PSxx-OMF0005CN

kPa 2.0 64 5 m 100 kPa 0.05mm 0.05mm [s] [s] [mm] [mm] 1.5 64 100 kPa 0.15 mm 2.0 64 100 kPa 0.3 mm [s] [s] [mm] [mm] -21No.PS-OMF0005CN-E ISA2-G ISA2-H 100 kPa 1.5 64 5 m 100 kPa 2.0 64 5 m [mm] [mm] [kPa] [kPa] -22No.PS-OMF0005CN-E ISA2 () 1 ON ( +)ON ()ON OFF Yes 2 No ( OFF +)ON 1 ()ON 3 ()ON 1,3 OFF 4 5 ON OFF 6 7 8 -23No.PS-OMF0005CN-E No.

(N)CQ2

Rod Type Without magnet With magnet Nil D New body type (required if ordering D) Nil K Standard Non-Rotating Rod Notes 1,2) No magnet, 12 to 25 Nil 12 to 200 with magnet, and 32 to 200 w/o magnet Z Bore size 12 16 20 25 32 40 50 63 80 100 125 140 160 180 200 Note 1) Not available for air-hydro type.

AC Servo Motor Driver (Pulse input type)

The effective value is displayed relative to the rated current of 100%. 0300 % 10 Peak load ratio The maximum torque is displayed. The highest value in the past 15 seconds is displayed relative to the rated torque of 100%. 0400 % 11 Instantaneous torque Torque that occurred instantaneously is displayed.

VK300

(Values at the initial period) VT VP VG Solenoid Specifications VP Grommet (G), DIN terminal (D) 100, 110, 200, 220, 240 6, 12, 24, 48 10% of rated voltage 9.5 VA/50 Hz, 8 VA/60 Hz 7 VA/50 Hz, 5 VA/60 Hz 3.5 VA/50 Hz, 3.3 VA/60 Hz 3 VA/50 Hz, 2.8 VA/60 Hz 4 W (Standard), 2 W (Low power consumption type) 4.3 W (Standard), 2.3 W (Low power consumption type) Varistor Diode (Varistor for 12 VDC

HRX-OM-W004

HRR Series 3.1 Precautions wiring communication 3-1 HRX-OM-W004 Chapter 3 Serial communication 2 2 R D R D 3 3 S D S D 5 5 S G S G Master This product Do not connect any wire to other PIN numbers.

VK300

(Values at the initial period) Solenoid Specifications Electrical entry Grommet (G), DIN terminal (D) 100, 110, 200, 220, 240 12, 24 10% of rated voltage 9.5 VA/50 Hz, 8 VA/60 Hz 7 VA/50 Hz, 5 VA/60 Hz 3.5 VA/50 Hz, 3.3 VA/60 Hz 3 VA/50 Hz, 2.8 VA/60 Hz 4 W (Standard), 2 W (Low power consumption type) 4.3 W (Standard), 2.3 W (Low power consumption type) Varistor Diode (Varistor for 12 VDC

EXxx-OMN0037CN

DC24 V D/A DC24 V 3 34 0 V 0 V 4 5 FE FE 5 FE FE 100 k 250 1 k 600 IP67 -34No.EX-OMN0037CN-A 0V 2 EX600 4 (-)2 (+) 4 3 4 -35No.EX-OMN0037CN-A LED LED OFF OFF 0 1 () () (SI ) -36No.EX-OMN0037CN-A EX600-AMB M12 (5 ) 1 2 (1 /) () DC24 V Class22 A 0.5 A/ 12 bit 010 V15 V05 V 020 mA420 mA 15 V 40 mA 100 k 250 (25 ) 0.05 F.S. (25 ) 0.15 F.S. (25 ) 0.5F.S. 0.6F.S.

Digital Flow Switch (Remote type sensor unit)

D: Contents revised in several places. E: Contents are added. F: Contents are added. G: Contents revised in several places. H: Contents are added. I: Contents revised in several places.[March 2017] J: Contents revised in several places.

Pneumatic Purification

Suite D Poway, CA 92064 Tel: (858) 679-1903 Fax: (858) 679 1904 SMC Pneumatics Inc. (Indianapolis) 3011 N Franklin Road Indianapolis, IN 46226 Tel: (317) 899 4440 Fax: (317) 898 4808 SMC Pneumatics Inc. (Boston) Zero Centennial Drive Peabody, MA 01960 Tel: (978) 326 3600 Fax: (978) 326 3700 SMC Pneumatics Inc.

