OMU0023 The current target position data is sent D9004 Target position 4 as an encoder count value. Step Data number being executed is D9006 Step Data number executed 2 sent. (a) Positioning data (encoder count value) The current position data is sent as an encoder count value. Count value 1,000,000 has been fixed for 0 mm as a reference point.
The valves are assembled as N.C. valves at the time of shipment. By removing the two retaining screws from the desired valves, and rotating each valve body 180 and reassembling it on the manifold base, it is possible to reassemble an N.C. valve as an N.O. valve. (When doing so, make sure that a gasket is attached to the mounting surface of the valve.) Properly tighten the screws.
Do not use in an environment with temperature cycles. Consult SMC if switches are used where there are temperature cycles other than normal temperature changes, as they may be adversely affected internally. 6. Do not use in an environment where there is excessive impact shock.
DeviceNet compatible SI unit As a DeviceNet slave unit, it is capable of solenoid valve ON/OFF control up to a maximum of 32 points. In addition, by connecting an input block a maximum of 32 sensor signal inputs are possible. Input block This is an expansion block which connects to an SI unit to perform sensor input from auto switches, etc.
V (mm/s) = Auto switch operation range (mm) Load operating time (ms) x 1000 In cases of high piston speed, the use of an auto switch (D-F5NT, F7NT, G5NT and M5T) with a built-in OFF delay timer (approx. 200ms) makes it possible to extend the load operating time. 4. Wiring should be kept as short as possible.
Do not use in an environment with temperature cycles. Consult SMC if switches are used where there are temperature cycles other than normal air temperature changes, as they may be adversely affected internally. 6. Do not use in an environment where there is excessive impact shock.
Cushion valve Auto switch Built-in magnet All cylinders come with a built-in magnet as a standard feature. This makes possible the mounting of an auto switch for piston position sensing even after the cylinder has been installed.
Please consult with SMC for details, as delivery times may be extended.
In cases where the band mount type is used as an applicable auto switch, select the part number of the new band referring to page 6-8-71 whenever the cylinder model is changed.
Real-time switch output, accumulated switch output, or accumulated pulse output can be selected as an output type.
Real-time switch output, accumulated switch output, or accumulated pulse output can be selected as an output type.
Applying an improper load may cause malfunctions. 3. Do not use the cylinder in an environment where the cylinder is expose to moisture, adhesive foreign matter, dust or liquid such as water or cutting fluid. If the cylinder is used in an environment where the lubrication of the cylinders sliding parts is compromised, please consult SMC. 4.
Note) When an AS-i compatible S kit is used, there is a limit on the maximum number of stations. For details, please refer to page 14. DeviceNet DeviceNet CC-Link CC-Link PROFIBUS-DP PROFIBUS-DP Remote I/O AS-i CANopen Nil +COM. COM.
As a guide, refer to the proper tightening torques shown below.
Modules for use with external vacuum supply (from pump or mainline) or as an air driven ejector system. Safe Vacuum self-holding function by means of double solenoid valves.
Do not use the cylinder under the following environments: An area in which fluids such as cutting oil splash on the piston rod An area in which foreign matter such as particles, cutting chips, or dust is present An area in which the ambient temperature exceeds the operating range An area exposed to direct sunlight An environment that poses the risk of corrosion 2.