SMC Corporation of America
Elite Part Number Search
Search Results "HRS200-AN-46-ASW"

Operation stop Combination Symbol: D1 Combination Symbol: D4 An N.C. solenoid valve is used for the vacuum release valve. An external supply valve must be provided. An external valve must be provided to serve as the supply valve. An air operated N.C. valve is used for the vacuum release valve.

An external pilot style that can be used individually is available as a made-to-order. For details, refer to the page 4-6-46.

Note 4) When n is an odd number, an even number that is one larger than this odd number is used for the calculation. However, the minimum even number is 4. So, 4 is used for the calculation when n is 1 to 3.

The ABS data is also transmitted when an alarm is reset or when an emergency stop is reset. 2) An ABS checksum error is caused (Y3AON) if checksum inconsistency is found in transferred data. 3) The following time periods are measured.

As the vacuum power of an ejector (venturi) rises, the vacuum flow actually lowers. When an ejector is used at its highest possible vacuum value, the vacuum flow will lower. Due to this, the amount of time needed to achieve adsorption is lengthened.

Never use in an atmosphere of explosive gases. The construction of auto switches is not intended to prevent explosion. Never use in an atmosphere with an explosive gas since this may cause a serious explosion. 2. Do not use in an area where a magnetic field is generated. Auto switches will malfunction or magnets inside actuators will become demagnetized. 3.

With an ejector When a few air cylinders are locally used.

It turns OFF when an alarm occurs or when JOG movement takes place.

Note 1) This cylinder cannot perform an intermediate stop using an air pressure circuit in vertical operation. In this case, an intermediate stop can be performed only by using an external stopper, etc. Note 2) Made-to-order products should be considered, too, depending on an operating environment, etc.

Check the specifications carefully before selecting an air dryer.

Note 3) When n is an odd number, an even number that is one larger than this odd number is used for the calculation.

Panel mount adapter ZS-46-B Panel mount adapter + Front protection cover ZS-46-D Lead wire with connector ZS-46-3L 3-core, 2 m, Non-waterproof (Without waterproof cover) Front protection cover ZS-27-01 D Panel mount adapter + Front protection cover ZS-46-D R1/8 Piping adapter ZS-46-N1 NPT1/8 Piping adapter ZS-46-N2 9 3-Screen Display High-Precision Digital Pressure Switch ZSE20(F)/ISE20

The unlocking cam is an emergency unlocking mechanism only.

(An assembly is shipped under the condition shown in the figure.) Note) The EXH port may be either on the lead wire side or on the end plate side. (An assembly is shipped under the condition shown in the figure.)

When an invalid combination is specified, an alarm (SUBCMD_ALM = BM (A.95E)) occurs.

If operated with the workpiece gripping point beyond the indicated ranges, an excessive offset load will be applied to the sliding section of the fingers, which can have an adverse effect on the service life of the product.

46 119.2 58 136 173 MORE DIMENSIONS S E E N E X T P A G E Courtesy of Steven Engineering, Inc. !

Select an air-hydro cylinder in combination with an air-hydro unit. Since good operation of an air-hydro cylinder depends on combination with an air-hydro unit, be sure to select an appropriate air-hydro unit. 2. Set the load of the air-hydro cylinder to be 50% or less of the theoretical force.