MGG Furthermore, although it could be impossible to recognize it under 2.5 mA, but there would be no problem only with 1 mA or more in terms of the contact output.
Channel 10 Disable Output will be held last state. 1: Set value shall be set per analogue output range within settable range in the table below.
Do not use in a place where the product could be splashed by oil or chemicals. If the product is to be used in an environment containing oils or chemicals such as coolant or cleaning solvent, even for a short time, it may be adversely affected (damage, malfunction etc.). Do not use the product in an environment where corrosive gases or fluids could be splashed.
pin should be used together with a plain washer.
Select the folder in which the step data is to be saved and save the data. Waveform data file (extension: gpf2) will be prepared. If the waveform condition needs to be checked, it can be displayed on the graph window. Click the Save Image button. Select the folder in which the step data is to be saved and save the data. An Image file (extension: jpg) will be prepared.
If more than the allowable rotating torque is applied, the detent guide will be deformed and there will be a significant loss of rotational accuracy.
Total current for OUT 0 to 7 must be 1 A or less. Total current for OUT 8 to 15 must be 1 A or less.
If a commercially available switching power supply is used, be sure to ground the frame ground (FG) terminal. If the product is connected to the commercially available switching power supply, switching noise will be superimposed and the product specifications will not be satisfied.
1 Be sure to read this before handling the products.
Air pressure and release pressure can be adjusted separately. Release pressure can be adjusted to suit the workpiece.
Be sure to operate the cylinder with the plates on both sides secured. Avoid applications in which the slide table or only one plate is secured. 5. When changing the ports to be used, be sure that unused ports are securely sealed.
Air consumption can also be reduced by controlling the pneumatic valve with a static neutralization completion signal. Note) The pneumatic valve must be separately procured.
Be sure to operate the cylinder with the plates on both sides secured. Avoid applications in which the slide table or only one plate is secured. 5. When changing the ports to be used, be sure that unused ports are securely sealed.
Be sure to operate the cylinder with the plates on both sides secured. Avoid applications in which the slide table or only one plate is secured. 5. When changing the ports to be used, be sure that unused ports are securely sealed.
Be certain to use an air cushion at the end of the cylinder stroke. If this is not done, the tie-rod or piston assembly will be damaged. 1. Be certain to use an air pressure circuit which will apply balancing pressure to both sides of the piston when in a locked stop.
The adapter must be installed by the customer.
Be certain to use an air cushion at the end of the cylinder stroke. If this is not done, the tie-rod or piston assembly will be damaged. 1. Be certain to use an air pressure circuit which will apply balancing pressure to both sides of the piston when in a locked stop.
Avoid applications in which two or more end lock cylinders are synchronized to move one workpiece, as one of the cylinder locks may not be able to release when required. 6. Use a speed controller with meter-out control. Lock cannot be released occasionally by meter-in control. 7. Be sure to operate completely to the cylinder stroke end on the side with the lock.
Air blowing and noise when mounting and removing the plug can be prevented by seal around the plug. Conventional model: Series KK13 One-touch fitting provided type is standardized. With lock mechanism (Semi-standard) Removal by unexpected impact can be prevented. Locked and released position can be maintained by the detent on the sleeve.