Magnetically Coupled Rodless Cylinder

Note 1) This cylinder cannot perform an intermediate stop using an air pressure circuit in vertical operation. In this case, an intermediate stop can be performed only by using an external stopper, etc. Note 2) Made-to-order products should be considered, too, depending on an operating environment, etc.

Air Slide Table

40 40 40 40 40 Stroke 50 50 50 50 50 50 75 75 75 75 75 100 100 100 100 125 125 125 Page 11 150 150 Low thrust with high rigidity type MXQB 10 10 10 10 10 20 20 20 20 20 30 30 30 30 30 40 40 40 40 40 Stroke 50 50 50 50 50 75 75 75 75 75 100 100 100 100 125 125 125 Page 53 150 150 Single side-ported type MXQC 10 10 20 20 30 30 Stroke 40 40 50 50 75 75 Page 67 100 Height interchangeable type

ZP

50 +25 +25 +40 +49.9 +51.4 +40 + 9.9 +51.4 13-11-110 New New Vacuum Pad More shapes and sizes of pads.

Table of Contents

(Refer to page 13-2-40 for How to Order.) Combination Symbol: K2 Combination Symbol: K7 An N.C. solenoid valve is used as the supply valve. Also, an external 2 port valve (vacuum valve) must be provided to serve as the vacuum release valve. An air operated N.O. valve is used as the supply valve. An N.C. solenoid valve is used for the vacuum release valve.

ZP

Male thread Female thread 40 40 6 tube 06 50 50 8 tube 08 M5 x 0.8 A5 Pad type (Refer to Table (1) for applications.)

Mechanically Jointed Rodless Cylinder Series MY1

Select an applicable one referring to the table below. Nil None With side seal Note) Cylinders with side seal are available for 16 to 40. Nil K 25, 32, 40, 50, 63 Note) S is available when stroke adjusting units are A and L.

AC Servo Motor Driver (Network card type ）

642.7 Setting range: 1 to 40 1600 PA10 INP In-position range Set an in-position range per command pulse.

Table of Contents

If the workpiece gripping point goes beyond the range limits, this will have an adverse effect on the life of the air gripper. 0.7 MPa 0.6 MPa, 0.7 MPa 0.6 MPa, 0.7 MPa 0.3 MPa 0.3 MPa 40 20 0.4 MPa 0.4 MPa 0.5 MPa 0.5 MPa 20 10 0 10 20 30 40 50 0 20 40 60 80 100 Gripping point L (mm) Gripping point L (mm) MHZ2-40 MHZ2-16/11-MHZ2-16 120 Pressure 0.2 MPa Pressure 0.2 MPa 60 0.6 MPa 0.6 MPa

AC Servo Motor Driver (Pulse input type/Positioning type ）

642.7 Setting range: 1 to 40 PA10 INP In-position range Set an in-position range per command pulse.

Air Cylinder Series CM2

4 4 8 7 9 8 37 107 19 10 9 34 30 60 75 30 14 10 32 32 52 36 108 116 118 40 25 40 55 20 21 Up to 300 Up to 400 6.8 3.2 102 131 133 142 to 400 Up to 300 Up to 300 4 4 8 7 9 9 41 111 19 10 9 40 37 60 75 30 14 10 40 40 60 40 112 120 122 47 28 40 55 20 25 6.8 3.2 102 135 Up to 300 Up to 450 137 146 to 450 Up to 300 Up to 300 4 4 8 7 9 9 41 113 19 10 9 40 37 60 75 30 14 10 40 40 60 40 114 122

Compact Cylinder

D 35 40 40 45 40 45 40 45 40 45 45 50 55 65 C Mounting bolt part no.

Compact Hydraulic Cylinder

2 (n 4) 2 (n 4) 2 (n 4) 2 D-M9m/M9mW 20 + 40 85 + 40 95 + 40 100 + 40 105 + 40 115 + 40 "n" pcs.

Electric Actuator/Slider Type

16 6 40 46 25 9.5 48 57.5 32 16 63 79 40 0 68 68 Step motor, Stroke: 300 mm Step motor Top surface of table and motor are level.

CY1

0 60 80 20 40 0 60 20 40 0 60 Moment ( Nm) Moment ( Nm) Moment ( Nm) Intermediate Stops Vertical operation 1) Intermediate stopping of load with an external stopper, etc.

Table of Contents

A cabtire cable with an O.D. 6 to 12 mm is applicable. Tighten each part with an appropriate tightening torque shown below.

Basic type / Direct mount type Series CY3B/CY3R

32 CY1S40L 0.40 CY1S32L 18.2 0.40 CY1S CY1S40H 47.0 0.65 40 CY1S40L 29.0 0.40 CY1L 2) Intermediate stopping of load with an air pressure circuit When stopping a load using an air pressure circuit, operate at or below the kinetic energy shown in the table below.

Pneumatics Best 2 Auto Switch Guide Applicable Cylinder Series 1 CDA2-X1184 MDB-X1184 CDQ2-XB14 CDG5·S CDJ5·S Cylinder series CDJP2 MDU-Z CDQM CDQS HYDQ CDJ2 CDM2 CDM3 MDB1 HYDB CDG1 CDG3 CDQ2 CDUJ CDA2 CDS1 CDS2 MDB RDQ CQU CDU ø125 to ø200 ø125 to ø160

, 50 40 to 100 40 to 100 40 to 100 12 to 100 20 to 80 32 to 63 25 to 40 32 to 63 32 to 63 20 to 40 20 to 40 20 to 40 20 to 40 40 to 63 40 to 63 16, 20 40, 50 12, 20 12, 20 10, 16 10, 16 Bore size 12 D-H7 D-H7C D-H7BAL D-H7NF D-H7W D-G5/K5 D-G5BAL D-G59F D-G5NTL D-G5W/K59W D-G39/K39 D-G39A/K39A D-F7/J7 D-J79C D-F79F D-F7BAL D-F7BAVL D-F7V D-F7NTL D-F7W (V) D-F5/J5 D-F5BAL D-F5W/J59W D-F59F

NCQ2/CQ2

D 35 40 40 45 40 45 40 45 40 45 45 50 55 65 C Mounting bolt part no.

Table of Contents

40 50 50 55 55 65 85 , Misc.

Compact Rotary Actuator Series CRQ2

, 15 10, 15 20, 30, 40 10, 15, 20, 30, 40 10, 15, 20, 30, 40 Change in angle adjustable range 0 to 100 Change in angle adjustable range 90 to 190 Chart 5.