IDX-OM-W028

Locations where ambient temperature is beyond following range: On-stream: 2 ~ 40oC Storage: 0 ~ 50oC (when there is no drain water inside of the piping) Locations where temperature changes rapidly.

SI unit for CC-Link

(Figure b) : Bit status "0" and "1" on a data corresponds solenoid valve status ON and OFF (0: OFF, 1: ON), and output number starts at zero from LSB (least significant bit). -15No.EX-OMO0007-E Troubleshooting and Maintenance Troubleshooting Chart Applicable SI unit: EX180-SMJ3/5 When any malfunction is observed, perform the following troubleshooting.

LEYx-OMZ0015

/size 750W80 Type of Motor AC servo motor (100/200VAC) Encoder Absolute 22bit encoder (Resolution: 4194304 p/rev) (Driver type: LECSC-T) Absolute 18bit encoder (Resolution: 262144 p/rev) Power consumption [W] Note 10) 1,100 (Maximum power) Type Note 11) Non-magnetizing lock specifications Lock unit Holding force [N] 5,700 3,400 1,200 Power consumption [W] at 20 10 Rated voltage [V] DC24 0-

ITV2-OM0095

(Tightening torque 0.6 to 0.8Nm) Dipswitch ON 1 2 3 4 5 6 7 8 9 10 Enable or disable of Dip switch MAC ID Baud rate HOLD/CLEAR Setting at the time of shipment 1 2 3 4 5 6 7 8 9 10 Node address: 0 Baud rate: 125kbps Hold/Clear: Clear Dip switch: enable 8 - Setting of MAC ID MAC ID 1 2 3 4 5 6 0 OFF OFF OFF OFF OFF OFF 1 OFF OFF OFF OFF OFF ON 2 OFF OFF OFF OFF ON OFF : : : : : : : 62 ON ON

ITV2-OM00114

When bit data (RY0F) is 0, it is set immediately before communication abnormality. Setting of terminating resistor This switch is selected to terminating resistor enable or disable.

MPC

100-DCN709SN Part Numbers P398020-501-3 P398020-500-3 Input Type 0 ~ 10V 0 ~ 10V 4 ~ 20mA 4 ~ 20mA Bore 25mm 40mm 25mm 40mm Stroke 50mm 100mm 50mm 100mm Type Straight type M12 connector Right angle type M12 connector Working Principle Linear displacement sensor gives feedback signal to controller.

Speed Controller: Standard Type Series AS Elbow Type (Metal Body) 1

(N specifications) How to Order AS4200-04 AS3200-03 01 S AS 2 2 0 0 AS2200-02 AS2200-01 Option Body size AS1200-M5 None With seal Nil 1 2 3 4 M3, M5 standard S K N 1 8 1 4 , standard standard standard AS1400-M3 Hexagonal lock nut 8 3 Electroless nickel plated 2 1 If more than one option is required, write option part numbers in the order of S, K, N.

ARJ310

0 !

AMR3000 to 6000

Refer to p.0-26 and 0-27 for Safety Instructions and common precautions on the products mentioned in this catalog, and refer to p.1.0-1 and 1.0-2 for precautions on every series. Selection Warning qThe residual secondary pressure cannot be released by releasing the supply pressure. To release the residual pressure, contact SMC.

IDU/IDF

Dew point conversion chart 60 50 40 30 Pressure dew point C 20 10 1.5MPa 1.3MPa 1.1MPa 0.9MPa 0.7MPa 0.5MPa 0.3MPa 0.1MPa Atmospheric pressure 0 10 20 30 40 50 60 50 60 40 30 20 10 0 10 20 30 Atmospheric pressure dew point C 25 Series IDU/IDF Safety Instructions These safety instructions are intended to prevent a hazardous situation and/or equipment damage.

Stainless Steel Heat

x 3 x 60 = 2736g/h. 6 7 8 3 1 2 3 4 5 Dew point conversion chart 60 50 40 30 Pressure dew point C 20 10 1.5MPa 1.3MPa 1.1MPa 0.9MPa 0.7MPa 0.5MPa 0.3MPa 0.1MPa Atmospheric pressure 0 -40 -30 -20 -10 -60 -50 -60 -50 -40 -30 -20 -10 0 10 20 30 Atmospheric pressure dew point C 8 Series IDUS/IDFS Safety Instructions These safety instructions are intended to prevent a hazardous situation and/

MXU

0 !1 !2 !3 !8 !9 @0 @1 @2 @3 D-9 Hard anodized Oil impregnated Oil-impregnated sintered alloy High carbon chrome bearing steel High carbon chrome bearing steel Carbon tool steel Carbon steel Phosphate coated 8-3-9 10 Series MXU Proper Auto Switch Mounting Position (Detection at stroke end) and Its Mounting Height D-A9 D-M9 D-F9W ( ): Denotes the values of D-A93.

3 Port Direct Operated Solenoid Valve Metal Seal, Body Ported/Base Mounted 1

Fluid Air/Inert gas 0 to 1.0 MPa Operating pressure range SY Proof pressure 1.5 MPa 20 to 60C (No freezing) Ambient and fluid temperature SYJ Any given port can accept high or low pressure supply without affecting the system life or operation. No-lubrication and dry-air operation possible. Response time (1) 10 ms or less (AC), 45 ms or less (DC) 1,500 c.p.m. (AC), 180 c.p.m.

VPA4

Ambient and fluid temperature (C) 0 to 60 Lubrication (1) Required (Use turbine oil Class 1 ISO VG32.) Mounting orientation Free Impact/Vibration resistance (m/s2) (2) 150/50 Note 1) Use turbine oil Class 1 (ISO VG32).

VHK

Flame resistant PBT (UL standard V-0) Flame resistant type Cover Flame resistant CR Knob: 2 port valve: Gray 3 port valve: Blue 2/3 port valve: Red (Option) Cam ring POM POM Stem Flame resistant CR (UL standard V-0) For flame resistant type with cover only Spring guide 3(R) Exhaust 3(R) Exhaust Stainless steel Spring NBR Packing, O-ring, Valve 5-8-1 2 Series VHK How to Order 2 VHK R L 02S

KJ

Nylon, Soft nylon, Polyurethane , , , , 5 32 1 4 5 16 3 8 1 2 T VMG KM11 Specifications Fluid Air Water Note) Model KM11 KM12 KM12 1.0 MPa Maximum operating pressure Proof pressure Ambient and fluid temperature 3.0 MPa 5 to 60C (Water: 0 to 40C) (No freezing) ANSI/ASMEB1.20. 1-1983 (NPT thread) Thread Note) Applicable for general industrial water.

ETL500-F-0-AT-16-0-0-0-AP-0-3-LT (Large Tube, 3 Roller, No Motor) Download Pumphead Datasheet Download Stepper Datasheet Download Tubing Datasheet Pumphead Datasheet.

ETL500-F-0-AT-16-0-0-0-AP-0-3-LST (Large Silicone, 3 Roller, No Motor) Download Pumphead Datasheet Download Stepper Datasheet Download Tubing Datasheet Pumphead Datasheet.

ETL500-F-0-AT-16-0-0-0-AP-0-3-MT (Med Tube, 3 Roller, No Motor) Download Pumphead Datasheet Download Stepper Datasheet Download Tubing Datasheet Pumphead Datasheet.

ETL500-F-0-AT-16-0-0-0-AP-0-4-LST (Large Silicone, 4 Roller, No Motor) Download Pumphead Datasheet Download Stepper Datasheet Download Tubing Datasheet Pumphead Datasheet.