MGG Do not use in a place where the product could be splashed by oil or chemicals. If the product is to be used in an environment containing oils or chemicals such as coolant or cleaning solvent, even for a short time, it may be adversely affected (damage, malfunction etc.). Do not use the product in an environment where corrosive gases or fluids could be splashed.
pin should be used together with a plain washer.
Select the folder in which the step data is to be saved and save the data. Waveform data file (extension: gpf2) will be prepared. If the waveform condition needs to be checked, it can be displayed on the graph window. Click the Save Image button. Select the folder in which the step data is to be saved and save the data. An Image file (extension: jpg) will be prepared.
If more than the allowable rotating torque is applied, the detent guide will be deformed and there will be a significant loss of rotational accuracy.
1 Be sure to read this before handling the products.
Air consumption can also be reduced by controlling the pneumatic valve with a static neutralization completion signal. Note) The pneumatic valve must be separately procured.
Be sure to operate the cylinder with the plates on both sides secured. Avoid applications in which the slide table or only one plate is secured. 5. When changing the ports to be used, be sure that unused ports are securely sealed.
Be sure to operate the cylinder with the plates on both sides secured. Avoid applications in which the slide table or only one plate is secured. 5. When changing the ports to be used, be sure that unused ports are securely sealed.
Be sure to operate the cylinder with the plates on both sides secured. Avoid applications in which the slide table or only one plate is secured. 5. When changing the ports to be used, be sure that unused ports are securely sealed.
Be certain to use an air cushion at the end of the cylinder stroke. If this is not done, the tie-rod or piston assembly will be damaged. 1. Be certain to use an air pressure circuit which will apply balancing pressure to both sides of the piston when in a locked stop.
After tightening by hand, the barb fitting type should be tightened by an additional 1/4 rotation using an appropriate wrench. 2. After tightening by hand, the barb elbow type should be tightened by an additional 1/2 rotation using an appropriate wrench. 2) M5 1. After tightening by hand, the barb fitting type should be tightened by an additional 1/6 rotation using a suitable tool. 2.
Note) Manifold gasket SYJ3000-14-2 can be used with the following manifold bases.
These can be ordered using the order number for each bore size.
These can be ordered using the order number for each bore size.
When In the exhaust posiiion, the vahre may be padlock secured. Prevents accidental start-ups whil personnl ate cleanlng or serviclng equipment. operated valve can be used to The supply/exhaust status of the air flo$r can be verified al a glance in the indicating windour.
N373 Check Valve with One-touch Fitting AKH/AKB Series Bushing Type Can be used in applications with splashing coolant and spatter, etc.
Avoid applications in which two or more end lock cylinders are synchronized to move one workpiece, as one of the cylinder locks may not be able to release when required. 6. Use a speed controller with meter-out control. Lock cannot be released occasionally by meter-in control. 7. Be sure to operate completely to the cylinder stroke end on the side with the lock.
The instruction manual should be carefully read and fully understood before the product is installed and operated. Also, the manual should be kept where it can be easily referred to at any time. 2. Allow space for maintenance. Allow the space necessary for maintenance and inspections. 3. Tighten screws with the proper tightening torque.
The load should be applied to the piston rod in an axial direction.