Vacuum Ejector Series ZM Vacuum switch electrical entry M S 0.35 MPa 0.45 MPa 0.5 MPa H Body style Nil L C CL CN Nil L Grommet type, with 0.6 m lead wire (ZSE1) Grommet type, with 3 m lead wire (ZSE1) Connector type, with 0.6 m lead wire (ZSE1) Connector type, with 3 m lead wire (ZSE1) Connector type, without connector assembly Grommet type, with 0.5 m lead wire (ZSM1) Grommet type, with 3 m lead wire (ZSM1) 1 1S
If deionized water is used, the conductivity should be 1S/cm and higher (Electrical resistivity: 1Mcm and lower). Check the drain port is closed by the valve to prevent the supplied circulating fluid from draining out. Supply the circulating fluid up to the H mark on the tank. Operation will stop when the fulid level falls lower than L.
tank 1000cm3 (With switch) Bottom limit ON 1000cm3 (With switch) Bottom limit OFF Metal bowl Lubricator with drain cock Nylon bowl Metal bowl with level gauge Flow direction: Right to left 1 1S-1 1S-2 2 3 6 8 R Note) 1, 1S-1 and 1S-2 are with metal bowl with level gauge and with drain cock. 1.17-8 AL800/900 Flow Characteristics Precautions RC(PT)2 AL800 AL900 RC(PT)11/4 Be sure to read before
Program 1s programming ends. Set the program no. to 8 through UP to PRG 8. Blinking Blinking Blinking Blinking Press WRITE 2 times. The display End will be replaced by 0.0, leading to input STEP 1. 43 Blinking First, press LEFT one time. Next, use DOWN to set the value of 8. Press LEFT one time. Then, use DOWN to set the value of 6. Press WRITE one time.
Between case and 12VDC: 500V AC for 1min REC Withstand voltage Insulation resistance Between case and AC line: 500V DC, 50M or more RHC Ambient temperature 0 to 50C (No freezing) Ambient humidity 35 to 85% RH (No condensation) MTS Square wave noise from a noise simulator (pulse duration 1s) 100V AC line 1500V, 24V DC line 36V I/O line 600V Noise resistance CC Vibration resistance Endurance
pressure 0.7 MPa Min. operating pressure 0.15 MPa 0 to 60C (No condensation) Ambient and fluid temperature Mounting Basic style, Rod side flange style Linear motion, Rotary motion/Specifications CRB1 Linear motion Bore size (mm) 32 40 Piston speed 50 to 500mm/s CRBU Cushion With air cushion, Without air cushion Port size Rc(PT)1/8 CRA1 Rotary motion Output torque (At 0.5 MPa) 1Nm 1.9Nm 0.2 to 1s
Matsushita, Mitsubishi, Omron, Sharp, Toshiba, Toyota 24VDC 10% Supply Voltage Varies by network Current Requirement 16 points Outputs 32 points (IN313-AB2 only) Indications Serial Unit Status LEDs for power, communication, error, I/O state (varies by protocol) Connection Plug-in (2 terminal strips for power and network in manifold block) Line Noise Resistance 1500V p-p power supply noise, 1s
Real-time switch output, accumulated switch output) Output Note 3) specifications Accumulated pulse output No. of outputs Output protection NPN open collector or PNP open collector (same as switch output) 4 outputs (1 output per 1 sensor input) Short circuit protection Hysteresis Response time Note 4) Hysteresis mode: Variable (can be set from 0), Window comparator mode: Fixed (3-digits) 1s
Program 1s programming ends. Set the program no. to 8 through UP to PRG 8. Press WRITE for 2 times. The display End will be replaced by 0.0, leading to input STEP 1. Blinking Blinking Blinking Blinking Blinking Blinking Blinking 51 First, press LEFT one time. Next, use DOWN to set the value of 8. Press LEFT one time. Then use DOWN to set the value of 6. Press WRITE one time.
