMmm 5.2-4 40dB(A): High Noise Reduction Silencer Series ANA1 A high noice reduction style silencer keeps the noise level inside a plant below 85dB(A).
Dimensions E C D E E L (Width across flats) M (Width across flats) M8 (KF Flange) (K Flange) Fn Fd C Detail of (a) (a) M Rc1/8 J H K B A G A Model A B C D E Fn Fd XLGR-80*-1* 90 250 117 45.5 38.5 114 110 XLGR-100*-1* 108 270.5 154 55 38.5 130 102 XLGR-160*-1* 138 339 200 65 38.5 180 153 Model G H J K L M XLGR-80*-1* 83 105 44 9 13 4 XLGR-100*-1* 102 92 58 9 13 4 XLGR-160*-1* 153 124 62 12.5
Caution Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Warning Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury. Danger Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury. Warning 1.