Safety Instructions Chamfered port size D (Recommended value) Rc, G NPT, NPTF Female thread size 1 8 1 4 3 8 1 2 10.5 to 11.8 14.1 to 15.8 17.4 to 19.4 21.7 to 25.1 10.2 to 11.8 13.6 to 15.8 17.1 to 19.4 21.4 to 25.1 15-1-11
The EEPROM is rated to keep its memory for 100,000 hours (approx. 11 years) without having power supplied. When system performance declines due to filter element clogging, worn vacuum pads, piping leakage, etc., the switch can detect and indicate an oncoming problem before failure occurs.
OUT2 setting/(CH1 only) MPa or kPa OUT1 OUT2 CH 1 2 3 4 PRESSURE Normally Open Normally Closed SET SET 16-3-11 11 Series PSE530/200 Operation 1: Initial Setting 4 Response time setting MPa kPa OUT1 OUT2 CH 1 2 3 4 PRESSURE 5 ms 20 ms 160 ms 640 ms SET Press SET button.
CEP: 09950-350, Brasil TEL: 11-4051-1177 FAX: 11-4071-6636 GREECE (Distributor) S.Parianopoulos S.A. 7, Konstantinoupoleos Street 11855 Athens, Greece TEL: 01-3426076 FAX: 01-3455578 DENMARK SMC Pneumatik A/S Knudsminde 4 B DK-8300 Odder, Denmark TEL: 70252900 FAX: 70252901 COLOMBIA (Distributor) Airmatic Ltda. Calle 18 69-05 Apart.
Integrated display 7 Rated flow range (Flow rate range) Option 2 (Refer to page 907.) 0.2 to 10 (5) l/min 0.5 to 25 (12.5) l/min 1 to 50 (25) l/min 2 to 100 (50) l/min 10 25 50 11 Option 1 (Refer to page 907.) ( ): Fluid: CO2 Calibration certificate Flow adjustment valve None With calibration certificate Nil A Nil S None Yes The certificate is written in English and Japanese.
Troubleshooting 11 6. Construction and parts 1112 1 - Safety Instructions These safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of potential hazard with the labels of Caution, Warning or Danger.
Mounted on to unused connectors (BUS OUT and PCI). 12 11 10 9 8 6 5 3 1 7 4 2 Direct mounting (1)When joining six or more units, fix the middle part of the complete EX600 unit with an intermediate reinforcing brace (EX600-ZMB1) before mounting using 2-M4x5 screws. Tightening torque: 0.7 to 0.8 Nm. DIN rail mounting (Available for series other than SY series.
Replace the element every 2 years or when the pressure drop becomes 0.1MPa, whichever comes first, to prevent damage to the element. 0.02 0.02 00 00 2000 4000 6000 50 100 150 200 Flow rate L/min (ANR) Flow rate L/min (ANR) AF20 Rc 1/4 AF50 Rc 1 0.10 0.10 P1 = 0.7MPa P1 = 0.5MPa P1 = 0.7MPa P1 = 0.5MPa 0.08 0.08 P1 = 0.3MPa Pressure drop MPa Pressure drop MPa P1 = 0.3MPa P1 = 0.1MPa 0.06 0.06
(Station 1) Light/Surge voltage suppressor Side A: Orange Side B: Green 18.9 (DIN rail dimension) (62.4) ON ON 43.5 OFF OFF (7.5) 34.2 Switch (when equipped with switch) Internal pilot manifold L: Dimensions n: Stations (n1 + n2) External pilot manifold L: Dimensions n: Stations (n1 + n2) L n 2 110.5 100 81 15 L n 2 123 112.5 91.5 16 3 123 112.5 91.5 16 4 135.5 125 102 17 5 148 137.5 112.5
36.5 81.5 40 8 22 99 68 66.5 101 66.5 46 76 24 1/4, 3/8 VCB31 M5 23 25 32 15 13.5 36.5 86 50 8 30 104 68 71 101 71 46 80 24 1/2 M5 23 22.5 36 17 11 41 90 45 8 22 107 70 74.5 103 74.5 48 84 26 1/4, 3/8 VCB41 M5 23 25 36 17 13.5 41 94 50 8 30 111.5 70 78.5 103 78.5 48 88 26 1/2 M5 28.2 30 36 17 17.5 41 102 60 8 35 119 70 86.5 103 86.5 48 96 26 3/4 4 Direct Operated 2 Port for Heated Water
rubber, Conductive NBR, Conductive silicon rubber Series variations ZPT Series ZPR Series Models Lateral vacuum entry Vertical vacuum entry Buffer With buffer With buffer Buffer mounting (male thread) Buffer mounting (male thread) Mounting Female thread Male thread Female thread One-Touch fitting Female thread One-Touch fitting One-Touch fitting Vacuum entry Female thread Dual Page P.10, 11
If it must be installed in an environment with poor noise conditions, eliminate the power supply noise by using a line filter, Z-wrap, or a spark killler on the 100 V power supply or signal source line. The length of the power suply and signal lines must be kept as short as possible.
