PSxx-OMU0008CN

(20,100,500,1000,2000,5000 ms ) 2 0 15 V 0.65 V 0.85 V 1 k 420 mA 2.420 mA 3.220 mA 12 V 300 24 V 600 50 0.4 V 5 ms -77No.PS-OMU0008CN-D ZSE20C ZSE20CF ISE20C ISE20CH () () () () 3 MPa,kPa,kgf/cm 2,bar,psi,InHg, mmHg MPa,kPa,kgf/cm 2,bar,psi LCD 3 (X2) 1)/ 2) 1)4 7 2)4 (1 11 7 ) ON OUT1OUT2 4 0,10,50,100,500,1000,5000 ms IP65 AC250 V 1 2 M(DC50 V ) -550 -1060 ()

PSxx-OMU0002CN

(20,100,500,1000,2000,5000 ms ) 0 2 15 V 0.65 V 1 k 420 mA 2.420 mA 12 V 300 24 V 600 50 0.4 V 5 ms -75No.PS-OMU0002CN-D ZSE20A() ZSE20AF() ISE20A() 3 MPa,kPa,kgf/cm 2,bar,psi,InHg,mmHg MPa,kPa,kgf/cm 2, bar,psi LCD 3 (X2) 1)/ 2) 1)4 7 2)4 (1 11 7 ) ON OUT1OUT2 4 0,10,50,100,500,1000,5000 ms IP40 AC1000 V 1 50 M(DC500 V ) -550 -1060 () 3585RH() UL/CSA(E216656)CE

Digital Flow Switch (Remote type monitor unit)

Although the accumulated flow value is measured up to 9 L, normally only the lower 3 digits are displayed. Press and hold the button to display the upper 3 digits.

PFxx-OMJ0005CN

1. 2. 3. 4

α PneuAlpha HARDWARE MANUAL

20 40 ms Response Time (I01 I08) 10 20 ms 10 20 ms Description AC Input Specication Description Sink (Common) Source (+ Common) 6 PneuAlpha Hardware Specification 2 Table 2.5: Analog Input Specications Temperature Drift +/3 LSB Offset/Gain Offset Value = 0 at 0V DC Gain Value: 0 10V = 0 250 These default values can be changed in the Offset FB Overall Accuracy +/5% (0.5V DC) Input Impedance

Table of Contents

3 3 3 MHY MHW MRHQ Direct mounting type Misc.

Step Motor Controller

B-1 A-1 B-2 A-2 B-3 A-3 Circuit Cable color Brown Red Orange Yellow Green Blue 2 1 6 5 3 4 A A B B COM-A/COM COM-B/ Cable color Connector D terminal no.

Electric Actuator/Slider Type

3 !

Valve Single Unit

ground Type 3 ground Type 3 ground Type 3 ground b) 3-wire type Wiring with signal ground line (SG) Master unit Slave unit 01 Slave unit 03 Slave unit 75 Type 3 ground Type 3 ground Type 3 ground Type 3 ground Twisted pair with shield Type 3 ground Type 3 ground Type 3 ground Type 3 ground 1-6-113 Type SF1 NKE Corporation Uni-wire System Type SJ1, SJ2 SUNX Corporation S-LINK System Type SG

EX120/121/122

ZS-28-CA-2 ZS-28-CA-2 ZS-28-CA-3 ZS-28-CA-2 ZS-28-CA-3 ZS-28-CA-3 ZS-28-CA-3 ZS-28-CA-3 ZS-28-CA-3 ZS-28-CA-3 ZS-28-CA-3 ZS-28-CA-3 ZS-28-CA-4 ZS-28-CA-4 ZS-28-CA-4 SMC part no. Manufacturer's part no.

