1% F.S. or lessMaximum load impedance: 300 (Power supply voltage 12 V)600 (Power supply voltage 24 V)Minimum load impedance: 50 Non-voltage input (Reed or Solid state), Low level: 0.4 V or less, 5 ms or longer input3 1/2-digit, 7-segment, 2-color LCD (Red/Green)?2% F.S. ?1 digit (Ambient temperature of 77 ?5F)Lights up when output is turned ON.

1% F.S. or lessMaximum load impedance: 300 (Power supply voltage 12 V)600 (Power supply voltage 24 V)Minimum load impedance: 50 Non-voltage input (Reed or Solid state), Low level: 0.4 V or less, 5 ms or longer input3 1/2-digit, 7-segment, 2-color LCD (Red/Green)?2% F.S. ?1 digit (Ambient temperature of 77 ?5F)Lights up when output is turned ON.

1% F.S. or lessMaximum load impedance: 300 (Power supply voltage 12 V)600 (Power supply voltage 24 V)Minimum load impedance: 50 Non-voltage input (Reed or Solid state), Low level: 0.4 V or less, 5 ms or longer input3 1/2-digit, 7-segment, 2-color LCD (Red/Green)?2% F.S. ?1 digit (Ambient temperature of 77 ?5F)Lights up when output is turned ON.

1% F.S. or lessMaximum load impedance: 300 (Power supply voltage 12 V)600 (Power supply voltage 24 V)Minimum load impedance: 50 Non-voltage input (Reed or Solid state), Low level: 0.4 V or less, 5 ms or longer input3 1/2-digit, 7-segment, 2-color LCD (Red/Green)?2% F.S. ?1 digit (Ambient temperature of 77 ?5F)Lights up when output is turned ON.

PF2D5.eng

Danger: Analogue output: 4 to 20 mA Max. load impedance: 300 (12 VDC) 600 (24 VDC) Operator 1: Refer to the PF2D3 operation manual for details of the flow monitor. 3: Load indicates analogue input equipment such as an ammeter.

Return Filter

(Note1) (Petroleum,Water-glycol, Emulsion,Phosphoric ester) Applicable model FH100-06 FH100-08 FH100-10 FH100-12 FH100-16 FH100-20 FH100-24 INOUT Port size (Rc) 3/4B 1B 1 1/4B 1 1/2B 2B 2 1/2B 3B Drain port size M162 Rated flow Paper 50 80 120 160 260 450 600 rate Micromesh 60 100 150 200 300 550 700 (L/min) Operating pressure 1.0MPa Operating temperature 80oC Nominal filtration 1.

Heat Resistant Solid State Auto Switch

Do not use a cable longer than 100 m. Do not cut the lead wire between the sensor and amplifier. It may malfunction after connecting it again. Environment Pay attention to use the product in an atmosphere with accumulation of iron waste or close contact with magnetic substances.

Coolant valve

SGC200/300/400: Special request X1(SF4-X240) SGC500/600/700: Installed pilot valve VO307 Caution 7 SGC200-OMM0002-F SGC / SGH Series Coolant Valve / Precautions 5 Be sure to read this before handling.

V100 Series

Plug Connector Lead Wire Length Standard length is 300 mm, but the following length is also available. How to Order Connector Assembly To detach a connector, remove the pawl from the groove by pushing the lever downward with your thumb, and pull the connector straight out. 2.

Speed Controller with Pilot Check Valve with One-touch Fitting Series ASP 1

06 07,08,09 2 4 200 100 1 2 100 0 0 0 5 10 0 5 10 Number of needle rotations Number of needle rotations ASP530F ASP630F 1500 1000 14 Inlet pressure : 0.5 MPa Inlet pressure : 0.5 MPa Inlet pressure : 0.5 MPa Inlet pressure : 0.5 MPa Inlet pressure : 0.5 MPa Flow rate (l/min (ANR)) Effective area (mm2) Effective area (mm2) 20 Flow rate (l/min (ANR)) 10 11,12,13 12 10,11 08,09 1000 10 15 8

