SMC Corporation of America
Elite Part Number Search
Search Results "CDNA2D100TN-100-D-M9PSAPC"

D Shows how precisely the pressure can be indicated or set by the degital Pressure switch. When 1 digit = 1 kPa, the pressure is given with an increment of Digit (Min. setting unit) 1 kPa, e.g., 1, 2, 3,, 99, 100. E Energy saving automatic control Indicate that the vacuum pressure during adsorption is monitored and ON and OFF of the ejector is automatically controlled.

D Shows how precisely the pressure can be indicated or set by the digital Pressure switch. When 1 digit = 1 kPa, the pressure is given with an increment Digit (Min. setting unit) of 1 kPa, e.g., 1, 2, 3,, 99, 100. E Energy saving automatic control Indicate that the vacuum pressure during adsorption is monitored and ON and OFF of the ejector is automatically controlled.

Applicable stroke table )Standard Stroke Manufacturable stroke range [mm] Model 600 500 400 300 200 100 900 700 800 1000 LEFS16 LEFS25 LEFS32 LEFS40 ) ) ) ) ) ) ) ) ) ) ) ) ) ) ) 100 to 400 100 to 600 100 to 800 200 to 1000 ) ) ) ) ) ) ) ) ) ) ) ) Consult with SMC for non-standard strokes as they are produced as special orders.

Fieldbus interface connector layout 6 RUN L/A IN L/A OUT PWR(V) PWR BUS OUT: M12 4-pole Socket D-coded 1 No.

Valve manifold Accessories Side D NOTE (SI unit side) Replacement of the SI unit Remove the M3 hexagon screws from the SI unit and release the SI unit from the valve manifold. Replace the SI unit.

Refer to 4.3.2 Setting and checking,5.3.2 Setting and checking. 2 2 R D R D 3 3 S D S D 5 5 S G S G Master This product Do not connect any wire to other PIN numbers.

Refer to 4.3.2 Setting and checking,5.3.2 Setting and checking. 2 2 R D R D 3 3 S D S D 5 5 S G S G Master This product Fig 3.3-2 RS-232C connector connection 3.3 Connected explanation HRSH Series 3-2 HRX-OM-R028 Chapter 4 MODBUS communication function Chapter 4 MODBUS communication function MODBUS protocol is a communication protocol developed by Modicon.

Table 3-6 RTU mode message frame a) Start b) Device Address c) Function d) Data e) Checksum (CRC) f) End T1-T2-T3-T4 XX XX XX XX XX XX T1-T2-T3-T4 a) Start In Modbus RTU mode, message frames are separated by a silent interval (non-communication time).

AL4 at 1 sec. and Cooling Output is 100 70%, the output will be 0.7 sec. ON and 0.3 sec.

D-M9-5 () D-M9N-5 D-M9P-5 3 NPN PNP IC PLC DC51224V(4.528V) 10mA DC28V 40mA 10mA 0.8V (40mA 2V ) DC24V 100A ON CE RoHS D-M9-5 M2.54L 16 - 5. 5-1. 1. () 2. 3. 4. 1. 5-2. 1. 2. 3. 4. Nm JMHZ2-16D M3x0.5 0.59 17 - MOTOMAN-HC10 M6x12 6.3Nm 18 - M6x23 6.3 Nm M4x10 1.0Nm 19 - M8 M8 M8-MOLEX S1 S2 M4x8 1.0Nm 20 - (M4x6) (M4x6) 1.0Nm P175-2.

Here, : Deformation ratio (%) d: Tubing diameter (mm) L: Measured length (mm) D: Mandrel diameter (mm) (Twice against the minimum bending radius) Test temperature: 205oC Relative humidity: 655 (%) 100 2d D L 1 = Tube deformation ratio at the minimum bending radius (3) Check the model, type and size before installation.

Envi ronm ent Low er t han 5 D o not use under f ol l ow i ng envi ronm ent . D o not use under f ol l ow i ng condi t i ons. W ARN I N G /H I N TS O N CO RRECT U SE Vi brat i on, I m pact Envi ronm ent H i gher t han /M ERI TS 60

Exterior dimensions Grommet: G Face seal fitting / compression fitting Terminal part Flat terminal connector 250 Series Model A B Bs C D E F L M P [inch] Grommet: G Grommet: GS Conduit: C Fast on: F DIN terminal: D Terminal: T G H G H G H G H G H J G H J XSA1-2S 22 55 24 63 30 8.5 20 3 8 27 53.5 30 40 47.5 47.5 23 53.5 64.5 45.5 52.5 99.5 47.5 68.5 -2V 50 1/4 XSA2-2S 63 31.5 73.5 63 32.5

Model Model L D L D TCU0805-1-N-X6 TCU0425-1-N-X6 1 N x 8 31 3 to 90 L x 5.2 + 200 N x 4 18 1 3 to 90 L x 5.9 + 200 8 5 TCU0805-2-N-X6 TCU0425-2-N-X6 2 42 L x 3 + 200 3 to 40 N x 16 L x 4.4 + 200 N x 8 2 3 to 90 4 2.5 28 TCU1065-1-N-X6 TCU0425-3-N-X6 52 1 3 to 45 L x 5 + 200 N x 10 N x 12 3 3 to 63 L x 2.9 + 200 28 10 6.5 TCU1065-2-N-X6 TCU0604-1-N-X6 2 3 to 35 52 L x 3 + 200 N x 20 L x 5.3

4 1 4 VND50D-32F VND60D-40F VND70D-50F 130 150 180 211.5 227 251 135 140 155 135 147 163.5 20 24 24 100 105 120 36 42 54 12 12 14 17-4-41 6 Series VND Precautions Be sure to read before handling.

D-R Note 3) Options for 2, 6, and 8 can not be specified at the same time. (Ex.) 68 Note 4) Symbols 9, D, J can not be specified at the same time. (Ex.) 9-D-J Note 5) For products with auto drain, either symbol D or J cannot be specified at the same time. 1 Indicate the required filtration rate after the symbol 1. Ex.)

VDC V V V V 6 12 VDC V V V V + G Grommet (Lead wire length: 300 mm) V V V V D Type D (DIN terminal/With connector) V V V V Y Type Y (DIN terminal/With connector)*2 V V V V DO Type D (DIN terminal/Without connector) V V V V YO Type Y (DIN terminal/Without connector) V V V V + y e Electrical entry u f Light/ surge voltage suppressor Nil None V V V V Z With light/surge voltage suppressor v*

VEX312 VEX332 1 100 VAC (50/60 Hz) 2 200 VAC (50/60 Hz) 3 110 VAC (50/60 Hz) 4 220 VAC (50/60 Hz) 5 24 VDC 6 12 VDC V 6 VDC S 5 VDC R 3 VDC * DC specification of type D and DO is only available with 12 and 24 VDC. 32 02 1/4 03 3/8 04 1/2 Foot bracket ( VEX312 and VEX332 only) F N* Pilot exhaust (PE) silencer Electrical entry Grommet L plug connector M plug connector DIN terminal G: Lead

Valve size 1: VN1-A16 (with thread) Valve sizes 2 to 4: VN-16 Threaded port only Thread type Nil F N T Rc G NPT NPTF 2 to 4 VNB 15A Air operated 2 0 1 A External pilot solenoid 2 VNB 15A 1 1 1 A T CE-compliant Nil Q CE-compliant Valve type Port size Valve size Rated voltage Electrical entry: D or DZ only Symbol Manual override Port size Rc 1 2 3 Note 2) 100 VAC 50/60 Hz 200 VAC 50/60 Hz