AS-FPQ/AS-FPG

Printed in Japan. 1st printing November, 2000 D-SMC.L.A. P-80 (D)

Digital Pressure Switch ( compatible)

Pressure range Rated pressure Characters displayed on the sub display Vacuum pressure -100 kPa Compound pressure 100 kPa Positive pressure 1 MPa Positive pressure 2 MPa Table showing the output mode and output form when Md1 and Md2 are selected.

Speed Controller with Indicator In-line Brass Stainless steel Electroless nickel plated In-line Type “Made to Order” “Made to Order” section has been added. Pages 3, 8 section has been added. ¡Lubricant: Vaseline -X12 The numerical indication of ¡Greas

AS2052FS AS1002FS AS2002FS Inlet pressure: 0.5 MPa 500 Inlet pressure: 0.5 MPa 100 08, 09 Inlet pressure: 0.5 MPa 06, 07 01, 23, 03, 04, 06, 07 Flow rate [L/min(ANR)] Flow rate [L/min(ANR)] Flow rate [L/min(ANR)] 200 400 06, 07 03, 04 300 50 100 200 100 0 0 5 10 0 0 5 10 0 0 5 10 Number of needle rotations Number of needle rotations Number of needle rotations AS3002FS AS4002FS Inlet pressure

Air Suction Filter / In-line Type With One-touch Fittings Series ZFC

L G ZA F H K J ZX I B C E D A ZR ZM 2 x M3 countersunk head screw mounting hole ZMA ZQ ZH ZU ZFC10, 20 ZL Applicable tubing O.D.

DOC1020530

Target position: 100.000[mm] (=10 [m] = 186A0h) Target speed: 100[r/min] (=10 [0.01r/min] = 2710h) Acceleration time constant: 100 [ms] (= 64h) Deceleration time constant: 100 [ms] (= 64h) The setup value is as follows.

3 Port Direct Operated Poppet Solenoid Valve Series VKF300 1

Rated voltage G: Grommet (Lead wire length: 300 mm) D: DIN terminal DO: DIN terminal H: Grommet (Lead wire length: 600 mm) 50 60 1 2 3 100 VAC, Hz 200 VAC, Hz 110 VAC, Hz 220 VAC, Hz 24 VDC 12 VDC 240 VAC, Hz Other (Without connector) 50 60 50 60 50 60 4 5 6 7 50 60 Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside

VR4151/4152

Tube deformation ratio at the minimum bending radius Mandrel = LD 2d 1 x 100 Caution Here, : Deformation ratio (%) d: Tube diameter (mm) L: Measured length (mm) D: Mandrel diameter (mm) (Twice against the minimum bending radius) 1.Tubing, with the exception of coiled tubing, requires stationary installation.

EX510-GDN1.eng

COM C COM C is receiving data: Lights up COM C is having no data to receive: Goes off COM D COM D is receiving data: Lights up COM D is having no data to receive: Goes off : It is lit when input unit is connected and communicating normally. 19 18 Display/ Switch Setting (continued) Switch setting Make sure that switch setting is performed with power supply turned off.

Rotary Clamp Cylinder: Standard ø12, ø16, ø20, ø25, ø32, ø40, ø50, ø63 Series MK

Rotary Angle Theoretical Output Operating pressure (MPa) Unit: N During unclamping (Extension end) 80 to 100 (9010) L type During unclamping (Extension end) Bore size (mm) Rod size (mm) Operating direction Piston area (cm2) 0.8 1.1 1.5 2 2 3 3.7 4.9 6 8 10.5 12.5 16.5 19.6 28 31.2 80 to 100 (9010) R type 0.3 24 33 45 60 60.8 90.2 112 149 182 243 319 380 502 596 851 948 0.5 40 55 75 100 100

MHS

MH*-OMM0056 MHS2-D MHS3-D MHS4-D MHSJ3-D MHSH(J)3-D 1. 23 2. 2-1. 45 3. 3-1. 6 3-2. 67 3-3. 713 3-4. 13 3-5. 14 3-6. 14 3-7. 14 4. 4-1. 14 4-2. 1518 4-3. 1922 4-4. 2326 1 [ ][][] ISO4414*1)JISB8370*2) 1) ISO4414Pneumatic fluid power-Recommendations for the application of equipment to transmission and control systems. 2) JIS B8370 2 1. 2. 3. 4. 3 2 2-1 MHS2 MHS2 -16D MHS2 -20D MHS2 -25D

3 Port Direct Operated Solenoid Valve Metal Seal, Body Ported/Base Mounted 1

DC: DL (With indicator light) Option Grommet G D DIN terminal 5 Base mounted 0 Manifold 4 Coil rated voltage 1 100 VAC, 50/60 Hz 2 200 VAC, 50/60 Hz 5 9 24 VDC Construction Other Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com Body ported De-energized Base mounted