The PSH Condensation Checker monitors temperature and moisture in a compressed air or non-corrosive gas supply line. The sensor identifies whether damaging condensation is a risk to the connected equipment. The detected results are displayed as percent relative humidity and temperature values. Both values can be displayed simultaneously if desired. The sensor can also respond
Output Specification: L2 (IO-Link/Switch output 1 + Switch output 2), Units specification: M (SI units only), Piping Specification: 01 (R 1/8), Option 1: W (Lead Wire w/Connector, 2m Waterproof), Option 2: A (Bracket)
HUMIDITY SWITCH, HUMIDITY SENSOR, Q62, 142.00000 lb
JXCx-OMT0023 Servo motor Driver Driver Servo motor Servo amplifier Servo amplifier U U U U V V M V M V W W W W Do not connect AC power supply directly to the servo motor. Otherwise, a fault may occur. Install a surge absorbing diode on the DC relay designed for control output signal in the specified direction.
Output Specification: L2 (IO-Link/Switch output 1 + Switch output 2), Units specification: M (SI units only), Piping Specification: 01 (R 1/8)
Output Specification: L2 (IO-Link/Switch output 1 + Switch output 2), Units specification: w/Units Selection Function, Piping Specification: 01 (R 1/8), Option 1: W (Lead Wire w/Connector, 2m Waterproof)