IS3000

Pneumatic Pressure Switch Series IS3000 Model Can be used for micro load, around 10 mA e.g. relays, programmable controllers, etc. Model Piping method Rc 1/4 thread Gasket piping Rc 1/4 thread Gasket piping Micro switch type Min. applicable load IS3000-02 IS3100 IS3010-02 IS3110 Standard 5 VDC 160 mA Micro load 5 VDC 1 mA Easy electrical wiring Wide space for wiring.

IS3000

Light ass'y for 24 VDC has 3 mA of current leakage.

Ionizer Nozzle type IZN10 Series IZS

or less Connected to +24 VDC (ON voltage: Between +19 V and power supply voltage, OFF voltage: 0.6 V or less) Current consumption: 5 mA or less Max. load current: 40 mA Residual voltage: 1 V or less (load current at 40 mA) Max. applied voltage: 28 VDC Connected to 0 V (ON voltage: 0.1 V or less, OFF voltage: 19 V or more) Current consumption: 5 mA or less Discharge stop signal Reset signal

ZQ

) 100 VAC 0.5 VA (5 mA) Power consumption 0.65 VA (5.9 mA) 110 VAC 0.55 VA (5 mA) (current value) 1.2 VA (6 mA) 200 VAC 1.0 VA (5 mA) 1.3 VA (5.9 mA) 220 VAC 1.1 VA (5 mA) L plug connector Grommet Grommet L plug connector With light/surge voltage suppressor L plug connector (With light/surge voltage suppressor) ( ) Electrical entry With light/surge voltage suppressor Vacuum Pressure Switch

AC Servo Motor Driver (MECHATROLINK-III type)

Do not short-circuit these terminals. [1] Main circuit power input terminals, L1, L2 and Control power input terminals, L1, L2: Connect the 200VAC external power supply to the power supply. Refer to the power supply specification for the size of the acceptable electric wire. [2] Connect the motor cable (U, V, W) to the servomotor connection terminals (U, V, W).

HRX-OM-Z002

HRLE050 200V N L HRLE090 200V L3 L1 L2 Fig. 3-12 Cable wiring (200V) 3.3 Installation Procedure HRLE Series 3-16 HRX-OM-Z002 Chapter 3 Transport and Set Up 400V L1 L2 L3 Fig. 3-13 Cable wiring (400V) HRLE Series 3.3Installation Procedure 3-17 HRX-OM-Z002 Chapter 3 Transport and Set Up 3.3.4 Preparation and wiring of communication cable Be sure to turn OFF the breaker of the facility power

Nozzle Type Ionizer

or less Discharge stop signal Connected to 0 V Voltage range: 5 VDC or less Current consumption: 5 mA or less Connected to +24 V Voltage range: 19 VDC to power supply voltage Current consumption: 5 mA or less Reset signal Input signal External switch signal 1 External switch signal 2 Discharge signal Max. load current: 40 mA Residual voltage: 1 V or less (Load current at 40 mA) Max. applied

e

LXP LXP Mass Electrical Specifications LXS LXS Unit: kg Actuator Unit 24 VDC 10% Rated current 2.5 A (Max. 5 A: 2 s or less) at 24 VDC 24 VDC 10% 30 mA at 24 VDC and Output load capacity 6 mA or less at 24 VDC/1 circuit (Photo coupler input) 30 VDC or less, 20 mA or less/1 circuit (Open drain output) Emergency stop, Output deviation, Power supply deviation, Driving deviation, Temperature

Parallel Style Air Gripper: Wide Type Series MHL2

Model/Stroke Width at closing (mm) Width at opening (mm) Max. operating frequency Opening/Closing stroke (mm) Mass (g) Bore size (mm) Model (L1) (L2) (L2-L1) c.p.m MHL2-10D MHL2-10D1 MHL2-10D2 MHL2-16D MHL2-16D1 MHL2-16D2 MHL2-20D MHL2-20D1 MHL2-20D2 MHL2-25D MHL2-25D1 MHL2-25D2 MHL2-32D MHL2-32D1 MHL2-32D2 MHL2-40D MHL2-40D1 MHL2-40D2 60 20 56 76 280 40 78 118 345 10 40 60 96 156 425 30

Compact Vacuum Ejector Series ZQ

Power consumption 110 V AC 0.65VA (5.9mA) 0.55 VA (5 mA) (current value) 200 V AC 1.2VA (6mA) 1.0 VA (5 mA) 220 V AC 1.3VA (5.9mA) 1.1 VA (5 mA) Grommet Grommet L plug connector L plug connector (With indicator light and surge) voltage suppressor L plug connector (With indicator light and surge voltage suppressor) Electrical entry With indicator light and surge voltage suppressor Vacuum

How to Order Series ZM Vacuum Ejector With Valve and Switch For details about certified products conforming to international standards, visit us at www.smcworld.com. 1

3 rotations 200 degrees 200 degrees 25 mA or less (When 24 VDC is ON) 16 mA 0.5 MPa 5 to 20 mA Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com 0.2 MPa When using ejector system, instantaneous pressure up to 0.5 MPa will not damage the switch.

