EX250-SPR_eng

change over switch x10 x1 Address setting switch Grounding terminal (FE) Used for grounding. 7 7 7 1 5 1 3 3 7 3 5 7 SI unit side 3 These safety instructions are intended to prevent hazardous situations and/or equipment damage.

q"s

m I I L I Riqht anqle tvpe 3 m I I j N lWithout cable connector I l L-Bracket Model 7 . l00O tvoe v : 2000 tvoe Pressure [rPa 2 kqf/cm, 3 bar 4 PSI kPa Power supply voltage 0 to 10 VDC Thread type 1/8 (1000 tuoe) 2 1/4 (1000. 2000 tvoe) 3/8 (2000 type) Without bracket I Flat bracket L-bracket World Wide QS\E Support...

Floating Joint: Standard Type JA Series

3-050 4-070 5-080 6-100 8-125 10-125 14-150 18-150 22-150 26-150 30-150 36-150 M3 x 0.5 M4 x 0.7 M5 x 0.8 M6 x 1 M8 x 1.25 M10 x 1.25 M14 x 1.5 M18 x 1.5 M22 x 1.5 M26 x 1.5 M30 x 1.5 M36 x 1.5 180 200 180 200 Caution Maintenance Warning 1.

Speed Controller with Residual Pressure Release Valve with One-touch Fitting Series AS



FE Elbow Type/Universal Type 1

AS321FE AS331FE AS421FE AS431FE Model 8 10 6 8 10 12 12 10 6 8 10 Tubing O.D.

PF2x2.eng

Setting flow chart button (DOWN) Selects the mode or decreases the ON/OFF Set value. 1PH+1PL Blue Blue 3 Non-Reverse output Upper 3 digits Lower 3 digits : Operate only the PF2A20 series.

Industrial Filter

Replacement of the element" on page 9 and 10 for the element replacement procedure. * Confirm cautions on page 3, 4, 5 and 6 for use. 5Replacement of the element 5-1 [Removal of the cover] bracket Clamping position check pin (1) Stop operation (2) Close the valve in order of INL, then, OUT. (3) Release the hexagon plug to reduce the pressure in the filter to zero. (4) Discharge all fluid

Compact Manometer Series PPA 1

G PPA AL 14-12-3 4 Compact Manometer Series PPA PPA100/101/102 How to Order Unit specifications PPA10 0 M Pressure specifications Nil M Option/Case holder With the unit switching function(1) 0.1 to 1 MPa (For high pressure) 101 to 10 kPa (For vacuum) 10 to 100 kPa (For low pressure) 0 1 2 Fixed in SI unit (2) None With PPA-B Nil B Note 1) With unit switching function is not permitted to sell

Compact Manometer Series PPA 1

G PPA AL 14-12-3 4 Compact Manometer Series PPA PPA100/101/102 How to Order Unit specifications PPA10 0 M Pressure specifications Nil M Option/Case holder With the unit switching function(1) 0.1 to 1 MPa (For high pressure) 101 to 10 kPa (For vacuum) 10 to 100 kPa (For low pressure) 0 1 2 Fixed in SI unit (2) None With PPA-B Nil B Note 1) With unit switching function is not permitted to sell

PSxx-OMF0005CN

1. 2. 3. 4

Electric Actuator / Rod Type Dust-tight / Water-jet-proof (IP65 Equivalent / IP67 Equivalent)

Check Model Selection in the Catalog. 2) Pushing force accuracy is 20% (F.S.). 3) The pushing force values for LEY25E is 30% to 50%, for LEYG32E is 30% to 70% and for LEYG40E is 35% To 65%. 4) The speed and force may change depending on the cable length, load and mounting conditions. Furthermore, if the cable length exceeds 5m, then it will decrease by up to 10% for each 5m.

Regulator AR30 to 60

Applicable model AR30 AR40 AR40-06 AR50 AR60 Option Note 4) Note 4) Note 1) AR30P-270AS AR40P-270AS AR40P-270AS AR50P-270AS AR50P-270AS Bracket assembly Note 5) Note 5) AR30P-260S AR40P-260S AR40P-260S Set nut G46-10-02 G36-10-01 G46-10-02 G46-10-02 G46-10-02 Round Square embedded type Round Square embedded type 1MPa Note 2) Note 3) Pressure gauge GC3-10AS GC3-10AS GC3-10AS GC3-10AS GC3

Vacuum Ejector Body Ported Type/Box Type (Built-in Silencer)

(When using the 3-port valve, seal the R-port of the release valve.) Ex.5Supply/Release valve (5-port valve with 3-position)+ Variable throttle 5-port valve with 3-position closed center is used to control the vacuum generation and release. A check valve is installed to the vacuum port to prevent vacuum pressure from being reduced when the supply valve is OFF*.

10% of rated voltageClass B1.5 W(0.06 A)2.5 W(0.1 A)1 W50 dB

Antistatic Tubing TA  Series

(mm) 12 3.2 4 6 8 10 Tubing I.D.

VX21/22/23

8 F 24 VDC 5 G DIN terminal 24 VDC With surge voltage suppressor A B D E H J L M 4 H 100 VAC Size 2 2 1/4 N.C. 7 J 110 VAC Aluminum 4 5 N.O. 3/8 K 200 VAC 7 L 230 VAC 4 8 7 Resin (With bracket) M Conduit terminal 24 VDC With surge voltage suppressor 4 N 100 VAC 10 7 P 110 VAC A B C D E F G H J K L M N 5 Q 200 VAC Size 3 3 N.C. 8 1/4 R 230 VAC 10 (N.C. only) 6 N.O.

Trimmer Auto Switch Series D-
7K/D-R
K

D-RNK 21.1 6 30 2-3.5 46 5 Connector for sensor e-con 3

Speed Controller: Standard Type Series AS Elbow Type (Metal Body) 1

Min. operating pressure 5 to 60C (No freezing) 10 turns 10 turns 8 turns Ambient and fluid temperature Number of needle rotation Hexagonal lock nut With seal, Hexagonal lock nut, Nickel plated Option 181 106 64 29 10 6 3 Weight (g) 20 0.3 1700 26 920 14 460 7 230 3.5 105 1.6 Flow rate /min (ANR) Controlled flow (Free flow) Effective area (mm2) Note 1) Flow rate values are measured at 0.5

Solid State Auto Switch

Output stays ON Display stays OFF 3 Switch failure (3-wire type) Replace the switch. Check if load specification satisfy the formula below. Load ON voltage Change to 3-wire type or reed Auto switch. Reduce the number of switch connected in parallel.

Guide Cylinder

Otherwise, the guide parts has twisted and lead to a malfunction. -10- 10) Mount in locations where maintenance will be easy.

Air Suction Filter

) The left and right brackets are mounted on the air suction filter single unit. -9- 3.