Hand Valve Series VH

VlA Selection Caution Environment Warning VM/VR VH q Use in low temperature environments The valve can be used at a temperature down to 5C. Take appropriate measures to avoid freezing of drainage, moisture, etc. q When the valve is installed in an atmosphere where there is a lot of dust, install a silencer into the port "3(R)".

Electro-pneumatics Hybrid Regulator

Failure phenomenon Possible causes Countermeasures (Page 10) The pressure can not be 1 Even though the signal goes up, the pressure does not increase. Supply pressure and/or pilot pressure (for external pilot type) is not high enough.

VNB Series

Low temperature operation 1) The valve can be used in an ambient temperature of not less than 5C.

Two Hand Control Valve

Mandrel = LD 2d 1 x 100 Here, : Deformation ratio (%) d: Tube diameter (mm) L: Measured length (mm) D: Mandrel diameter (mm) (Twice against the minimum bending radius) Test temperature: 20 5C Relative humidity: 65 5% Air Supply Warning 5.Do not use fluids other than specified. The only fluid that can be used is air. 1. Use clean air.

Direct Operated 3 Port Solenoid Valve

Common exhaust Individual exhaust 10 VT315-OMH0002-D TROUBLE SHOOTING Should any trouble be found during operation, trace the source of the trouble in the following order and take corrective action.

Safety Instructions

Wrapping direction Pipe tape Expose approx. 2 threads Excessive tightening may damage the thread portion or deform the gasket and cause air leakage. 15-1-10 4 Fittings & Tubing Precautions 2 Be sure to read before handling.

Clean Exhaust Filter SFE Series

Clean Exhaust Filter SFE Series RoHS How to Order SFE 11 Size/Port size Male thread type Plug-in type Symbol Port size Max. ow capacity L/min (ANR) 11 M5 x 0.8 3 42 R1/8 65 52 R1/8 130 53 R1/4 130 73 R1/4 200 Symbol Port size Max. ow capacity L/min (ANR) 3A 4 30 4B 6 65 5C 8 130 7D 10 200 Male thread type One-touch tting type Symbol Applicable tubing O.D.

3/5 Port Solenoid Valve

Tightening Torque for Piping VK300 series can be used down to -5C. VK3000 series can be used down to -10C. Connection thread Proper tightening torque (Nm) Rc1/8 3~ 5 5 VK300**-OMH0002-C VK300/3000 Series Precautions for 3/5 Port Solenoid Valve 3 Be sure to read before handling. Piping Air Supply 4. Piping to products 1.

Symbol: 11 (Body Ported), Voltage: 5 (24 VDC), Wetted Part Material: C (Plate: PEEK; Diaphragm: Kalrez®), Reverse Mounting Prevention Pin: None, Bracket: None, Lead Wire Length: 6 (Grommet, 600mm; Light/Surge: No), CE Compliant: Q (CE Compliant)

Symbol: 11 (Body Ported), Voltage: 5 (24 VDC), Wetted Part Material: C (Plate: PEEK; Diaphragm: Kalrez®), Reverse Mounting Prevention Pin: None, Bracket: 1 (Bracket), Lead Wire Length: 6 (Grommet, 600mm; Light/Surge: No)

Symbol: 11 (Body Ported), Voltage: 5 (24 VDC), Wetted Part Material: C (Plate: PEEK; Diaphragm: Kalrez®), Reverse Mounting Prevention Pin: None, Bracket: 1 (Bracket), Lead Wire Length: Grommet, 300mm; Light/Surge: No, CE Compliant: Q (CE Compliant)

Symbol: 11 (Body Ported), Voltage: 5 (24 VDC), Wetted Part Material: C (Plate: PEEK; Diaphragm: Kalrez®), Reverse Mounting Prevention Pin: None, Bracket: 1 (Bracket), Lead Wire Length: KZ (Plug Connector, 300mm; Light/Surge: Yes)

Symbol: Body Ported, Voltage: 24 VDC, Wetted Part Material: Plate: PEEK; Diaphragm: Kalrez®, Reverse Mounting Prevention Pin: None, Bracket: None, Lead Wire Length: Grommet, 600mm; Light/Surge: No, CE Compliant: CE Compliant

Symbol: Body Ported, Voltage: 24 VDC, Wetted Part Material: Plate: PEEK; Diaphragm: Kalrez®, Reverse Mounting Prevention Pin: None, Bracket: Bracket, Lead Wire Length: Plug Connector, 300mm; Light/Surge: Yes, CE Compliant: -

Compatible Fluid: Air / Water / Chemical, Operating Environment: Standard, Type: Electromagnetic Type, Switching Type: Normally Closed, Body Material: Resin, Connection Type: M, Plumbing Thread Nominal: M5, Tube Diameter: -, Operating Temperature Range(°C): 0～50, Driving Type: Linear Motion Type, Orifice Diameter(Ø): 1.5, Insulation Class: B, Pipe opening type (details): Body Ported Type,

Compatible Fluid: Air / Water / Chemical, Operating Environment: Standard, Type: Electromagnetic Type, Switching Type: Normally Closed, Body Material: Resin, Connection Type: M, Plumbing Thread Nominal: M5, Tube Diameter: -, Operating Temperature Range(°C): 0～50, Driving Type: Linear Motion Type, Orifice Diameter(Ø): 1.5, Insulation Class: B, Pipe opening type (details): Body Ported Type,

Heatless Air Dryer Series ID

(Self-regenerative style allows for easy maintenance.) 7 8.5 18.5 25 Note) Inlet air pressure: In the case of 0.7 MPa Specifications ID20 ID30 ID40 ID60 Model Compressed air Fluid Operating pressure (MPa) Inlet air temperature (C) Ambient temperature (C) Voltage & power consumption 10% Installation features 0.3 to 1.0 0.3 to 0.9 5 to 50 2 to 50 100 VAC, 200 VAC (50/60 Hz) 30 W Indoor Note

Heatless Air Dryer Series ID 1

.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com Specifications ID20 ID30 ID40 ID60 Model Compressed air Fluid Operating pressure (MPa) Inlet air temperature (C) Ambient temperature (C) Voltage & power consumption 10% Installation features 0.3 to 1.0 0.3 to 0.9 5 to 50 2 to 50 100 VAC, 200 VAC (50/60

Symbol: 11 (Body Ported), Voltage: 5 (24 VDC), Wetted Part Material: C (Plate: PEEK; Diaphragm: Kalrez®), Reverse Mounting Prevention Pin: None, Bracket: 1 (Bracket), Lead Wire Length: 6 (Grommet, 600mm; Light/Surge: No), CE Compliant: Q (CE Compliant)

Compatible Fluid: Air / Water / Chemical, Operating Environment: Standard, Type: Electromagnetic Type, Switching Type: Normally Closed, Body Material: Resin, Connection Type: M, Plumbing Thread Nominal: M5, Tube Diameter: -, Operating Temperature Range(°C): 0～50, Driving Type: Linear Motion Type, Orifice Diameter(Ø): 1.5, Insulation Class: B, Pipe opening type (details): Body Ported Type,