Valve Single Unit

ground Type 3 ground Type 3 ground Type 3 ground b) 3-wire type Wiring with signal ground line (SG) Master unit Slave unit 01 Slave unit 03 Slave unit 75 Type 3 ground Type 3 ground Type 3 ground Type 3 ground Twisted pair with shield Type 3 ground Type 3 ground Type 3 ground Type 3 ground 1-6-113 Type SF1 NKE Corporation Uni-wire System Type SJ1, SJ2 SUNX Corporation S-LINK System Type SG

Step Motor Controller

B-1 A-1 B-2 A-2 B-3 A-3 Circuit Cable color Brown Red Orange Yellow Green Blue A A B B COM-A/COM COM-B/ 2 1 6 5 3 4 Cable color Connector D terminal no.

AC Servo Motor Driver LECYM/LECYU Series Compatible LEF  Position control, speed control and torque control Power supply voltage (V) LEJ can be used. 200 to 230 VAC 
Control encoder: Absolute 20-bit encoder LEL Motor capacity (W) (Resolution: 10485

3 !

7ND9071en

[6 mm or 1/4" (x)] 1.2* 2.1* 2C 1.08 66 3/8 10 mm or 3/8" 2.4 3.0 3C 2.18 133 3/8 10 mm or 3/8" 4.8 5.2 4C 4.34 265 3/8 10 mm or 3/8" 3.2 3.7 5C 8.7 531 3/8 10 mm or 3/8" 7.5 11.0 6C 17.5 1068 3/4 10 mm or 3/8" 12.0 20.0 Air supply piping 10 mm or 3/8" for all actuators.

ZSE30/ISE30

PRESSURE PRESSURE PRESSURE PRESSURE PRESSURE OUT OUT ON: Red ON: Green OUT OUT OUT PRESSURE PRESSURE 2.5 ms 20 ms 160 ms PRESSURE PRESSURE OUT OUT ON/OFF: Red ON/OFF: Green Press the SET button to set the color and proceed to the operating mode setting. If the analog output is set, press the UP or DOWN button and select the desired display color from (Green) or (Red).

SFOD-OMT0010

Connect the actuator cable. 16 MOT3 Motor power connector (6 pins) 17 ENC4 Encoder connector (16 pins) Axis 4: Connect the actuator cable. 18 MOT4 Motor power connector (6 pins) 19 CI 3 4 Motor control power supply Motor control power supply(+), Axis 3 stop(+), Axis 3 unlock(+), Axis 4 stop(+), Axis 4 unlock (+) connectorNote) 20 M PWR 3 4 Motor drive power connector Note) Axis 3, Axis 4

Valve Single Unit

/pressure center JIS Symbol 3 position closed center 3 position exhaust center 3 position pressure center (This figure shows a closed center type.)

PFxx-OMA1007

Signal Details 1 NC Not connected 2 NC Not connected 3 0 V 0 V 4 Output Output 5 NC Not connected VP side: M12 3-pin A-coded (Plug) Connector Pin No. Signal Details 3 0 V 0 V 4 + Input 5 FE Ground -25No.PF-OMA1007-B Connection to Standby regulator Hub side M12 5-pin A-coded (Socket) Connector Pin No.

VP4

And it can be used in the vacuum applications. 2 position single/3 position 0.15 to 0.9 MPa Operating pressure range 2 position double VF 0.1 to 0.9 MPa Max. 50C Ambient and fluid temperature 2 position double VFR 45 ms or less Note) 45 ms or less Note) Response time 3 position 60 ms or less Note) 70 ms or less Note) 2 position double VP4 Max. operating frequency 5 Hz 5 Hz Courtesy of Steven

Auto Switch Guide Reed Switches/Solid State Switches For Air Grippers (Rotary Actuators) 1

MHF Type Solid state switch Reed switch 3-wire: 100 A or less, 2-wire: 0.8 mA or less (4) Leakage current None MHL Note 2) Operating time 1 ms or less (3) 1.2 ms Impact resistance 1000 m/s2 300 m/s2 MHR 50 M or more at 500 M VDC (Between lead wire and case) Insulation resistance Note 3) MHK 1000 VAC for 1 minute (Between lead wire and case) 1500 VAC for 1 minute (1) (Between lead wire and