HRX-OM-R026

Table 8-1 Quality standard for clean water (tap water) Standard value Item Unit For circulating fluid For facility water pH (at 25oC) 6.0 to 8.0 6.5 to 8.2 Electric conductance (at 25oC) [S/cm] 100 to 300 100 to 800 Chloride ion [mg/L] 50 or less 200 or less Sulfuric acid ion [mg/L] 50 or less 200 or less Standard item Acid consumption (at pH 4.8) [mg/L] 50 or less 100 or less Total hardness

Slider Type Ball Screw Drive/11-LEFS Series

force is 100%.

Mini-Rotary Actuator Series CRJ Rack-and-Pinion Type/Size: 05, 1

Accelerating torque calculation (Example) (Example) Friction coefficient Ta = I x (Nm) Mass m F = mg Clamp F F I : Inertial moment Static torque calculation Movement Load Refer to features page 5. : Angular acceleration = (rad/s) Tf = F x l (Nm) g = 9.8m / s F: Pressing force (N) l l Static torque calculation 2 Load t2 Ts = F x l (Nm) Lever : Rotation angle (rad) t : Rotation time

2 Finger, 3 Finger, 4 Finger Air Gripper Parallel Type Series MHS

N 0.5MPa 0.5MPa 40 40 0.4MPa 0.4MPa F 0.3MPa 0.3MPa 20 20 0.2MPa 0.2MPa 0 0 10 10 20 20 30 30 40 40 Gripping point L mm Gripping point L mm MHS2-25D MHS2-25D 100 100 F Internal gripping Pressure 0.6MPa Pressure 0.6MPa 80 80 Gripping force N Gripping force N 0.5MPa 0.5MPa 60 60 Note: 1N = 0.2248lbf 1in = 25.4mm 1MPa = 145psi 0.4MPa 0.4MPa 40 40 0.3MPa 0.3MPa 0.2MPa 0.2MPa 20 20 0 0 10 10

AIR COMBINATION

Note 5) If the compressor is small (0.75 kW, discharge flow is less than 100 L/min[ANR]), air leakage from the drain cock may occur during start of operations. N.C. type is recommended. 18 6.

Ionizer

V to +400 V +30 V to +100 V Within 30 V 30 V to 100 V 100 V to 400 V 400 V or lower Light ON Positive Static neutralization completion Flash at 4 Hz Detects the electric potential difference and outputs in an analog voltage.

Magnetically Coupled

shaft indicates the moment point of the cylinder and the load section. 100 1000 Allowable driving force Fn (lbf) Allowable driving force Fn (lbf) 100 10 10 Usable range Usable range 1 0 1 2 3 4 1 0 2 4 6 Distance from cylinder shaft center Lo (inch) Distance from cylinder shaft center Lo (inch) NCY3B25 100 Allowable driving force Fn (lbf) 10 Usable range 1 0 1 2 3 4 5 Distance from cylinder

Micro Mechanical Valve Series VM1000

) 3 (R) 14.5 14.5 2 x 1/8 2 x 4.6 mounting hole 44 25.4 17 * 0.5 MPa supply F .O.F .* 15 N T.T. 90 Key can be removed at the on and off positions.

Speed Controller with One-touch Fitting Stainless Series Series AS-FG Elbow Type/Universal Type

Cylinder extension speed: 100 mm/s Meter-out needle fully open 100 mm/s Return speed Solenoid valve (Reference) Recommended circuit for high return speed When low extension speed and high return speed are desired, the following circuit using 3-port is recommended. Exhaust port (EA) Supply port (P) Exhaust port (EB) Fig.

Electronic Pressure Switch Series (Separate Type)

kPa 27 to 80 kPa 4.5 to 28 VDC (ZSM1-115) 24 to 125 VDC 100 to 250 VAC to 100 VDC to 100 VAC 24 to 220 VDC 100 to 550 VAC Voltage 100 VAC/DC or less (ZSM1-121) Repeatability 0.05 MPa 0.05 MPa 3% F .S. 3% F.S. 3% F.S. 3% F.S. 10% F.S. 15 kPa or less (ZSM1-115) 0.02 to 0.35 MPa (Without pointer scale) 0.03 to 0.4 MPa (Without pointer scale) Hysteresis (Calibration range of ISG) 0.08 MPa or

VQ20/30

Blue (100 VAC) 2 (, +) 2 Red (200 VAC) Indicator light Indicator light With indicator light With indicator light Red (+) DC Blue (100 VAC) Series VC (Class H coil) Red (100 VAC) Grommet, Conduit, Conduit terminal AC circuit For energy-saving circuit, there is the polarity. 1 DIN terminal Since internal connections are as shown below for the DIN terminal, make connections to the power supply

