Auto switches can be mounted on any of the 4 surfaces with no projection of the switch.Rotary clamp cylinder w/auto switch mounting grooves, Bore sizes (mm): 12, 16, 20, 25, 32, 40, 50, 63, Standard stroke (mm): 10, 20, 30, 50 (depending on bore size), Clockwise or counterclockwise rotary direction, Auto switch capable, Cylinder, Rotary Clamp, CLAMP CYLINDER, 562 lb
Auto switches can be mounted on any of the 4 surfaces with no projection of the switch.Rotary clamp cylinder w/auto switch mounting grooves, Bore sizes (mm): 12, 16, 20, 25, 32, 40, 50, 63, Standard stroke (mm): 10, 20, 30, 50 (depending on bore size), Clockwise or counterclockwise rotary direction, Auto switch capable, Cylinder, Rotary Clamp, CLAMP CYLINDER, 557 lb
EX600-SEN3_4_eng Safety cannot be assured in the case of unexpected malfunction. : This switch can be enabled and disabled by parameter. -10 to 50 oC (Max. surrounding air temperature rating: 50 oC) Operating temperature range -20 to 60 oC Storage temperature range Switch for diagnosis: Allocates the diagnostic data to the input data.
The connection parts of the unit are firmly joined with seals and injury can result. -10 to 50 oC (Max. surrounding air temperature rating: 50 oC) Operating temperature range 1 Input data + System diagnosis 4 byte OFF ON -20 to 60 oC Storage temperature range ON OFF 2 Input data + System diagnosis + Unit diagnosis (Up to 10 units) 6 byte For use in Pollution Degree 3 Environment (UL508) Pollution
(M4 x 20) Tightening torque: 0.7 to 0.8 Nm. The tightening torque at the valve side depends on the valve type. Refer to the operation manual of the corresponding valve manifold.
Assembly and disassembly of the SI unit -25No.EX-OMV0023-A Specifications Specifications General specifications Item Specifications Ambient temperature -10 to +50 oC Ambient humidity 35 to 85%RH (No condensate) Ambient temperature for storage -20 to +60 oC Withstand voltage 500 VAC applied for 1 minute Insulation resistance 500 VDC, 10 M or more Operating atmosphere No corrosive gas Enclosure
mA or less Operating temperature range -10 to 50 oC Storage temperature range -20 to 60 oC Enclosure IP67 (manifold assembly) 2 Standard CE marked (EMC directive, RoHS directive), UL (CSA) 1: All unused connectors must have a seal cap fitted.
Max. 1.0 A/unit : When an external power supply is used: Max. 1.5 A/unit (Note) Load current Bit: 7 0 32 output type 50 mA or less Internal current consumption IP67 Enclosure rating Bit: 7 0 Operation: -10 to 50 oC, Storage: -20 to 60 oC (no condensation or freezing) Ambient temperature range Bit: 7 0 Operation, Storage: 35 to 85%RH (No condensation) Operating humidity range After maintenance
Dimensions Type R Installation type 372 4 x M5 mounting hole 342 58 34 12 6 72 50 149 2 492 Type J Handy type LQ-GJ 36 76 117 30 49 127 37.5 43 63 Type K Handy type 45 LQ-GK 36 SET POS.
When embedded O-ring Air Machining dimensions for mounting Sealed with O-ring Air Bore size (mm) Stroke A B C D E F G 5 12 8.5 6 4 3.5 M8X1.0 6.5 3 10 20 16.5 14 15 28 24.5 22 5 16 12.5 10 6 3.5 M10X1.0 8.5 3 10 23 19.5 17 15 30 26.5 24 5 17 13.5 10.5 10 3.5 M15X1.5 12 4 10 23.5 20 17 15 30.5 27 24 5 19 14.5 11.5 16 4.5 M22X1.5 19 5 10 25 20.5 17.5 15 31.5 27 24 Note) E and F should be machined
Solenoid Specifications Model V114-5LU Fluid Air Ambient and fluid temperature (C) 10 to 50 (No freezing) Response time (DC) (ms) ON: 5 or less OFF: 4 or less Max. operating frequency (Hz) 20 Lubrication Not required Mounting position Unrestricted Impact/Vibration resistance (m/s2) 15030 Enclosure rating Dust proof Model V114-5LU Electrical entry L plug connector(L) Coil rated voltage (V)
19 18 17 (68AH)SW008A 48 47 46 45 36 35 34 33 (68BH)SW008B 64 63 62 61 52 51 50 49 1 to 64 represents the station number.
When instructions are given in the Specific Product Precautions, follow these specifications. 1/2 20 to 25 3/4 28 to 30 1 36 to 38 1 1/4 40 to 42 1 1/2 48 to 50 2 48 to 50 3) If the fitting is tightened with excessive torque, a large amount of sealant will seep out.
Communication cable Type Specifications Vinyl cord VCTF JISC3306 2-core nominal area: 0.75 mm2 (signal cable x 2) Conductor resistance (20 oC): 25.1 /km VCTF cable (commercially available cable) Nominal area: 0.75 mm2 x 4 (signal cable x 2, power cable x 2) Ambient temperature: 60 oC or less Special flat cable Type SCA1-4F10 (length 100 m) Power supply wiring The SI unit is a multi power
Failure to follow this instruction may cause the actuator to suddenly move. (14) When the product is used in a balance control circuit, the check valve may not be released even when the pilot pressure is 50% of the operating pressure. In this case, obtain the pilot pressure from a position so that the pilot pressure is equivalent to the operating pressure.
. -3- Product Features Guide Cylinder/Compact Type MGC Series 20, 25, 32, 40, 50 -4- 1. How to Order WEB catalog for details. Applicable Auto Switches/Refer to WEB catalog for further information on auto switches. WEB catalog. WEB catalog. -5- 2. Model/Stroke 3. Specifications 4. Theoretical Output -6- 5. Weight 6. Moving Parts Weight 7.
Maintenance Air temperature() -20 -10 0 10 30 40 50 60 1. Perform maintenance inspection according to the procedures indicated in the operation manual. If handled improperly, malfunction and damage of machinery or equipment may occur. 2.
Please be noted that the diaphragm assembly adheres to the bonnet if disassemble parts with the handle facing downwards. 20 ) Diaphragm assembly Applicable model Process Procedure Tool Check item Assembly Mount parts to the body in order of the diaphragm assembly, pressure adjusting spring, and pressure adjusting screw.
Compact Cylinder/Non-rotating Rod: Double Acting, Single Rod Series CQ2K Replacement Procedure is 12, 16, 20, 25 32, 40, 50, 63 P.290 Construction Standard (40 to 63) !4 !5 !3 !4 !5 !3 With auto switch Without auto switch The numbers are the same as the "Construction" of the CQ2 series catalog (CAT.ES20-205). *BLUE links will lead to purchase pages.
Compact Cylinder/Non-rotating Rod: Double Acting, Double Rod Construction Series CQ2KW 12, 16 20, 25 32, 40 50, 63 Replacement Procedure is P.290 Standard (40 to 63) Actuators Modular F.R.L. Pressure Control Equipment Air Preparation Equipment Industrial Filters Replacement Procedure Actuators Modular F.R.L. Pressure Control Equipment Industrial Filters !6 !8 !5 !7 !6 !8 !5 !