HRX-OM-W004 In the latter case, up to 31 products can be connected. Both ends of the communication connection (the end nodes) need to be connected to the higher level computer. The terminal resistance of this product can be set by the operation display panel. Refer to 3.6.2 Setting and checking.
Contact output signal 4 to 6 can be used to change the signal type. 2.4.1 Contact output signal 1 to 3 The contact type of contact output signals 1 to 3 can be set.
The needle on the side that is not used should be left fully opened. Note) The operating principle for AL20 to 60 types is different from that of AL10 type.
Also, set the tightening torque to be 0.05 to 0.15 Nm.
Contact output signal 4 to 6 can be used to change the signal type. 2.4.1 Contact output signal 1 to 3 The contact type of contact output signals 1 to 3 can be set.
As a rule, they should be tightened 2 to 3 turns with a tool after first tightening by hand.
{Rc3/4} FGH200-06 {Rc3/4} FGH300-06 {Rc3/4} 0.05 0.05 0.05 Pressure drop (MPa) Pressure drop (MPa) Pressure drop (MPa) 0.01 0.01 0.01 0.005 0.005 0.005 0.001 10 30 50 70 100 0.001 10 30 50 70 100 0.001 10 30 50 70 100 Flow rate (L/min) Flow rate (L/min) Flow rate (L/min) FGH100-10 {Rc1} FGH200-10 {Rc1} FGH300-10 {Rc1} 0.05 0.05 0.05 Pressure drop (MPa) Pressure drop (MPa) Pressure drop (
When the pressure in one chamber of the cylinder must be boosted. Operating press: 0.5 MPa Bore size: 100 Output: 3850 N Operating press: 0.8 MPa Bore size: 80 Output: 3850 N Equivalent output force 6. When the hydraulic pressure of an air-hydro unit must be raised. 7. When the pressure must be raised in an explosion-proof environment. 8.
Equipment which may generate electromagnetic interference or whose function may be compromised by electromagnetic interference is required to be immune to electromagnetic affects (EMS/immunity) without emitting excessive electromagnetic affects (EMI/emission).
Valves can be ordered as normally open or normally closed and pilot actuation can be factory preset.
This should be handled by a person in charge of safety training. All personnel who work with or around the product should have sufficient knowledge about the dangers inherent to the product and be trained in safety measures.
When the product is to be removed, confirm that the safety measures as 2.
The fittings may be damaged if they are used in the above manner. (2) The tubing bending radius in the vicinity of the fitting should be at least the minimum bending radius of the tubing. If the bending radius is less than the minimum value, fittings may be damaged, or tubing may crack or be crushed.
This regulator cannot be used as a check type regulator to be installed between a solenoid valve and an actuator. It can cause breakdown and malfunction. 7.
from the equipment and required cleanliness may not be obtained.
from the equipment and required cleanliness may not be obtained.
from the equipment and required cleanliness may not be obtained.
Should be used as the air supply for driving pilot type and metal type solenoid valves.
Should be used as the air supply for driving pilot type and metal type solenoid valves.