Speed Controller: Standard Type Series AS Large Flow In-line Type 1

Free flow Controlled flow Applicable cylinder bore size (mm) Effective area (mm2) Effective area (mm2) Flow rate (/min (ANR)) Flow rate (/min (ANR)) Model Port size Weight (g) AS420-02 2,500 1/4 38 3,600 55 0.34 AS420-03 5,000 3/8 77 4,800 74 0.33 63, 80, 100, 125 AS420-04 6,600 1/2 100 6,700 102 0.32 AS500-06 10,100 3/4 154 8,100 123 140, 160, 180, 200 0.36 AS600-10 15,100 1 230 16,900 258

Stainless Steel Heat

Use an air compressor of 100 l/min or greater air delivery. Since the auto drain is designed in such a way that the valve remains open unless the air pressure rises to 0.15MPa or higher, air will blow out from the drain discharge port when the air compressor starts up until the pressure increases.

MIW/MIS

20 80 Lateral load F 10 60 40 80 70 60 50 40 30 30 20 Point of application L mm 80 60 40 120 100 Point of application L mm 4 Escapements Series MIW/MIS 12, 20 How to Order Finger options Nil: Basic type (Standard type) 1: Tapped on upper and lower faces 2: Tapped on all faces (5 surfaces including end surface) Stroke 12 20 12 20 12mm 20mm MIW only accommodates a stroke of the same length

MXU

Maximum Load Weight (g) Weight (g) Cylinder stroke (mm) 5 Maximum load weight Model Model 10 15 20 25 30 MXU6 MXU10 MXU16 MXU6 MXU10 MXU16 100 66 72 81 88 97 103 200 115 124 138 147 166 174 400 216 215 251 250 285 300 8-3-3 4 Series MXU Allowable Moment Precautions Allowable moment (Nm) Correction value of moment center position distance (mm) Model Stroke Be sure to read before handling.

VT325

.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com Surge voltage suppressor Nil V Standard For vacuum Electrical entry Rated voltage VT Nil None 1 2 3 Option 100 VAC, 50/60 Hz G Grommet, Lead wire length 300 mm C Conduit D DIN terminal With surge voltage suppressor VP 200 VAC, 50/60 Hz Port size 110

10%, Ripple (p-p) 10% or less (with power supply polarity protection)40 mA or lessNPN or PNP open collector 1 output, NPN or PNP open collector 2 outputs (selectable)80 mA28 V (at NPN output)1 V or less (with load current of 80 mA)2.5 ms or less (with anti-chattering function: 20, 100, 500, 1000, 2000 ms)Yes?0.2% F.S. ?

10%, Ripple (p-p) 10% or less (with power supply polarity protection)40 mA or lessNPN or PNP open collector 1 output, NPN or PNP open collector 2 outputs (selectable)80 mA28 V (at NPN output)1 V or less (with load current of 80 mA)2.5 ms or less (with anti-chattering function: 20, 100, 500, 1000, 2000 ms)Yes?0.2% F.S. ?

10%, Ripple (p-p) 10% or less (with power supply polarity protection)40 mA or lessNPN or PNP open collector 1 output, NPN or PNP open collector 2 outputs (selectable)80 mA28 V (at NPN output)1 V or less (with load current of 80 mA)2.5 ms or less (with anti-chattering function: 20, 100, 500, 1000, 2000 ms)Yes?0.2% F.S. ?

10%, Ripple (p-p) 10% or less (with power supply polarity protection)40 mA or lessNPN or PNP open collector 1 output, NPN or PNP open collector 2 outputs (selectable)80 mA28 V (at NPN output)1 V or less (with load current of 80 mA)2.5 ms or less (with anti-chattering function: 20, 100, 500, 1000, 2000 ms)Yes?0.2% F.S. ?

10%, Ripple (p-p) 10% or less (with power supply polarity protection)40 mA or lessNPN or PNP open collector 1 output, NPN or PNP open collector 2 outputs (selectable)80 mA28 V (at NPN output)1 V or less (with load current of 80 mA)2.5 ms or less (with anti-chattering function: 20, 100, 500, 1000, 2000 ms)Yes?0.2% F.S. ?