Smooth Cylinder/Low Speed Cylinder CA2Y100-PS When only grease for maintenance is necessary, please order by the following part numbers.
Cable lengths other than those shown below should be arranged by the customer.
As the actuator can be operated by hand, move it to the required position. When the Direct Teaching is completed, return the SVON in the main window to ON. Caution 1) Some actuators cannot be operated by hand even when the servo is turned OFF.
Remaining tape could cause imperfect cooling or failure by entering into the product.
Do not carry a rotary table by the auto switch lead wires. Never carry a rotary table by its lead wires. This may not only cause broken lead wires, but it may cause internal elements of the auto switch to be damaged by the stress. Fix the auto switch using the appropriate screws on the switch body. If other screws are used, the auto switch may be damaged.
by means of the ON input.
Reference 1 NG Check allowable load mass by thrust. m mh, mv Check allowable load mass by thrust. OK Reference 2 Check allowable load mass by stroke. NG Check allowable load mass by stroke. m mst ) mst: See Graphs (1) to (7). OK Reference 3 Consider load factor on guides.
The circulating fluid discharged from the pump, is heated or cooled by the users equipment and returns to the thermo-chiller. The circulating fluid is controlled to a set temperature by the refrigeration circuit, to be discharged to the users equipment side again by the thermo-chiller.
EtherCAT is registered trademark and patented technology, licensed by Beckhoff Automation GmbH, Germany.
When the pressure falls below the set value (P_1) by the amount of hysteresis value (H_1), the switch will be turned OFF. The default settings are P_1: -70.0 kPa and H_1:10.0 kPa. Operation of OUT2 Supply pilot valve: OUT2 is turned on by the signal for suction. Suction starts by the generation of vacuum pressure.
Compared with the previous type (Series REA: 300 mm/s), the tact time can be shortened by approximately 1/2.
To accomplish this, use a device such as a highly responsive electric control circuit or solenoid valve driven by direct current, and place the solenoid valve as close as possible to the cylinder. 4. Note that the stopping accuracy will be influenced by changes in piston speed.
Do not carry a cylinder by the auto switch lead wires. Never carry a cylinder by its lead wires. This may not only cause broken lead wires, but it may cause internal elements of the switch to be damaged by the stress. 3. Mount switches using the proper fastening torque.
When the pressure falls below the set value (P_1) by the amount of hysteresis value (H_1), the switch will be turned OFF. The default settings are P_1: -70.0 kPa and H_1:10.0 kPa. Operation of OUT2 Supply pilot valve: OUT2 is turned on by the signal for suction. Suction starts by the generation of vacuum pressure.
Remaining tape could cause imperfect cooling or failure by entering into the product.
unit by rotating it clockwise.
Compared with the previous type (Series REA: 300 mm/s), the tact time can be shortened by approximately 1/2.