IDX-OM-W031 Install an aftercooler after the air compressor to reduce the temperature. Moisture is generated at the downstream of the compressed air line. The bypass valve is open. Be sure to fully close the bypass valve. Condensate is not drained from the auto drain. Check the draining piping is not used in an upward direction nor bent. Check the auto drain. Check the auto drain strainer.
Furthermore, since valves and cylinders are not guaranteed for zero air leakage, it may not be possible to hold stopped position for an extended length of time. Contact SMC if it is necessary to hold a stopped position for an extended time.
1 Sub-plate Assembly Part No.: VZ400-S!2 Mounting bolt and gasket are not attached. Carbon steel Round head combination screw !4 !5 !6 Pilot valve assembly !
Exhaust the drain from an air filter periodically. Note) Compatible cable (cable O.D. 6 to 12 mm) Washer Rubber seal Binding head screw Tightening torque 0.5 to 0.6 Nm Gasket Note) For an outside cable diameter of 9 to 12 mm, remove the internal parts of the rubber seal before using. 240
(Refer to 2.3.1 Contact input signal TypeFormatFormSetting) If an input from an external switch is detected, it can be generated as an alarm.Options to select continuous monitoring or monitoring during operation are available. Also, the detection start time after the start of operation and the detection end time can be set.
Install an AFM Mist Separator or an AMH Micro Mist Separator with Pre-filter on the inlet side of membrane dryer. Install an air filter or main line filter on the inlet side of the mist separator when there are large quantities of dust (solid foreign matter).
It may cause human injury and/or an accident. Design 1. Cannot be used as an emergency shutoff valve, etc. The valves presented in this catalog are not designee for safety applications such as an emergency shutoff valve. If the valves are used in this type of system, other reliable safety assurance measures should also be adopted. 2. Ensure sufficient space for maintenance activities.
This may cause human injury and/or an accident. Please contact SMC for repair and maintenance of the product. (4) Do not wipe the product using chemicals.
An example of when the SI unit station number is set to 01 is shown below.
Caution (1) Install an air filter. (3) Draining Remove condensate from air filters regularly. (4) Removal of equipment, and supply/exhaust Install an air filter close to the upstream side of the valve.
When mounting any part such as an air filter on the fitting at the compressed air inlet or outlet port, support the part to prevent excessive force from being applied to the product. Be careful not to let the vibration of the air compressor transmit. If the temperature of compressed air on the inlet side is higher than 50oC, place an aftercooler after the air compressor.
Caution (1) Install an air filter. Install an air filter upstream near the valve. Select an air filter with a filtration size of 5m or smaller. (2)Take measures to ensure air quality, such as by installing an aftercooler, air dryer, or water separator.
Do not operate in an atmosphere containing flammable or explosive gases. Fire or an explosion can result. This product is not designed to be explosion proof. If using the product in an interlocking circuit: Provide a double interlocking system, for example a mechanical system. Check the product regularly for proper operation. Otherwise malfunction can result, causing an accident.
If an abnormal condition occurs, turn off the power supply and stop the flow of compressed air. If an abnormal condition occurs, such as smoke, a foul smell, or noise, immediately turn OFF the power supply and stop the flow of compressed air because there is a possible risk of electric shocks or fire. 2. Do not place your hands or foreign objects inside the unit.