REC cable O.D.: 6.8 to 11.5) CE1 CE2 Proper Auto Switch Mounting Position D-H7 D-H7C D-H7NF D-H7W D-H7BAL D-C7 D-C80 D-C73C D-C80C ML2B D-G39 D-K39 D-A33/A34 D-A44 D-B5 D-B64 D-B59W D-G5NTL Bore size (mm) C J G5-S A B A B A B A B A B A B CV 20 56.0 31.5 50.0 25.5 55.0 30.5 51.5 27.0 53.0 28.5 49.5 25.0 25 MVGQ 56.0 31.5 50.0 25.5 55.0 30.5 51.5 27.0 53.0 28.5 49.5 25.0 32 59.5 36.5 53.5 30.5
Connection of fittings For a fitting with sealant R or NPT, first, tighten it by hand, then use a suitable wrench to tighten the hexagonal portion of the body an additional two or three turns. For the tightening torque, refer to the table below. 9. Ventilation Provide ventilation when using a valve in a confined area, such as in a closed control panel.
After blowing, make sure to hang the product on a hook, etc. Caution 1. Clean specification is not available with this product. When using in a clean room environment, confirm the required cleanliness before use. A minute amount of particles are generated due to wearing of the emitters while the product is operating. Wiring / Piping Warning 1.
Leakage voltage When a resistor and a switching element are used in parallel or C-R device (surge voltage suppressor) is used for the protection of the switching device, note that leakage voltage will increase because earth leakage current passes through the resistor and C-R device. The suppressor residual leakage voltage should be 0.2 VDC or less.
P/As seal material has undergone a high vacuum degassing process. Orifice conductance In the case of a A (cm2) hole in an ultra-thin plate, the conductance C results from V the average velocity of the gas, R the gas constant, M the molecular weight and T the absolute temperature.
' view RE A B Breathing hole REC A-A' view CX CY MQQ M RHC Manual button MK(2) RS Q G RS H A RZQ MI W S Non-lube type Long stroke type CEP1 CE1 Component Parts CE2 Note Material Material No.
B-1 A-1 B-2 A-2 B-3 A-3 Connector C terminal no. Signal Cable color S Standard cable Brown Red Orange Yellow Green Blue A A B B COM-A/COM COM-B/ 2 1 6 5 3 4 Cable color Connector D terminal no.
This is a function to protect personnel and restrict operation that may cause damage to the product or facility, and to remove dangers related to safety. Apr R AR BR CR DR ER FR . May S AS BS CS DS ES FS . Caution If instructions are not followed there is a possibility of injury or equipment damage. Jun T AT BT CT DT ET FT .
Caution Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Warning Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury. Danger Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury. Warning 1.
Caution Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Warning Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury. Danger Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury. Warning 1.
A vacuum pad is a consumable part, so it is warranted for a year after it is delivered. Also, even within the warranty period, the wear of a product due to the use of the vacuum pad or failure due to the deterioration of rubber material are not covered by the limited warranty.
2 w y r !0 e New PFA q Body New PFA w Sensor Super PFA e Tube PPS r Housing A PPS t Housing B PPS y Housing C POM u Bushing PPS i Cap FKM o Gasket FKM !0 O-ring Stainless steel 304 !1 Thread PVC !2 Lead wire !1 q t i PF2D540 o !0 u !0 !2ywr e !
36 1/8 (EA, EB port) 1741 Series SYA3000/5000/7000 Dimensions/Series SYA7000: Base Mounted 3/8, 1/4 (A, B port) 21 22.5 2 position single 11.5 13.5 SYA714002 03 57 77.5 42 10.4 61 M5 x 0.8 (Pilot port) B A PE 38 46 B A Manual override P EB EA 21 69 6.4 2 x 4.3 (For mounting) 87.5 26.5 1.8 (Ventilation hole) 13.5 3/8, 1/4 (P , EA, EB port) 20.5 20.5 33 3/8, 1/4 (A, B port) 21 22.5 2 position
The cylinder should be operated using a connection method which allows for shaft alignment variations and deflection due to the cylinder's own weight. A drawing of a recommended mounting method is shown in Figure 1.
Setting Position (mm) D-C7 D-C8 D-C73C D-C80C D-G39 D-K39 D-A33, A34 D-A44 D-B5 D-B6 D-H7l D-H7C D-G5NTL D-H7lW D-H7lF D-H7BAL D-B59W Bore size (mm) A B A B A B A B A B A B A B 20 56.0 31.5 50.0 25.5 55.0 30.5 51.5 27.0 53.5 29.0 53.0 28.5 49.5 25.0 25 56.0 31.5 50.0 25.5 55.0 30.5 51.5 27.0 53.5 29.0 53.0 28.5 49.5 25.0 32 59.5 36.5 53.5 30.5 58.0 35.5 55.0 32.5 57.0 34.0 56.5 33.5 53.0
Keep this manual in a safe place for future reference.
B Model A B VNH211 -15A A B VNH311 -20A A B VNH411 -25A A B VNH113 -10A A B VNH213 -15A A B VNH313 -20A A B VNH413 -25A A B VNH133 -10A A B VNH233 -15A A B VNH333 -20A A B VNH433 -25A VNH111 -10A Operating fluid pressure Fluid Operation Operating fluid temperature 0 to 3.5 MPa Coolant External pilot solenoid/Air operated 5 to 60C /5 to 60C (NBR seal) 5 to 60C /5 to 99C (FKM seal) 0 to 7.0
This product cannot be used to hold a stop position for an extended period of time. Pilot check valves and actuators are not guaranteed for zero air leakage. Therefore, it is sometimes not possible to hold a stop position for an extended period of time. In the event that holding for an extended time is necessary, a mechanical means for holding should be devised. 3.
Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Caution: Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious injury. Warning: Danger : Danger indicates a hazard with a high level of risk which, if not avoided, will result in death or serious injury.
In order to prevent a malfunction or diaphragm damage caused by debris or cutting chips in the fluid, install a filter with approximately 100 mesh on the inlet side of a flow switch. C (COM) A (N.O.) Color of lead wire Black Symbol Contact C Z I SE3 Common A White Normally Open B (N.C.)