N.C. valve type, class B coil insulation, Power consumption 2.5w, IP65 enclosure, Seal: NBR (low concentration ozone resistant type: FKM), Resin body 2 port valve, 2 PORT VALVE, I02, 45 lb

N.C. valve type, class B coil insulation, Power consumption 2.5w, IP65 enclosure, Seal: NBR (low concentration ozone resistant type: FKM), Resin body 2 port valve, 2 PORT VALVE, I02, 45 lb

New

signal Current type 4 to 20 mA DC 0 (Sink type) Right angle type 3 m Current type 0 to 20 mA DC 1 (Sink type) 2 3 L Voltage type 0 to 5 VDC Voltage type 0 to 10 VDC Monitor output N Without cable connector 1 2 3 4 Analog output 1 to 5 VDC Switch output/NPN output Switch output/PNP output Bracket Analog output 4 to 20 mA DC (Sink type) Nil Without bracket Flat bracket Thread type Nil Rc B

2.0

(Value in the initial state) Vibration resistance: No malfunction occurred in a one-sweep test between 45 and 2000 Hz. Test was performed at both an energized and a de-energized state in the axial direction and at a right angle to the main valve and armature. (Value in the initial state) 4 When the tube is installed 5 The value is based on SMCs measurement conditions.

PVC Quick Drain Valve

Liquid seals When circulating fluid Provide a relief valve in the system so that fluid does not get into the liquid seal circuit. 32 (11/4) 40 (11/2) 25 (1) 50 (2) Nominal dia. mm (inch) 4.0 6.0 8.0 12.0 Tightening torque Nm TLM TILM For fittings of 65A or larger, tighten the fittings by a further 1/8 rotation (45) with a belt wrench after tightening by hand.

ITVH

AP100 Port size B 2 1/4 3 3/8 Note) EXH port: 1/4 Built-in regulator EXH port: M5 Solenoid valve EXH port: M5 L-bracket C * Bracket is included. 957 ITVH2000 Series Standard Specifications Model ITVH2000 Minimum supply pressure Whichever is higher: 0.5 MPa or the set pressure + 0.2 MPa Maximum supply pressure 3.0 MPa Set pressure range Note 1) 0.2 to 2.0 MPa Power supply Voltage 24 VDC 10%

Speed Controller with One-touch Fittings

1 Component Parts No. 1 2 3 4 5 6 Description Body A Handle Body B Needle Seat ring Needle guide Material Note No. 7 8 9 10 11 12 Zinc chromated Note 2) Material Note Description Lock nut U-seal Spacer Cassette Seal O-ring PBT PBT Brass Brass Brass Brass Steel wire Note 2) HNBR POM Note 1) Electroless nickel plated Electroless nickel plated Electroless nickel plated Electroless nickel plated

Speed Controller with Residual Pressure Release Valve with One-touch Fitting AS  FE Series

12 14 44.9 26.9 49.9 48 6 11.6 27 36.3 14.2 53 AS23 1FE-01-08SK 18.5 28.2 12.9 16.2 30.9 8 15.2 29 40.8 AS23 1FE-02-04SK 16 21.9 10.9 16.2 30.6 4 10.4 36 39.6 AS23 1FE-02-06SK 17 25.2 18.4 34 6 12.8 37 42.1 R 1/4 14 14 41.2 46.2 46.7 51.7 18.5 AS23 1FE-02-08SK 18.5 28.2 18.3 12.9 35.2 8 15.2 39 45.1 AS23 1FE-02-10SK 21 31 20.2 38.7 10 18.5 42 47.9 AS33 1FE-03-06SK 17 25.2 38.5 6 12.8 57 45

•

) I Hys:&fe51S mode AdlUS lable (2 digits or more) Adjustable (3 digits or more) --Hysleresis I:"~ato , me oo Fixed (2 digits) Fixed (3 digils) OFF~ ::,t1:1 -ON : Output ON ON : Output ON ONI ~ Indicator lights Output I Green Output 2 Red Output 1: Green OJtpLrt 2 R ed 200Hz Response frequency 200Hz P2 Pl n2 nl Max.operating pressure , .5MPa { ' 5.3kgf/cm2} 200kPa {2.04kgf/cm2} ONh I ::,b[

S Couplers Series KK/KKH/KK13

Check for the following during regular maintenance, and replace components as necessary. a) Scratches, gouges, abrasion, corrosion b) Leakage c) Twisting, flattening or distortion of tubing d) Hardening, deterioration or softness of tubing 7. Do not repair or patch the replaced tubing or couplers for reuse.

