C85 Check the detecting position again and tighten the mounting screw to fix the auto switch definitely (the tightening torque of M3 screw should be about 50 to 70 N/cm). 5. Modification of the detecting position should be made following step #3. C76 C85 C95 Auto Switch Mounting Band Part No.
Replaceable Rod Seal CM2 CG1 Rod seal can be quickly replaced, greatly extending the cylinder life. (C85 20, 25).
This calculation can be easily made using the SMC Pneumatics CAD System.
Grease pack part number : GR-S-010 Note 2) A switch spacer, as specified in the table above will be required if an auto switch is mounted afterward.
Auto switch u The detection position can be changed under the conditions in step t.
There may be the case it will vary substantially depending on an ambient environment.
Two styles of guide rod bearings to accommodate your application Slide bearing For heavy loads Ball bushing bearing For highly accurate and smooth operation Auto switch can be mounted. A shock absorber can be installed (option). Can be mounted on two sides. Mounting from the bottom side Mounting from the upper side Guide of high rigidity Adjusting bolt with bumper is standard.
Attachments should be designed to be as light and short as possible. Gripping point (1) A long or heavy attachment increases the inertia force required to open or close the fingers.
The MGPKFM16-30 should be selected.
The load should be applied to the piston rod in an axial direction.
The load should be applied to the piston rod in an axial direction.
Fluids which corrode, det eriorate or swell the filter and element material cannot be used.
Note 1) No freezing Note 2) This product cannot be used in water.
Two auto switches can be mounted even with the minimum 5 stroke.
If tightening plugs on the top mounting port with more than the proper tightening torque, plugs will be screwed much deeply and air passage will be squeezed.
Each setting and function should be operated by trained and experienced operator.
Select the body and sealing materials that best suit the fluid to be used.
Depending on the system configuration selected, the specified speed may not be satisfied. Other Caution This product should not be used as a stopper. Plate Shim ring (prepared by user) Workpiece 13 JMGP Series Specific Product Precautions 2 Be sure to read this before handling the products. Refer to the back cover for Safety Instructions.