Liquid seals When circulating fluid Provide a relief valve in the system so that fluid does not get into the liquid seal circuit. 32 (11/4) 40 (11/2) 25 (1) 50 (2) Nominal dia. mm (inch) 4.0 6.0 8.0 12.0 Tightening torque Nm TLM TILM For fittings of 65A or larger, tighten the fittings by a further 1/8 rotation (45) with a belt wrench after tightening by hand.
In case that the cyclic temperature is beyond normal temperature changes, the inside of the Fieldbus system is likely to be adversely affected. 11. Do not use in direct sunlight. This may cause equipment failure or malfunction. 12. Monitor the ambient temperature range. Failure to do so may cause a malfunction. 13.
Failure to observe this precaution could damage the filter element. 1.10-3 Regulator with Mist Separator AMR3000 to 6000 Dimensions AMR3000 AMR4000, 5000, 6000 N Bracket mounting dimension With auto drain Model Port size A B C D E F G H J K L M U (Body) V (Adapter) P 50 35 45 46.5 R 78 97 98 115 S 8 7 10 15 T 9 9 11 11 B 260 298 366 432 L 178 211 277 321 1 4, 3 8 1 4, 3 8 AMR3000 AMR4000
If it must be installed in an environment with poor noise conditions, eliminate the power supply noise by using a line filter, Z-wrap, or a spark killler on the 100 V power supply or signal source line. The length of the power suply and signal lines must be kept as short as possible. state.
Clamping Force Specifications W-R1-S2Type Type 1 Type 3 Mass of transferred object 1000 kg or less 3000 kg or less 5000 Possible amount of positional correction 50 mm or less 4000 Clamping force 4430 N 4070 N Clamping force [N] Operating time 1.0 s or more 0.8 s or more 3000 Cylinder operation stroke 83.5 mm 140 mm Bore size 100 mm 2000 Cylinder proof pressure 1 MPa Max. operating pressure
Piping: 1 (Bottom Direction), Body Color: BU (Dark Blue), Piping Type: Rc, Connection Size: 11 [S Coupler Plug (Rc Type Only)], Nozzle: 11 (High Efficiency Nozzle, KNH-R02-100)
Bore size (Stroke (mm)) 6 8 12 16 20 25 10, 20, 30, 40, 50 10, 20, 30, 40, 50, 75 10, 20, 30, 40, 50, 75, 100 10, 20, 30, 40, 50, 75, 100, 125 10, 20, 30, 40, 50, 75, 100, 125, 150 10, 20, 30, 40, 50, 75, 100, 125, 150 Applicable Auto Switches/Refer to Best Pneumatics No. 3 for further information on auto switches.
Power supply available all over the world Single-phase 100 VAC, 200 VAC, 230 VAC (50/60 Hz) Air flow capacity (L/min [ANR]) Outlet air temperature adjustment range Outlet air set pressure range Outlet air temperature stability Filter nominal filtration rating Temperature control method Model Port size IDH4 Rc3/8 100 to 500 0.18F (0.1C) 0.01 m (99.9% filtration efficiency) Heater operation