AS VCHC AS1201F-M3, AS1211F-M3 AS1301F-M3, AS1311F-M3 AS1201F-M5-02, AS1211F-M5-02 AS1201F-M5, AS1211F-M5 AS1301F-M5, AS1311F-M5 AS2201F-01, AS2211F-01 AS2301F-01, AS2311F-01 ASS Inlet pressure: 0.5 MPa Inlet pressure: 0.5 MPa Inlet pressure: 0.5 MPa ASR ASQ Flow rate (L/min (ANR)) Flow rate (L/min (ANR)) Flow rate (L/min (ANR)) Number of needle rotations Number of needle rotations Number of
1/4 to 1/2 Port size IR IR 66 IRV 36 Female thread for bottom mounting 4 x M5 x 0.8 depth 7 VEX Bottom bracket is not available as an option.
close proximity with each other either horizontally or vertically Plug connection ower supply output connection 30 e-Con connector Analog output or auto shift input 2 outputs + Sensor connection M5 female thread, through type (with mounting holes) M3 M5 female thread, through type M5 6 reducer 4 reducer R1/8,NPT1/8 Applications Manifolding is possible.
Port sizes ol M5 and PT1/8 are available. . A model with the maximum odput pressure ot 7 pst{0.51kgf/ cm,) is available for the minimum pressure setting ot O.O7 psl {0.005k9flcm1. Subdivided pressure range .
Spring 134313 o AWM Dimensions AWD K A Model ARJ1020F-M5-04 ARJ1020F-M5-06 21 22 B 10.4 12.8 C 4 6 D E F 10.6 (Width across flats: 10) G H J Caution 17.2 M5 X 0.8 6 3.5 15.5 50 ITV qRelease the lock to adjust the pressure. After the adjustment, engage the lock. Failure to observe this procedure could damage the handle or cause the secondary pressure to fluctuate.
Mandrel = LD 2d 1 x 100 Here, : Deformation ratio (%) d: Tube diameter (mm) L: Measured length (mm) D: Mandrel diameter (mm) (Twice against the minimum bending radius) Test temperature: 20 5C Relative humidity: 65 5% Air Supply Warning 5.Do not use fluids other than specified. The only fluid that can be used is air. 1. Use clean air.
415 VAC (50/60 Hz) 20 A M5 4 cores x 5.5 mm2 (4 cores x AWG10) (Including grounding cable R5.5-5) R5.5-5 HRS150-Al-40-l HRS150-Wl-40-l Note) An example of the cable specifications is when two kinds of vinyl insulated wires with a continuous allowable operating temperature of 70C at 600 V, are used at an ambient temperature of 30C.
10 15 F CDJP D 10 15 F 90 S With Auto Switch Number of auto switches Action Air cylinder with auto switch S 2 1 Mounting Bore Size * 5 stroke: S type only With auto switch 6 10 15 6mm 10mm 15mm Symbol Mounting Standard B F L D T Basic Flange Foot Clevis Trunnion Applicable Auto Switches Length of lead wire (m) 0.5 () Load voltage Wiring (Output) Auto switch model No.
How to Order B 40 30 D CQ2X Without auto switch With auto switch CDQ2X A73 B 40 30 D Number of auto switches With auto switch (with built-in magnet) Auto switch type 2 pcs. 1 pc. "n" pcs. Nil S n Nil Without auto switch (with built-in magnet) Microspeed cylinder Select auto switch model number from the table below.
Port thread type (for 32) Nil TN TF Rc NPT G Action D Double acting M5 for 15 to 25.
Hz) 20 A M5 4 cores x 5.5 mm2 (4 cores x AWG10) (Including grounding cable R5.5-5) R5.5-5 HRS150-A -40HRS150-W -40Note) An example of the cable specifications is when two kinds of vinyl insulated wires with a continuous allowable operating temperature of 158F (70C) at 600 V , are used at an ambient temperature of 86F (30C).
Tightening the threaded portion of an M3, M5 or M6 fittings 1) M3 First, tighten it by hand, then give it an additional 1/4 turn with a wrench. 2) M5 and M6 First, tighten it by hand, then give it an additional 1/6 turn with a wrench. Mounting Caution 1. Check tubing for damage before installing. Confirm model size, etc. 2.
Touching an emitter when it is electrified may result in electric shock or other accidents. d) Avoid using in a place in the presence of corrosive or explosive gas or where there is a volatile combustible. 3.
AS-D AS-T Made to Order ASP Lubricant: Vaseline 1 X12 Grease-free (Seal: Fluorine Coated) + Throttle Valve (Without Check Valve) 2 X21 ASN Ex.) AS1201FG-M5-23-X12 AQ Ex.) AS1201FG-M5-23-X21 Note 1) Not particle-free Note 2) Throttle valve is only compatible with the part no. of the meter-out type. Throttle Valve (Without Check Valve) 3 X214 ASV Ex.)
G Stainless steel Body material Applicable tubing O.D. 04 06 08 10 12 4 6 8 10 12 Body size 2 Elbow Type 2 3 4 5 6 M5 1/8 1/4 3/8 1/2 Control type Port size 0 1 Meter-out Meter-in M5 01 02 03 04 M5 x 0.8 R1/8 R1/4 R3/8 R1/2 With one-touch fitting 1
01 02 03 04 06 M5 x 0.8 AQ1500 AQ1510/2000 AQ2000/3000 AQ3000 1 8 Standard 1 4 0 1 M5 x 0.8 8 3 1 8 Note) AQ150 only 1 2 AQ5000 3 4 Thread type Metric thread (M5) Rc NPT G Nil N F Caution Be sure to read before handling.
m GH641 m3 m5 m 200 kPa ISA3-F ISA3-G 1 m3 m5 m 1 m3 m5 m [mm] [mm] 9 0 10010 ISA3-H 1 m3 m5 m [mm] 29 0 30030 -19No.PS-OMR0001CN-J 2 ISA3-() ISO1179-1 1 2 3 4 5 6 L1 38 76 114 152 190 228 C(4 ) C(6 ) F(G ) H 13 13.6 19 ISA-14() -20No.PS-OMR0001CN-J 2 ISA3-(DIN ) ISO1179-1 1 2 3 4 5 6 L1 38 76 114 152 190 228 L2 62.5 125 162.5 200 237.5 275 L3 73 135.5 173 210.5 248 285.5
IS400-1 (1S-1) IS400-2 (1S-2) Model Port size B J A C D E F G H I , 1 4 1 2 1 1 AL800-12 to 14-1 AL900-20-1 431 (481) 437 (487) 3 x M5 x 0.8 x depth 6 3 x M5 x 0.8 x depth 6 230 230 ( ): With float switch 117 117 60 60 100 100 2 59 63 166 162 73 73 1046
Required screws are as follows: 2 x M5 (End plate: torque = 1.5 Nm) 2 x M5 (SI unit: torque = 1.5 Nm) 4 x M(Valve manifold: refer to valve manifold catalogue) OFF US1 is not present or is below the dropout level (< approx. 17 VDC). Refer to the product catalog or operation manual to obtain more detailed information about outline dimensions.