No.VQ4000V-OMV0001 Solenoid Valve PRODUCT NAME VQ4000/5000 (Pilot Valve V100) MODEL/ Series Contents Safety Instructions -2,3 Precautions on Design -4,5,6 Selection -4,5,6 Mounting -6 Piping -6 Wiring -6 Lubrication -7 Air Supply -7 Operating Environment -7 Maintenance -7,8 Specific Product Precautions -9 ~11 Construction and optional parts -12~15 Trouble shooting -16,17 -1S VQ4000V-OMV0001
Real-time switch output, Accumulated switch output) Output Note 4) specifications Accumulated pulse output No. of outputs Output protection NPN open collector or PNP open collector (same as switch output) 4 outputs (1 output per 1 sensor input) With short circuit protection Hysteresis Response time Note 5) Hysteresis mode: Variable (can be set from 0), Window comparator mode: Fixed (3-digits) 1s
The ready to send signal (X32) is not turned OFF within 1s after the ABS data request signal (Y42) is turned ON. 2. Programmable PC or Correct the ladder. PLC...etc program incorrect. 3. The ready to send signal (X32) remains OFF for longer than 1s. 3. Faulty programmable PC or PLC...etc output or input module. Change the input or output module. 4.
If deionized water is used, the conductivity should be 1S/cm and higher (Electrical resistivity: 1Mcm and lower). Check the drain port is closed by the valve to prevent the supplied circulating fluid from draining out. Supply the circulating fluid up to the H mark on the tank. Operation will stop when the fulid level falls lower than L.
Vibration resistance 490 m/s2 in X, Y, Z directions 3 times each Impact resistance 1000 Vp-p, Pulse width 1s, Rise time 1ns Noise resistance Weight Note 3) 660 g Port size (Rc, NPT, G) 1/2, 3/4 3/8, 1/2 3/8 Note 1) The system accuracy when combined with PF2W2/3. Note 2) Output system can be selected during initial setting. Note 3) Without lead wire.
No.PB19PB20 12 00 OFF PB03 0 PB04 FFC 100 100%1s 0 0 100 PB05 500 PB06 GD2 1(6.1.1)0100.0 No.PA0823 7.0 0 300.0 PB07 PG1 12 No.PA0803 24 rad/s 1 2000 5 14 5 No.
No.SY3000V-OMM0002-B Solenoid Valve PRODUCT NAME SY3000/5000/7000 Series Plug-in Type MODEL/ Series Contents Safety Instructions -2,3 Design / Selection -4,5 Mounting -5 Piping -6 Wiring -6 Lubrication -7 Air Supply -7 Operating Environment -8 Maintenance -8 UL approved product -8 Specific Product Precautions -9 ~16 Construction and optional parts -17~19 Trouble shooting -20,21 -1S No.SY3000V-OMM0002
4000 Current (% to the capacity of the main breaker of this product) Figure 3-6 Breaker operating characteristics curve HRZ Series 3.3 Procedure for Installation 3-9 HRX-OM-I051 Chapter 3 Transporting and Installation HRZ008-L HRZ008-L1 4h 2h 1h 30min 20min 14min 10min 6min 4min MAX 2min 1min Operating time 30s 20s 10s 5s 2s MIN 1s 0.5s 0.2s 0.1s 0.05s 0.02s 0.01s 100 135 200 300 400 500
Tie rod Carbon steel Uni-chromated " Tie rod nul Garbon steel Nickel plated 12 Wear ring Resin ~ , 13 Rod end nut Carbon steel Nickel plated Seal Kit list '-Sore slie (mm) Seal kit part number Contents n MB32-PS ~ , 40 M840PS Sel 01 the ,', SO MB50-PS ~ 63 M863-PS No, 14, 1S, 1Band 18. ~ 60 MBSO-PS ~ lOll MBl OOPS *The seal kit includes 2-cushlon seals, I-rod seal, ' -piston seal, and 2-tube
Rc Special voltage With light Without DIN connector (With surge voltage suppressor) G 24 VAC 12 VDC 48 VAC NPT 1K 1L Rc 220 VAC 240 VAC Applicable to air and water (VXN<2) Conduit terminal 1M 1W (With surge voltage suppressor) 24 VAC 12 VDC 48 VAC 1N 1P 1Q 1R 1Y 1S 1T 2A 2B 2C 2D 2E 2F Enter symbols in the order below when ordering a combination of electrical option, other option. 220 VAC
Interior purge N2 gas Packaging Clean gas filter Class 10,000 Class 10,000 31 Pressure Control Equipment Regulator Series AR Regulator Series Application/Characteristics Port size Set pressure (MPa) Miniature regulator ARJ1020F Direct operated relieving style Back flow function M5 0.1 to 0.7 Miniature regulator ARJ210 Direct operated relieving style 0.2 to 0.7 M5 to 1/8 Miniature regulator ARJ310