PSxx-OMT0001CN

[mm] 3 m 3 m 3 m [sec] [sec] [sec] [mm] [mm] [mm] [mm] 5 m 5 m 5 m [sec] [sec] [sec] [mm] [mm] [mm] [mm] [mm] [mm] -19No.PS-OMT0001CN-E 2 () [()][] 1.5 F42.51 m3 m5 m GH641 m3 m5 m 200 kPa ISA3-F ISA3-G 1 m3 m5 m 1 m3 m5 m [mm] [mm] 9 0 10010 ISA3-H 1 m3 m5 m [mm] 29 0 30030 -20No.PS-OMT0001CN-E 2 ISA3-() ISO1179-1 1 2 3 4 5 6 L1 38 76 114 152 190 228 C(4 ) C(6 ) F(G ) H 13

ZSE30/ISE30

A load exceeding the maximum load specification can cause damage to the switch or shorten its operating life span. 3. Do not use a load that generates surge voltage. Although surge protection is installed in the circuit at the output side of the switch, damage may still occur if a surge is applied repeatedly.

MGC

at a constant or low speed or to effect an intermediate stop, just like a hydraulic unit, while using pneumatic equipment such as a valve.

ZSE30A(F)/ISE30A

Pin description 1 2 3 4 DC (+) OUT (2) DC () OUT (1) 1 2 3 4 4 Black 3 Blue 43

Series GS40 Digital Pressure Sensor 1

Model GS40-M5 GS40-01 GS40-02 AV Air/Inert gas Fluid AU 3% F.S.

Series GS40 Digital Pressure Sensor 1

Model GS40-M5 GS40-01 GS40-02 AV Air/Inert gas Fluid AU 3% F.S.

MGC

3 !4 !5 !6 !7 !8 No.

Shock Absorbers and Rate Controls

lrlA |.25N/A r{/A.1 3 .35 t ( l{/A 13.9 or.

70pvpump

Since a large quantity of liquid will be pumped out, use a suitable throttle in the discharge port if problems occur. Note 3) With a low number of operating cycles, even a valve with a small Cv factor can be operated.

PA3000/5000/PAX1000

Since a large quantity of liquid will be pumped out, use a suitable throttle in the discharge port if problems occur. Note 3) With a low number of operating cycles, even a valve with a small Cv factor can be operated.

ITV

If exhausting of this pressure is desired, shut off the power after reducing the set pressure, and discharge the air using a residual pressure exhaust valve, etc. 3. If power to this product is cut off due to a power failure, etc. when it is in a controlled state, output pressure will be retained temporarily.

Process Pump

Connect the solenoid valve lead wires to a 24 VDC power supply. Red is (+) and Black is (). (The PB1013A air-operated type must be equipped with a separate 3-port solenoid valve.) 3. Using a regulator, set the pilot air pressure within the range of 0.2 to 0.7 MPa.

VEX1

When the load factor is 0% (no load), the maximum working speed will be 1.2 times, and when the load factor is 75%, it will be 0.7 times. 5.1-15 VEX3 Construction/Operation Principles [1]2(A)3(R) [3]1(P)2(A) [2] Closed center This is a 3 port switch valve in which the shaft extending from the driving piston opens/closes a pair of poppet valves .

SRP

mounting hole 40 8.5 20 28 72.5 (when set = 75.5) Bleed exhaust hole 6.5 28 41 1.6 Port size A B IN OUT Model Port size D C B A 30 30 23.5 14 M5 x 0.8 SRP111-M5 40 40 22.5 15 Rc 1/8 SRP111-01 C D 3 Series SRP Safety Instructions These safety instructions are intended to prevent a hazardous situation and/or equipment damage.

SRP

mounting hole 40 8.5 20 28 72.5 (when set = 75.5) Bleed exhaust hole 6.5 28 41 1.6 Port size A B IN OUT Model Port size D C B A 30 30 23.5 14 M5 x 0.8 SRP111-M5 40 40 22.5 15 Rc 1/8 SRP111-01 C D 3 Series SRP Safety Instructions These safety instructions are intended to prevent a hazardous situation and/or equipment damage.

Series VCS

1 2 stns. + 3 stns. 2 stns. + 3 stns. x 2 2 stns. x 2 3 stns. x 2 2 stns. x 2 + 3 stns. x 2 2 stns. x 2 + 3 stns. 2 stns. x 1 3 stns. x 3 Note) Manifold bases are composed by connecting 2 station and 3 station bases.

Series VCL

Add a "" in front of the part numbers for solenoid valves, etc. to be mounted. 2 3 4 Class 2 Class 3 Class 4 Enter together in order, counting from station 1 on the D side.

ZSE1/ISE1

NPTF 1/8 Connector type (Lead wire: 0.6 m) T1 C Connector type (Lead wire: 3 m) CL Note) Single mounting style: M5 x 0.8 (female) threaded.

15

CY3B CY3R CY1S CY1S Dynamic moment calculation by mounting type CY1L M1 CY1H Va CY1F Va CYP A M3 M3E y z M1E FE FE m x g m x g Table 3.

Quick Exhaust Valve Series AQ 1

30 to 60C) 1 4 8 3 Note) AQ1500 and AQ1510 are not available. 3 4 Type Port size Symbol 0 5 Type Applicable model Diaphragm Lip AQ2 to AQ5 AQ1 Only Port size Applicable series M5 01 02 03 04 06 M5 x 0.8 AQ1500 AQ1510/2000 AQ2000/3000 AQ3000 1 8 Standard 1 4 0 1 M5 x 0.8 8 3 1 8 Note) AQ150 only 1 2 AQ5000 3 4 Thread type Metric thread (M5) Rc NPT G Nil N F Caution Be sure to read before handling