Direct Solenoid The vahs may be ordered from the factory with the D.C. solenoids installed, or they may be converted in the lield.
Note 2) On the AMC220, an R 1/4 fittinng can be attached by removing the drain cock. (It be comes the drain piping type.
If the body is held while tightening bolts, etc., the guide section will be subjected to a large moment, and there may be a loss of precision. DFor connection with a load having an external support/guide mechanism, select an appropriate connection method and perform careful alignment.
-ASD330F-01-08 10-ASD230F-M5-06 2.
UR Edition D Safety Instructions Be sure to read the Handling Precautions for SMC Products (M-E03-3) and Operation Manual before use.
-ASD330F-01-08 10-ASD230F-M5-06 2.
4 Note 1) Cotter pin should be used together with a flat washer.
Max. system presure This pressure is the limit of pressure that can be applied to pipe line. (Line pressure) [The pressure difference in a solenoid valve must be maintained less than the highest operating pressure difference.] 3. Symbol The JIS symbol is ( ): this designates the valve to be normally closed.
Max. system presure This pressure is the limit of pressure that can be applied to pipe line. (Line pressure) [The pressure difference in a solenoid valve must be maintained less than the highest operating pressure difference.] 3. Symbol The JIS symbol is ( ): this designates the valve to be normally closed.
Mount the solenoid so that it will be on the same side as the single solenoid of the Series VZ5000. In the case of base mounting, 2(A) port of 3 port valve should be 2(B) port of manifold base.
An environment where food which will be sold as merchandize, directly touches the fitting components. Installable Splash zone An environment where food which will not be sold as merchandize, directly touches the fitting components. An environment where there is no contact with food.
Note 3) The product can be used in temperatures 14 to 140F (10 to 60C) if there is no risk of water droplets forming and freezing. Refer to page 5 for Precautions on these products.
They can be ordered in lots of 10 pieces. d D Series SY3000 SY5000 SY7000 Part No.
When the cylinder is used as mounted with a single side fixed or free (basic type, flange type), be careful not to apply vibration or impact to the cylinder body. A bending moment will be applied to the cylinder due to the vibration generated at the stroke end, and the cylinder may be damaged.
Positioning should be performed accurately. Especially in the case of small diameter pads. 6. When transporting in an upward direction, factors such as acceleration, wind pressure and impact force must be considered in addition to a workpiece weight.
Leakage amount: 5 cm3/min or less at OFF Can be used with vacuum.
This control is not for synchronizing the position of the main axis and slave axis. 1 Multi-Axis Step Motor Controller JXC73/83/92/93 Series 4-axis operation can be set collectively in one step.
DAuto switch mounting grooves can be covered with resin fastener strips, which adhere tightly to the tube (option) to prevent the entry and accumulation of dirt.
Note) A total of up to 3 supply/exhaust blocks can be mounted. Contact P/A if 4 or more will be mounted. External pilot specification Specified layout: Indicate the wiring specifications on a manifold specification sheet. (Please note that in locations where single solenoid wiring is indicated, it will be impossible to use double or 3 and 4 position valves.)
DAuto switch mounting grooves can be covered with resin fastener strips, which adhere tightly to the tube (option) to prevent the entry and accumulation of dirt.