Air Tank Series AT 1

.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com 45 95 150 170 250 350 450 770 960 Surface: Munsell N-5.5, Inner surface: Non coated Safety valve (1 pc.) R 1/2 R 3/4 R 11/4 R 2 R 1 Accessory (2) Rc 1/2 Valve for drainage (1 pc.) Pressure gauge (1 pc.)

Magnet: None, Mounting: B [Through Hole (Standard)], Bore Size: Ø100 mm, Port Thread: TN [NPT (ø32-ø100)], Stroke: 45 mm, Auto Switch: -, Lead Wire or Prewired Connector: -, Number: -

Magnet: Built-in, Mounting: B [Through Hole (Standard)], Bore Size: Ø50 mm, Port Thread: TN [NPT (ø32-ø100)], Stroke: 45 mm, Auto Switch: -, Lead Wire or Prewired Connector: -, Number: -

Magnet: None, Mounting: B [Through Hole (Standard)], Bore Size: Ø50 mm, Port Thread: TN [NPT (ø32-ø100)], Stroke: 45 mm, Auto Switch: -, Lead Wire or Prewired Connector: -, Number: -

Magnet: Built-in, Mounting: B [Through Hole (Standard)], Bore Size: Ø25 mm, Port Thread: M Thread [ø12-ø25]; Rc [ø32-ø100], Stroke: 45 mm, Auto Switch: M9B--Solid State, Gen. Purpose, 2 Wire, Horizontal, Lead Wire or Prewired Connector: 3 m, Number: -

Magnet: Built-in, Mounting: B [Through Hole (Standard)], Bore Size: Ø25 mm, Port Thread: M Thread [ø12-ø25]; Rc [ø32-ø100], Stroke: 45 mm, Auto Switch: M9N--Solid State, Gen. Purpose, 3 Wire NPN, Horizontal, Lead Wire or Prewired Connector: 0.5 m Cord Length, M8-3 Pin Connector, Number: 1 pc.

Magnet: Built-in, Mounting: B [Through Hole (Standard)], Bore Size: Ø25 mm, Port Thread: M Thread [ø12-ø25]; Rc [ø32-ø100], Stroke: 45 mm, Auto Switch: M9N--Solid State, Gen. Purpose, 3 Wire NPN, Horizontal, Lead Wire or Prewired Connector: 0.5 m Cord Length, M8-3 Pin Connector, Number: -

Magnet: Built-in, Mounting: B [Through Hole (Standard)], Bore Size: Ø20 mm, Port Thread: M Thread [ø12-ø25]; Rc [ø32-ø100], Stroke: 45 mm, Auto Switch: M9P--Solid State, Gen. Purpose, 3 Wire PNP, Horizontal, Lead Wire or Prewired Connector: 0.5 m Cord Length, M8-3 Pin Connector, Number: 1 pc.

Magnet: Built-in, Mounting: B [Through Hole (Standard)], Bore Size: Ø20 mm, Port Thread: M Thread [ø12-ø25]; Rc [ø32-ø100], Stroke: 45 mm, Auto Switch: M9NW--Solid State, 2-color Indication, 3 Wire NPN, Horizontal, Lead Wire or Prewired Connector: 3 m, Number: -

Magnet: Built-in, Mounting: B [Through Hole (Standard)], Bore Size: Ø80 mm, Port Thread: TN [NPT (ø32-ø100)], Stroke: 45 mm, Auto Switch: -, Lead Wire or Prewired Connector: -, Number: -