Clamp Cylinder Series CK1

Applicable cylinder series CKP140-100 63 50 40 CKP140-125 BK1T-040 D-P4DWSC D-P4DWSE D-P4DWL/Z CKP140-150 Series CKG1 CKG140-50 CKG150-50/CKP150-50 CKG163-50/CKP163-50 CKG140-75 CKG150-75/CKP150-75 CKG163-75/CKP163-75 CKG140-100 CKG150-100/CKP150-100 CKG163-100/CKP163-100 CKG40-R050 Series CKP1 BAP1T-040 D-P79WSE D-P74L/Z Series CKG140/50/ 63 CKG40-R075 CKG40-R100 Series CKP150/63 CKG140-

VDW Series

(the value under the prescribed conditions) 0.8 0.7 0.6 Subsonic Critical pressure 0.5 0.4 0.45 0.45 Sonic 0.4 0.4 0.35 0.35 0.3 0.3 0.3 0.25 0.2 0.25 0.2 0.2 0.15 0.15 0.1 0.05 0.1 0.1 0.05 S = 0.54 VDW101 10 60 50 40 30 20 10 20 VDW 1.6 S = 1.2 125 100 75 50 S = 3.2 VDW202.3 350 300 250 200 150 100 50 S = 5.8 VDW203.2 600 500 400 300 200 100 S = 2.8 VDW302 300 250 200 150 100 50 VDW303

2/3 Port Valve for Various

LQ Thread type Nil T F N For 32A For 40A For 50A 32 40 50 Rc NPTF G NPT Flange LVN Refer to the table (1) given below for availability.

Digital Pressure Switch

Other parameter settings Item Page Default setting [F 3] Response time page 30 2.5 ms [F 4] Display resolution page 31 1000-split [F 5] Auto-preset function page 32 Manual [F 6] Fine adjustment of display value page 34 0% [F 7] Power saving mode page 35 OFF [F 8] Security code page 36 OFF [F90] Setting of all functions page 37 OFF [F97] Copy function page 39 OFF [F98] Check of output page

Valve Mounted Guide Cylinder Series MVGQ ø12, ø16, ø20, ø25, ø32, ø40, ø50, ø63, ø80, ø100 Valve, Speed Controller, and Cylinder are formed into one unit. Easy piping wiring work for Valve, Speed Controller and Cylinder can be formed into one unit, furthe

Built-in magnet for auto-switches CV MVGQ Maximum Driving Speed of Cylinders 1000 1000 900 900 Cylinder speed (mm/s) Cylinder speed (mm/s) 800 800 Load factor: 10% Load factor: 50% 700 700 600 600 500 500 400 400 300 300 200 200 100 100 0 12 16 20 25 32 40 50 63 80 100 0 SYJ3000 VZ3000 VZ5000 VF3000 Bore size (mm) Series Variations Bore size (mm) Standard stroke (mm) Applicable valve series

PSxx-OML0002CN

> [F 2] [F 1] OUT1(2729) 1[-], [F 3] <> [F 3] [F 3] -30No.PS-OML0002CN-G [F 4] <> [F 4] 1000 100 [F 4] [MPa]/[kPa(ZSE)]/[kgf/cm 2]/[bar]/[psi]/[inHg] ([kgf/cm 2]/[bar]/[psi]/[inHg] 26[F 0] -31No.PS-OML0002CN-G [F 5] <> [F 5] [F 5] -32No.PS-OML0002CN-G OUT1 AP1 (OUT1AP1 1AP2) OUT1 OUT1 OUT1 A1L A1H (A1L 1AP2) OUT2 P_1 H_1(n_1 H_1)AP2 (OUT2AP2 1 ) OUT2 OUT2OUT1OUT2

One-touch Fittings

Possible to use in vacuum to 100 kPa.

7

CKGA80, 100/CKPA80, 100/With Magnetic Field Resistant Auto Switch (Rod Mounting Type) 1 P3DWASC CK G A 80 Y Built-in standard magnet type with magnetic field resistant auto switch 100 Built-in strong magnet type with magnetic field resistant auto switch 100 P79WSE CK P A 80 Y Built-in standard magnet Number of auto switches Nil S 2 pcs. 1 pc.

SI unit for DeviceNet TM

Max. cable length for network Communication speed Drop line length Cummulative Drop Thick cable Thin cable 500 kbps 100 m 100 m 39 m max. 250 kbps 250 m 100 m 78 m max. 6 m or less 125 kbps 500 m 100 m 156 m max. Terminating resistors DeviceNetTM requires a terminating resistor to be installed at each end of the trunk.