SYJ3000/5000/7000 (For details, refer to catalog in page 1-5-73.)
Note 1) Enter the cable length symbols in . Please be sure to fill in the blank referring to page 374.
Consult P/A when the use in such environment is required. 3.Do not use in direct sun light. 4.Do not use in environment where there is heat source. With shock absorber 2.
ZH05DA06 06 06 One-touch One-touch One-touch 06 01 06 One-touch Screw-in One-touch 01 01 01 Screw-in Screw-in Screw-in ZH05DA07 07 07 One-touch One-touch One-touch 07 N01 07 One-touch Screw-in One-touch N01 N01 N01 Screw-in Screw-in Screw-in ZH07DA06 06 06 One-touch One-touch One-touch 06 01 06 One-touch Screw-in One-touch 01 01 01 Screw-in Screw-in Screw-in ZH07DA07 07
Operation pattern Describe in detail. Speed Confirm the amount of time in seconds needed to cover the moving distance.
Auto switch Buit-in maonel. Rail mountino stvle Buit in maqnel.
It is already built-in to the rectifier circuit.
Built-in One-touch fittings :! for easier piping.
Low Speed Cylinder o20 to o40mm Stable ooeration at extremely low speeds (0.02 in/sec). Splash Proof a2O lo a40mm For use in environments where the cylinder is in direct contact with water or liquid. Allows piping at head end only.
This may cause play or an increase in the sliding resistance. 1. Tap Mounting Max. screw-in depth If bolts are too long, they will come into contact with the cylinder tube, in this case, the product will not be held correctly. Use bolts that are between the maximum and minimum screw-in depths in length.
Operation pattern Describe in detail. Speed Confirm the amount of time in seconds needed to cover the moving distance.
Built-in One-touch Fitting CM2 F Mounting Bore size Stroke Specifications Action Double acting/Single rod Built-in One-touch fitting Bore size 20, 25, 32, 40 A style in which One-touch fittings are built in the cylinder. It dramatically reduces the piping labor and installation space.
Can be used for 230V AC in common.
There are limitations on the load mass and operating pressure in case the product is used in the vertical direction. When using the product in the vertical direction, confirm the allowable values in Vertical Operation in Model Selection (1) on page 1548. If the allowable value is exceeded, the magnet coupling may slip off, causing the workpiece to drop down.
indicated in the following drawing.
OUT IN OUT IN OUT IN OUT IN OUT IN 56 31 157 100 353 252 628 471 982 756 1608 1206 4 CXS 6 15.7 10.0 35.3 25.2 62.8 47.1 98.2 75.6 161 121 6 CXS10 8 CXS15 Manual Release 10 CXS20 Manual release (Non-locking type) 1.
The stroke can be set in 1 mm increments.
The stroke can be set in 1 mm increments.