Electronic Pressure Switch Series (Separate Type)

rest IP40 IP40 Enclosure Display calibration function Anti-chattering function Peak hold Bottom hold Panel mounting possible Selectable pressure unit Auto shift function Auto preset function Note Page 16-3-33 16-3-1 16-1-3 3 Electronic Pressure Switch Series (Self-contained Type) Model Selection Table Self-contained Type ZSE2 ISE2 ZSP1 PS1000 PS1100 ISA2 ZSE3 ISE3 ZSE1 ISE1 ZSE30 ISE30 ISE70

70pvpump

Fixed 0.5 kPa 0.01 mm or less Hysteresis NPN/PNP open collector 1-5 V, 4-20 mA Analog output NPN/PNP open collector Analog output NPN open collector Analog output NPN/PNP open collector Analog output 1 setup NPN/PNP open collector PNP open collector NPN/PNP open collector Analog output NPN/PNP open collector NPN/PNP open collector NPN open collector 2-wire type Output Display (Resolution)

3 Port Solenoid Valve Rubber Seal Series SY100 1

1 3 Port Solenoid Valve Rubber Seal Series SY100 Low power consumption: 0.5 W (Standard, Without indicator light) (Current draw: 21 mA at 24 VDC) V100 Body width: 10 mm Large flow type: 0.75 W (Current draw: 31 mA at 24 VDC) SY [Energy saving type [0.22 W] is available, too. For details, refer to catalog on page 4-3-15.] [Low wattage [0.45 W] is available, too.

3 Port Solenoid Valve Rubber Seal Series SY100

3 Port Solenoid Valve Rubber Seal Series SY100 Low power consumption: 0.5 W (Standard, Without indicator light) (Current draw: 21 mA at 24 VDC) V100 Body width: 10 mm Large flow type: 0.75 W (Current draw: 31 mA at 24 VDC) SY [Energy saving type [0.22 W] is available, too. For details, refer to catalog on page 4-3-15.] [Low wattage [0.45 W] is available, too.

HRX-OM-X071

no (M ma mTNN ALNN Alarm number (Alarm number maximum FLOW / / / PUmP Pump output setting (%) 900 Displays only when the alam is generated.

Non-rotating Double Double Power Power Cylinder Cylinder (without Series MGZ Series MGZR non-rotating mechanism)

Model Bolt Proper tightening torque N.m L1 MGZ/MGZR20 MGZ/MGZR25 MGZ/MGZR32 MGZ/MGZR40 MGZ/MGZR50 MGZ/MGZR63 MGZ/MGZR80 L2 11 11 16 16 16 16 20 10 10 12 12 15 15 23 2.5 to 3.1 2.5 to 3.1 4.1 to 6.4 4.1 to 6.4 8.8 to 13.8 8.8 to 13.8 30.4 to 47.5 M5 x 0.8 M5 x 0.8 M6 x 1 M6 x 1 M8 x 1.25 M8 x 1.25 M12 x 1.75 L2 L1 2.

3 Port Solenoid Valve/

(Load resistance) 5 VDC, 5 mA (Load resistance) Max. voltage 24 VDC Max. load current 50 mA Max. load inductance 0.5 H Insulation voltage 300 V 600 V Protection against electric shock Class II (EN60947-5-1: 2004) 4 VP500/700-X536, X538, X555 Symbols Safety limit switch Made by OMRON Terminal/Pin Numbers (Built-in switch 2N.C.)

3 Port Solenoid Valve/

(Load resistance) 5 VDC, 5 mA (Load resistance) Power consumption 2.2 W Max. voltage 24 VDC Max. load current 50 mA Suppressor Diode Max. load inductance 0.5 H Indicator LED Insulation voltage 300 V 600 V Protection against electric shock Class II (EN60947-5-1: 2004) 20 VG342-X87 Symbols Safety limit switch Made by OMRON Symbol Pin Numbers (Built-in switch 2N.C.)

SX

L1 L2 L3 L4 160.5 173 185.5 185.5 198 210.5 223 235.5 M3 Terminal screw A: Orange B: Green 150 162.5 175 175 187.5 200 212.5 225 129 139.5 150 160.5 171 181.5 192 202.5 15.5 16.5 17.5 12.5 13.5 14.5 15.5 16.5 (Rail mounting hole pitch 12.5) Stations n 10 stations 11 12 13 14 15 16 17 stations 248 248 260.5 273 285.5 298 310.5 310.5 L1 L2 L3 L4 237.5 237.5 250 262.5 275 287.5 300 300 213 223.5