Compressed Air Preparation Filter Do not use the product where these are present. 2. Applications in which the difference between the inlet and outlet pressure exceeds 0.1 MPa must be avoided. Failure to do so may result in element breakage. 3. For air blow applications, prevent airborne particles from the operating environment from entering into the compressed air stream.
Do not lift the product by holding the panel, fittings or piping. Never lay the product down for transportation. This may lead to damage to the product. A polyurethane tube is attached as a drain tube for this product. Use this tube to discharge drainage to a drain tank etc. Do not use the drain tube in an upward direction. Do not bend or crush the drain tube.
Do not install by directly grasping the cylinder tube, as this could cause a tube to deform and malfunction. 2. Do not install it by directly grasping the piston rod with a pair of electricians pliers.
Do not operate with the magnetic coupling out of position. If the magnetic coupling is out of position, push the external slider by hand (or the piston slider with air pressure) back to the proper position at the stroke end. 3. Do not apply a lateral load to the external slider.
In a locked state, do not apply impacts, strong vibrations or rotational forces. Do not apply a impacts, strong vibrations or rotational forces from external sources, because this could damage or shorten the life of the lock unit. 4. The locking of the fine lock cylinder is directional.
Piping Caution Caution Handling 1.Do not inadvertently move the guide adjusting unit. The guide is installed at the proper tightening torque. Do not loosen the mounting bolts of the guide. 2.Do not operate the magnetic rodless cylinder if the magnet couplings on the actuator are displaced.
The set screws in the figure below are for securing the guide shaft, so do not loosen them except for the purposes of replacing the seals. This can cause a malfunction. Caution 1. Do not use the cylinder in an environment where the cylinder is expose to moisture, adhesive foreign matter, dust or liquid such as water or cutting fluid.
Do not apply a force of 20 N or more to the lead wire.
A B High precision type Basic type Port location Nil E Side ported Front ported Size 1 2 3 7 A With adjustment bolt Dimensions Clean series products do not have a hollow axis.
Do not install it by directly grasping the piston rod with a pair of electricians pliers.
When installing the cylinder into equipment or performing adjustments, etc., be sure to apply air pressure of 0.25 MPa or more to the unlocking port, and do not perform work using the unlocking cam. 3.
Series: 3 (VQ30), Stations: 20 Stations, Option: None, Thread: 00T (NPTF3/8)
Series: 3 (VQ30), Stations: 4 Stations, Option: D (DIN Rail Mounting)
Series: 3 (VQ30), Stations: 8 Stations, Option: None, Thread: 00T (NPTF3/8)
Series: VQ30, Stations: 20 Stations, Option: None, Thread: NPTF3/8
Series: VQ30, Stations: 4 Stations, Option: DIN Rail Mounting, Thread: -
Series: VQ30, Stations: 8 Stations, Option: None, Thread: NPTF3/8
Series: VQ30, Stations: 10 Stations, Option: None, Thread: NPTF3/8
Series: VQ30, Stations: 11 Stations, Option: None, Thread: NPTF3/8
Series: VQ30, Stations: 12 Stations, Option: None, Thread: NPTF3/8