Regulator for 2 MPa ARX 20 Do not subject the gauge to impacts, such as dropping, during transportation and mounting. This can cause loss of indication accuracy. 2. Do not use in locations with high temperature and humidity. This can cause malfunction. 3. When screwing the pressure gauge into place, be sure to apply your wrench on the square wrench flats.
Before piping and screwing in couplings, please make sure that sludge trom pipe threading and sealing materials do not go into the pipe. When seal tape is used, tape winding should be done so that 2 threads are left untaDed on the end.
Do not service or attempt to remove product and machinery/equipment until safety is confirmed. The inspection and maintenance of machinery/equipment should only be performed after measures to prevent falling or runaway of the driven objects have been confirmed.
Do not supply or discharge air suddenly. This will cause the temperature to decrease due to air expansion, and the temperature may exceed the operating temperature limit of the air tank. If flow speed becomes faster, a loud noise may be generated by the friction inside the tube.
VQC1000/2000 series valves do not come with mounting screws or gaskets. For VQC4000/5000 series valves, when a valve is ordered individually, it comes with a mounting screw but no gasket. VQC1000/2000 series valves do not require separate mounting screws as there are clamp screws built into the manifold.
VQC4000/5000 series valves do not have common polarity.
② For manifolds with serial transmission kits, whether the valves are positive common or negative common depends on the type of protocol. For VQC1000/2000 series valves, install valves with the same common specification as the common specification of your protocol.
Do not restrict the flow rate by plugging or mounting a speed controller to the exhaust port.
In addition, SY7120 series valves do not come with a gasket because they are the equivalent of existing SY7000 series body ported valves.
The SY7000 series body ported valve gasket assembly part number is “SY7000-GS-1.”
Do not tighten or loosen the release bolts excessively. Also, do not tighten them with a pneumatic or electric screwdriver because it may damage internal parts of the product.
For further details, refer to the excerpts from the MWB series “Specific Product Precautions” below.
However, unlike KS and KX series rotary One-touch fittings, they do not rotate with low friction. Do not use the product in a manner in which the connected tube swings or rotates with respect to the fitting.
PF2D series: Pure water and liquids that do not corrode or permeate Teflon (Refer to the list of applicable fluids in the catalog.)
LFE series: Fluids that do not corrode the materials of wetted parts (Refer to the list of applicable fluids in the catalog.)
However, new VX2 (with a white coil) series valves do not have mounting holes on the bottom surface of the body, so brackets cannot be retrofitted.
If the part number is “VX2□□□□XNB,” a bracket can be retrofitted because it has a mounting hole on the bottom surface of the body.
Note) 1/2 port size VX2 series valves do not have an option with brackets as standard.
Do NOT make upward piping. 2. Float type auto-drain (N.C.) DO NOT pipe upwards. (ANR)}. 2) Set pressure more than 0.1 MPa. 2. Float type auto-drain (N.C.) 1) Compressor can be used even if energy is under 3.7 kw. 2) Set pressure more than 0.15 MP 14-3-14
Before piping and screwing in couplings, please make sure that sludge trom pipe threading and sealing materials do not go into the pipe. When seal tape is used, tape winding should be done so that 2 threads are left untaDed on the end.
Do not attempt to rotate, as it does not turn Cable connection threads RC(PT) 1/4 Exhaust porl EXH (3) Port size 4-M5 x 0 8 thread depth 6mm Mounting hole 2-RC(PT) 1/4, 3/8 SUP port, OUT porl rTl|z000/3000 tleflru-Pltotllnalic Re[ula 0imeffiiolt$ ITV3OtrT Cable connector (4 wire) Cable connector (4 wire) . Do not anempt to rotate. as it does not turn.
The SY is available in body ported or base mounted styles, and can be used individually or manifold mounted.Plug-in connector connecting base, Side ported, Available with external pilot, Connector types: D-sub, Flat ribbon cable (26, 20 or 10 pins), PC wiring, One-touch fittings, MFLD ASSY, 16-STA (SY), VALVE, SS5Y3 MANIFOLD SY3000, AJ, SS5Y3 BODY PT (M5), .57860 lb
Please contact us for the latest version.sales@ocaire.com, MANIFOLD, 16-STA, VALVE, VV3K* MANIFOLD VK 3-PORT, NJ, VV3K* BASE MT 1/8, .59516 lb
Please contact us for the latest version.sales@ocaire.com, MANIFOLD, 16-STA, VALVE, VV3K* MANIFOLD VK 3-PORT, NJ, VV3K* BASE MT 1/8, .30684 lb
MFLD ASSY, 16-STA (SY). VALVE. SS5Y5 NO SIZE RATING. 1.58400 lb. 2J.
This is a legacy product. Please contact us for the latest version.sales@ocaire.com